Sharp AF-R120CX инструкция обслуживания

ROOM AIR CONDITIONER INSTALLATION AND OPERATION MANUAL PAGE CONTENTS This INSTALLATION AND OPERATION MANUAL explains the proper use of your new Sharp Air Conditioner. Read these instructions carefully before installing or operating your air conditioner. The INSTALLATION AND OP- ERATION MANUAL should be kept in a safe place for handy reference. FOR [...]

2 To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the right side of the unit. DATE OF PURCHASE Dealer Name Address City State Zip Telephone FOR YOUR PROTECTION TO PHONE: Dial 1-800-BE-SHARP (237-4277) for: SERVICE (for your nearest Sharp Authorized Serv[...]

3 SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new [...]

4 INST ALLA TION INSTRUCTIONS Before beginning installation, read these instructions carefully. Use the enclosed MOUNTING KIT for proper installation. The mounting kit is designed for wooden sill double or single hung sash-type windows. Minimum opening (Without mounting kit) Mounting kit fully closed Mounting kit fully opened 22 / "(560mm) 27 [...]

5 7 6 5 4 3 2 1 ITEMS P ACKED WITH THIS UNIT No. Accessories Q'ty Right closure assembly Left closure assembly Window sash foam seal 1 1 1 SUGGESTED T OOLS 1. Screw driver (medium size Phillips) 2. Tape measure or ruler 3. Knife or scissors INST ALLA TION INSTRUCTIONS 13 Screws(L=1", 25.4mm) Bottom gasket 8 1 6 Screws(L= / ", 10mm) 6[...]

6 INST ALLA TION INSTRUCTIONS Open the window sash and place the cabinet on the sill. Close the window sash securely behind the top angle. If there is space between the bottom channel and the sill, fill the gap with a thin board or other hard filler. 5 Front panel Exhaust Lever Closure assembly Insert the right closure assembly and the left closure[...]

7 Indoor side INST ALLA TION INSTRUCTIONS Closure assembly (Left) 6 Jamb (Left) Top angle Sill 1/2 inch (13mm) Closure assembly (Left) Stool Insert the closure assemblies on both sides into the rails of the jamb. Secure the cabinet to the window stool with 3 screws (L=1", 25.4 mm), working from the inside of the cabinet. Secure the top angle a[...]

8 PRECAUTIONS 3-Pronged receptacle 3-Pronged plug Grounding prong Grounded receptacle box Grounding adapter Grounded receptacle box Screw Tab for grounding screw Grounding wire IMPORTANT: Points to keep in mind when using your air conditioner. • Install the air conditioner by following the installation instructions given in the previous section o[...]

9 PRECAUTIONS • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for the compressor to restart cooling. There is an electronic device in the unit that keeps the compressor off three minutes for protection. • If a power failure occurs during use, allow 3 mi[...]

10 HIGH COOL MED COOL LOW COOL FAN ONLY SELECTOR ENERGY SAVER POWER ON/OFF TEMP F hr TIMER ON/OFF 1 2 3 4 5 6 7 8 9 10 11 8 12 1 2 3 4 5 6 7 9 10 11 2 1 SELECTOR indicator Receiver window for remote control signal Display SELECTOR pad TIMER ON/OFF pad TIMER indicator P ARTS NAMES UNIT CONTROL P ANEL TEMPERATURE setting pad ---- Lower temp. ---- Rai[...]

11 F hr POWER ON/OFF POWER ON/OFF F hr TEMP OPERA TION INSTRUCTIONS --- Lower temp. --- Raise temp. COOLING OPERA TION Display / Indicator Touch POWER ON/OFF pad. To turn off the unit, touch POWER ON/OFF pad again . • POWER indicator and SELECTOR indicator (HIGH COOL) will light. • POWER indicator and SELECTOR indicator will go off. T O CHANGE [...]

12 LOW COOL MED COOL HIGH COOL SELECTOR SELECTOR T O CHANGE F AN SPEED Procedure • SELECTOR indicator will light in order as you touch. NOTES ON F AN SPEED Display / Indicator Pad Fan operates at medium speed; cooling power at medium. F AN ONL Y OPERA TION Cooling for sleeping comfort with low fan speed. Fan and cooling at maximum performance. Un[...]

13 CLOSED OPEN EXHAUST Lever ENERGY SAVER ENERGY SAVER HOW TO OPERA TE ENERGY SA VER T O CHANGE AIR FLOW DIRECTION During normal operation, the thermostat automatically controls cooling and the fan runs continuously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor [...]

14 0.5h 1.0h 1.5h 10h Preset(0.5h) Previous setting 11h 12h CL(cancel) F hr TIMER ON/OFF HOW TO OPERA TE ON TIMER OPERA TION • After setting the ON TIMER, change the temperature and fan speed settings as shown on pages 11 and 12. When the temperature is set in the timer mode, the temperature will show in the display for 5 seconds and then return [...]

15 0.5h 1.0h 1.5h 10h Preset(0.5h) Previous setting 11h 12h CL(cancel) F hr TIMER ON/OFF HOW TO OPERA TE OFF TIMER OPERA TION • This unit has a built-in timer that can be programmed to shut the unit off up to 12 hours in advance. • You can set the timer to stop in increments of 30 minutes (0.5 hours) up to 9.5 hours in advance of the stop time,[...]

16 Insert the batteries in the compartment, making sure the and polarities are properly aligned. HOW TO OPERA TE USING THE REMOTE CONTROL INST ALLING BA TTERIES Use two size-AAA (R03) batteries. Battery compart- ment cover NOTES: • The battery life is approximately one year with normal use. • When you replace the batteries, always use two new o[...]

17 HIGH COOL MED COOL LOW COOL FAN ONLY • The time setting will change as you push the button. The display will change as follows; • The last OFF time setting is memorized by the unit and will appear on the display when the button is pushed. • The timer will be set, 5 seconds after the SET TIMER / OFF button is pushed for the last time. • I[...]

18 ENERGY EFFICIENCY TIPS CLEANING AND MAINTENANCE CLEANING THE FIL TER If the filter is clogged with dust, the amount of air flow will be reduced, resulting in poor cooling performance. The filter should be cleaned every10 days. At the beginning of every cooling season or after a long period of inactivity, clean the filter before starting the unit[...]

19 BEFORE CALLING FOR SER VlCE IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECK THE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose? • Is the fuse blown or the circuit breaker tripped? • Did you restart the unit within 3 minutes after a power fail[...]

20 SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 SHARP CORPORATION Osaka, Japan Printed in Thailand TINSEA297JBRZ 01LO TL 1[...]