Liebert UPS Systems PSI XR manual

AC P ow er For Business-Criti cal C on tinuity™ Li eber t ® PSI XR ™ Us er Man ual–1000/1500/ 1920/3000V A, 60Hz, 120V AC[...]

[...]

i T ABLE OF CONTENTS 1.0 I NTRODUCTI ON . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2.0 W HAT ’ S I NCLU DED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3.0 I NST ALLATION . . . . . . . . . . . . . . . . . [...]

ii 7.0 B ATTERY M AINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 7.1 Battery Charging, Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 7.2 Internal Battery Replacement Procedure . . . . . . . . . . . . . . . . . . . [...]

1 I MPORT ANT S AFETY I NSTRUCTIONS SA VE THESE INSTRUCTIONS This manual co ntains important instructio ns that should be followed du ring installation and ma inte- nance of the UPS. • Intended for installat ion in a temperature-contro lled, indoor area free of conductive contami- nants. • Maximum ambient temperature 104°F (40°C). Read this m[...]

2 ELECTROMAGNETIC COMP ATIBILITY —The Liebert PSI XR complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any in terference received, including in terference that may cause unde- sired operation. This equipment uses, genera[...]

3 G LOSSARY OF S YMBOLS Risk of ele ctrical shock Indicates caution followed by important instructions Indicates the unit contains a valve-regulated, lead-ac id battery Recycle DC voltage Equipment grounding conductor Bonded to ground AC voltage ON/Alarm Silence/Manual Self-Diagnostic Test OFF Status Change Button ![...]

Introd uction 4 1.0 I NTRODUCTION The Liebert PSI ™ XR is a 2U, line-in teractive UPS that may b e installed in a rack or used as a tower UPS. Status indicators on the front of the Liebert PSI XR display load level, battery level, buck/boost, site- wiring fault and battery st atus. Controls include a combination ON/ Alarm Silenc e/Manual Self-Dia[...]

Introd uction 5 Figure 3 1920V A—rear view Figure 4 3000V A—rear view DC 48V OUTPUT EPO INPUT VOLT AGE=1 10V VOLT AGE=120V VOLT AGE=127V 2 1 FUNCTION RJ-45 Data Line Connec tors USB Port RS232 (DB-9) Port Power Cord; 5-20P (not shown for cla rity) EPO External Battery Cabinet Conn ector V oltage Configuration DIP Switch 15A Output Circuit Break[...]

What’ s Included 6 2.0 W HAT ’ S I NCLUDED The Liebert PSI XR is shipped with the following items: • Multi-Language User Manual on CD • Liebert Mu ltiLink Shutdown So ftware and User Manual on CD • DB-9 Serial Cable • USB Cable • Tower Stand • Rack-Mou nt Handles • Battery-UPS Tab • Mounting Hardware • Fixed Moun ting Rails ?[...]

Installation 7 3.0 I NST ALLATION 3.1 Prep aration The Liebert PSI XR may be installe d in either a tower or rack conf iguration. Determine the method that suits the applica tion and proceed. Decide where to install the Liebert PSI X R. The UPS must be installed indoor s in a controlled envi- ronment. Place it in an area with unrestricted ai rflow [...]

Installation 8 3.2 T ower UPS Installation See Figure 7 when using the Liebert PSI XR in a tower configuration. Figure 7 T ower configuration—att ach T ower St and Step 1 Step 2[...]

Installation 9 3.3 Rack-Mount U PS Conversion and Inst allation See Fi gure 8 when installing the Liebert PSI XR in a rack. Ex ternal battery cabinets are inst alled in same manner. Figure 8 Convert the Liebert PSI XR f or rack inst allation NOTICE When rack-mounted, the UPS must be supported by a shelf, slide rails, brackets or fixed rails on each[...]

Installation 10 3.4 Orient Display for Inst allation The Liebert PSI XR features a rotating display that may be oriented fo r either tower or rack ins talla- tions. To set the display for your installation, pull out on the di splay and rotate it until it i s oriented cor- rectly, then press it i nto the UPS until it is seated. Figure 9 Adjusting th[...]

Installation 11 3.6 Connect Network Surge protection Connect a 10 base-T/100 network cable to the RJ-45 network surge protection IN jack on the rear of the UPS. Connect from the OUT jack w ith network cabling to network equipment (see Figure 11 ). Figure 1 1 Connect network surge prot ection 3.7 Connect Computer Interface Port Determine what type o[...]

Installation 12 3.8 EPO Switch The Liebert PSI XR is equipped with an Emergency Powe r Off (EPO) switch. The user must supply a means of interfacing with the EPO circuit to allo w disconnecting the UPS input feeder breaker to interrupt all sources of po wer to the UPS and connected equipment to comply with national and local wiring codes and regula[...]

Installation 13 Figure 15 Connect battery cabinet s to UPS See Table 8 for approx imate battery run times. DC 24V OUTPUT INPUT EPO VOLTAGE=1 10V VOLTAGE=120V VOLTAGE=127V 2 1 FUNCTION[...]

Controls and Indica tors 14 4.0 C ONTROLS AND I NDICATORS Buttons on the front panel displa y control the Lieb ert PSI XR. Eight L EDs indica te the UPS’s statu s. Refer to Figure 16 and Table 2 . Figure 16 Display and st atus indicators T able 2 Display and st atus indicators f unction, legend Item Name Status Indicators Description 1 LED 1 AVR [...]

Controls and Indica tors 15 4.1 Control Buttons 4.1.1 On/Alarm Silence/Manual Self-Diagnostic T est This button controls output power to co nnected load (s). It has three functions: •O n •A l a r m S i l e n c e • Manual Self-D iagnostic Test ON —Start the UPS by pressing this button for more than 3 seconds, then releasing the button (an al[...]

Controls and Indica tors 16 4.2.3 Battery Level Indicator The five LEDs illuminate with a steady glow to indicate battery capacity. Battery capacity is shown for five second s after the Status Change Button is pressed. The LEDs show the battery capacity as a range, ± 5% The LEDs’ battery level meanings and colors are: 4.2.4 UPS St atus Indicator[...]

Operational Modes 17 5.0 O PERATIONAL M ODES 5.1 Normal Mode When the UPS is in Normal Mode, the No rmal Mode Indicato r illumina tes green. 5.2 Buck/Boost Mode The Automatic Voltage Regulator (AVR ) circuitry compensates for fluctu ations in utility power, su ch as voltage surges and sags. When the Liebert PSI XR detects an abnormality, it raises [...]

Communication 18 6.0 C OMMUNICATION 6.1 DB-9 Connector The UPS has a DB-9 (9 pin female) connector on the rear to allow UPS statu s communications with a computer running Liebert MultiLi nk shutdown soft ware. The connection prov ides serial communica- tion, On Battery and Low Battery signals. Liebert MultiL ink software and a 6 ft. (1.8m) DB-9 ser[...]

Communication 19 6.3 RJ-45 Dat a Line Protection Connectors Data line (in and out) connectors on the rear o f the UPS provide transient voltage surge suppression (TVSS) for network devices. 6.4 UPS Communications The Liebert PSI XR is equipped with a Liebert IntelliSlot ® port to provide advanced communication and monitoring options. Liebert Multi[...]

Battery Maintenance 20 7.0 B ATTERY M AINTENANCE 7.1 Battery Charging, S torage The batteries are valve-regulated, nonspillabl e, lead acid and must be kept charged to retain their design life . The Liebert PSI XR con tinuously charg es the batteries wh en connected to th e utility sup- ply, even while the UPS is switched Off. If the Liebert PSI XR[...]

Specifications 21 8.0 S PECIFICATIONS T able 6 Liebert PSI XR specifications Model Number PS1000RT3-120XR PS1000RT3120XRW PS1500RT3-120XR PS1500RT3120XRW PS2200RT3-120XR PS2200RT3120XRW PS3000RT3-120XR PS3000RT3120XRW Power Rating, VA/W 1000VA/900W 1500VA/13 50W 1920VA/1920W * 3000VA/270 0W Dimensions, W x D x H, in (mm) Unit 17.3 x 19.3 x 3.5 (440[...]

Specifications 22 T able 7 Battery cabinet specifica tions Model Number PSRT3-24VBXR PSRT3-48VBXR Used w/UPS Model PS1000RT3-120XR PS1000RT3120XRW PS1500RT3-120XR PS1500RT3120XRW PS2200RT3-120XR PS2200RT3120XRW PS3000RT3-120XR PS3000RT3120XRW Dimensions, W x D x H, in (mm) Unit 17.3 x 19.3 x 3.5 (440 x 490.5 x 88) Shipping 22 x 26.6 x 9 (560 x 675 [...]

Specifications 23 T able 8 Liebert PSI XR battery run times Number of Batteries Load % 10 00VA 1500VA 1920VA 3000VA Internal Battery 10 82 81 76 75 25 43 32 32 32 50 15 13 14 13 7 5 9888 1 0 0 6555 Internal Battery + 1 External Battery Cabinets 10 272 222 161 142 25 139 109 80 70 50 73 55 45 31 75 51 31 25 17 100 31 18 15 12 Internal Battery + 2 Ex[...]

Trou bleshooting 24 9.0 T ROUBLESHOOTING The informatio n below indicates va rious symptoms a user may encoun ter if the Liebert PSI XR expe- riences a problem. See Table 9 for suggested solutions. 1. An alarm sounds, alerting that the UPS requires attention. The al arm can be silenced except for low battery, overload warning an d fault. 2. One or [...]

Trou bleshooting 25 Notes[...]

Trou bleshooting 26[...]

[...]

EmersonNetworkPower.com Ensuring The Hi gh Av ailabi lit y Of Mission-Critic al Data And Ap plic ations. Emerson Net work P ower , the global leader in enabling business-critical continuity , ensures network re siliency and adaptabilit y through a family of technologies—inc luding Liebert power and cooling technologies—that prot ect and suppor [...]