RedMax BCZ3050SW инструкция обслуживания

US-1 BCZ3050S/T/SW U S 848-JCS-93A0 (908) BCZ3050S BCZ3050T BCZ3050SW OWNER 'S/ OPERA T OR'S MANUAL BR USHCUTTERS APPLICABLE SERIAL NUMBERS : DRIVE UNIT 90200101 and up ENGINE UNIT 90200101 and up W ARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other repro[...]

US-2 BCZ3050S/T/SW SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. ■ WARNINGS IN THE MANUAL Th[...]

US-3 BCZ3050S/T/SW U S 1. Parts location BCZ3050S BCZ3050T BCZ3050SW 1 2 3 4 5 6 6 7 8 9 17 7 7 8 9 4 2 5 3 18 10 11 12 13 14 15 16 1. Loop handle 2. Suspention point 3. Stop switch 4. Throttle cable 5. Throttle trigger 6. Shaft tube 7. Cutting attachment guard 8. Cutting line head 9. Gear case 10. Spark arrester 11. Starter knob 12. Fuel tank 13. [...]

US-4 BCZ3050S/T/SW 3. W arning labels on the machine For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to take a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close the choke Position: AIR CLEANER COVER (c[...]

US-5 BCZ3050S/T/SW U S •A brushcutter or trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operater or others. It is extremely important that you read and understand the contents of this Owner's manual. • Under no circumstances may the design of the machine be modified without the perm[...]

US-6 BCZ3050S/T/SW contain dangerous carbon monoxide. 10. Never to touch the spark plug or plug cord while the engine is in operation Doing so may result in being subjected to an electrical shock. 11.Never to touch the muffler, spark plug, other metallic parts of the engine or engine cover while the engine is in operation or immediately after shutt[...]

US-7 BCZ3050S/T/SW U S 5. For safe operation equipment, CLEAN UP! ■ Transport 1. Drain the fuel from the fuel tank before transporting or storing the product. 2. When hand-carrying the product, cover over the cutting part, lift up the product and carry it paying attention to the blade. 3. Secure the unit carefully to prevent movement when it is t[...]

US-8 BCZ3050S/T/SW 5. For safe operation muffler, and the ignition wiring. 4. When replacing the any other part, or any lubricant, always be sure to use only RedMax products or products which have been certified by RedMax for use with the RedMax product. 5. In the event that any part must be replaced or any maintenance or repair work not described [...]

US-9 BCZ3050S/T/SW U S 6. Set up Tighten the screws gradually by turns. ■ INSTALLING HANDLE • Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE1) (1) About 19 inches (48cm) (2) About 14.5 inches (37cm) ■ HIP PAD • Fix the tube by the band. (SE2) (1) Band ■ INSTALLING CUTTING ATTACHMENT GUARD •[...]

US-10 BCZ3050S/T/SW 7. Fuel ■ FUEL • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 feet (3 m) away from the fueling point before starting the engine. ■ GASOLINE REQUIREMEN[...]

US-11 BCZ3050S/T/SW U S 7. Fuel test standard has been discontinued by API in 1995 and it no longer exists. • Gasoline/Oil mixture Storage Recommendations Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen). Moisture and air cause the deve[...]

US-12 BCZ3050S/T/SW 8. Operation ■ STARTING ENGINE The cutting head will start rotating upon the engine starts. 1. Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine. 2. Push the primer pump several times until overflown fuel flows out in[...]

US-13 BCZ3050S/T/SW U S ■ CUTTING WORK (LINE HEAD USAGE) 1. Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury. 2. Keep the cutting attachment guard in place at all times when the unit is operated. TRIMMING GRASS A[...]

US-14 BCZ3050S/T/SW every every every 25 50 100 system/compornent procedure before hours hours hours note use after after after fuel leaks, fuel spillage wipe out ✔ fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary see ■ ADJUSTING replace carburetor idle adjusting screw ✔ IDLING SPEED (p.12) if necessary clean and [...]

US-15 BCZ3050S/T/SW U S 9. Maintenance .038 in 1.00mm MA4 (1) MA2 MA1-d (1) MA3 • Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury. ■ AIR FILTER • The air filter, if clogged, will reduce the engine performance. Check [...]

US-16 BCZ3050S/T/SW 9. Maintenance MA8 (1) (2) MA7 • Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty the fuel tank and run the engine until it uses all the fuel left in the fuel line and the carburetor. Store the unit indoor taking necessary measures for rust prevention. 10. Storage 1 1. Disposal • Wh[...]

US-17 BCZ3050S/T/SW U S •W hen sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper tools and equipment to prevent injury. ■ CHOOSE THE BLADE Choose a suitable recommended cutting attachment according to the object to be cut. (OPT3) • When replacing blade always be sure to use products which[...]

US-18 BCZ3050S/T/SW 12. Optional blade usage (for BCZ3050S/SW only) ■ STARTING THE ENGINE Please refer 5.For safe operation (P.6), 8.Operation (P.12). • The product is equipped with a centrifugal clutch mechanism, so the cutting attachment could rotate as soon as the engine is started. When starting the engine, place the product onto the ground[...]

US-19 BCZ3050S/T/SW U S d. Keep the blade sharp. A dull blade increase the chance of blade thrust. e. Avoid feeding the blade too rapidly. The blade can bounce away from material being cut if the blade is fed faster than its cutting capability. f. Cut only from your right to your left. g. Keep your path of advance clear of material that has been cu[...]

US-20 BCZ3050S/T/SW Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adjustment screw ➞ out of normal range ➞ adjust to normal range sparking (no spark) ➞ spark plug is fouled/wet ➞ clean/dry ➞ plug gap is incor[...]

US-21 BCZ3050S/T/SW U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and later small off-road engine. In U.S. and Canada, new equipment that use small off-road engines must be designed, built, and [...]

RedMax STANDARD LIMITED WARRANTY STATEMENT ALL Products Sold on or after 1/01/2009 All RedMax Brand Products RedMax Limited Warranty, provides to the ORIGINAL retail purchaser that this RedMax product is free from DEFECTS in MATERIAL and WORKMANSHIP under normal use and maintenance from the date of retail purchase. RedMax agrees to repair or replac[...]

Engine Failures caused by operating engines on gasoline with octane rating lower than 89 are not covered by the RedMax Two-Stroke engine warranty. (Emission related parts only are covered for two years, regardless of two-stroke oil used, per the statement listed in the EPA or California Emission Defect Warranty Explanation.) THIS WARRANTY DOES NOT [...]