Royal Sovereign 900NPH-1200N инструкция обслуживания

OWNER'S MANUAL PROFESSIONAL PHOTO LAMINATOR ROYAL SOVEREIGN INTL.INC. PLEASE READ AND SAVE INSTRUCTIONS NPH-1200 / 900 NPH-1200N/900N 1[...]

TOPICS PAGE INTRODUCTION ----------------------------------------- - SAFETY PRECAUTIONS ----------------------------------- - CHARACTERISTICS OF NPH-1200N/900N --------------------- - SPECIFICATIONS ---------------------------------------- - SETUP ------------------------------------------------ MAJOR PARTS IDENTIFICATION --------------------------[...]

Thank you for purchasing a Royal Sovereign Laminating Machine. To insure high quality lamination, please read this instruction manual thoroughly. For additional product support or factory-direct ordering information, call Royal Sovereign Customer Service at (201)568-0830 or toll free call, (800)397-1025. 1. To prevent the possibility of electrical [...]

This machine has been designed using the latest laminating technology. 1. This machine is controlled by a state-of-the-art Microprocessor. a) Protect the rollers--When the power is off or a power failure occurs, rollers continue to turn until the unit properly cools down. b) Automatic overheating protection--If a temperature sensor should fail, the[...]

Place laminator on a sturdy, flat work surface. Allow ample clearence behind laminator for laminated document or photograph to exit completely without bending. Connect laminator to an electrical outlet that matches laminator's rated voltage and power requirements. If an extension cord is required, use a cord rated higher than the laminator&apo[...]

1. Top Cabinet 2. Roller Cover 3. Roller Cover Screws 4. Control Panel 5. LCD Window 6. Input 7. Output 8. Power Cord MAJOR PARTS IDENTIFICATION 6[...]

Appropriate speed and temperature may be set, using the LCD controller. The LCD panel was designed for convenience, by incorporating the ability to program your settings into "Memory". 1. CONTROL PANEL SETTINGS LCD DISPLAY BUTTONS CONTROL PANEL INSTRUCTIONS T-Check COLD MEMORY HOT/COLD 7[...]

2. LCD WINDOW 1. * 6 film thickness options 75 Mic=3 mil, 100 Mic=4 mil, 125 Mic=5 mil 2. SPEED * 7 speed options Setting 1 is slowest / Setting 7 is fastest 3. TEMPERATURE Display the present temperature. 4. Is displayed when the present temperature is reached. 5. Indicates to wait till blinking stops. Current temperature is higher or lower than t[...]

3. BUTTON FUNCTIONS : Check current temperature : Hot/Cold function : Working condition and Cold function cancel : Increase temperature : Decrease temperature : Increase speed : Decrease speed : Restore the memorized working setting : Restore the memorized working setting : Reverse function : Power On/Off T-Check MEMORY HOT/COLD T-Check COLD MEMORY[...]

4. HOW TO SET THE BUTTONS (Buzzer rings each time you press the button.) 1.Temperature available range from 20℃ to 160℃. 2.Each time you press or to set temperature, it will change 1℃(1℉) at a time. If you press the button for more than 2 seconds, temperature will change automatically. 1.You can use 7 different lamination speed. 2.You can c[...]

1) Memorizing working condition 1. The laminator can memorize up to 6 settings. 2. Use up and down arrows to set or 3. When you complete the optimum laminating conditions (Speed & Temperature), button. This setting is memorized and confirmed when the light blinks. 4. To enter other settings into memory, repeat steps 2 and 3. 2) Using the memori[...]

1. HOT LAMINATING 1. Press the power button. 2. Please refer Information Panel on the front of product. 3. Select a memory setting by pressing the and button. 4. It is ready when the LCD window shows and the buzzer rings three times. 5. After Insert document or photograph to be laminated into a laminating pouch, insert pouch squarely into opening s[...]

2. COLD LAMINATING 1. Press the power button to turn on. 2. Press 3. It is ready when LCD window shows and the buzzor rings three times. 4. Insert document into a Royal Sovereign cold laminating pouch as follows. 1) Prepare cold pouch film. 2) Remove protective paper inside cold pouch. (Be careful not to allow the pouch to close and seal itself clo[...]

3. COLOR FOIL LAMINATING **Your laminator has ability to add color by applying color foil to documents copied or printed by lasor printer or toner copier.** **PAPER CARRIER is required** 1. Press the power button to turn the laminator on. 2. Find FOIL FUNCTION using the up arrow. 3. It is ready when LCD window shows and the buzzer rings 3 times. 4.[...]

4. MOUNT BOARD LAMINATING **You can laminate photographs or pictures on a hard mounting board up to 2mm thickness** 1. Press the power button to turn on. 2. Temperature 130 and speed 1 is set for Foil function. 3. It is ready when LCD window shows and the buzzor ri ngs 3 times. 4. Set material on Mount board then slide them into the opening slot 5.[...]

1. Cleaning rollers with a clean and thick paper 1) If film adhesive apears on the laminated pouch surface , Inse rt a sheet of clean, thick paper (about 0.5mm(1/50") thickness) into the machine 2~3 t imes on 100℃(212℉) setting. The paper will attract the excess adhesive from the roller. 2. Cleaning rollers with cleaning solvent. 1) When r[...]

1. Please be cautious that neckties, necklaces, long hair and clothing are kept well away while operating the laminator. 2. Prevent children from accessing the machine. 3. Make certain that the machine is connected to an adequate power source. 4. Do not use for any purpose other than lamination. 1. Width of upper and lower side of film should be sa[...]

This product is warranted for 1 year from date of purchase to b e free from electrical or mechanical defects in material and workmanship. Should product fail to operate during warranty period, return it, freight prepaid, to Royal Sovereign Corporation, 100 West Sheffield Avenue, Englewood, NJ 07631, for service. There will be no charge for parts an[...]