NewAir AC12000E инструкция обслуживания

PLEASE  READ  AND  SAVE  THESE  INSTRUCTIONS   NewAir  AC ‐ 12000E,  AC ‐ 12000H  Portable  Air  Conditioner  Owner’s  Manual  k0045[...]

BEFORE USE GENERAL SAFETY INSTRUCTIONS: • AL W A YS OPERA TE THE UNIT IN AN UPRIGHT POSITION AND PLACE IT ON A FLA T , LEVEL SURF ACE A T LEAST 14 INCHES A W A Y FROM ANY OTHER OBJECTS (Fig 1 & 4). • DO NOT PLACE OBJECTS ON THE UNIT , AND DO NOT COVER OR OBSTRUCT THE INLET OR OUTLET GRILLS (FIG. 2). • CLOSEL Y SUPER VISE ANY CHILDREN AND [...]

PARTS LIST Front: Back: 1. Control panel 2. Louvers 3. Carrying handle 4. Casters 5. Air filter 6. Air inlet 7. Cord storage 8. Exhaust air outlet 9. Rubber plug / drainage point Accessories: 10. Exhaust hose 11. Hose adaptor (goes over the hose and into the window kit) 12. Extendable window kit 13. Activated carbon filter 14. Hose for continuous d[...]

INSTALLATION INSTRUCTIONS Installing the Exhaust Hose and Window Kit: FIG.5 Wall or Window Window Kit Adapter 1. Open the window and insert the window kit into the open gap. 2. Close the window until the window kit is held securely. This technique may also be used for sash windows. 3. Fit the exhaust hose into the exhaust air outlet located on the [...]

Positioning the Exhaust Hose: • Insert the exhaust hose into the back of the unit and tighten it into place. • Avoid kinks and bends in the exhaust hose. This can cause moist air to accumulate, resulting in overheating and • The exhaust hose may be extended from 12 inches (300 mm) to 59 inches (1500 mm), but for maximum cooling efficiency, us[...]

Installing the Activated Carbon Filter: 1. Remove the filter frame from the unit. 2. Separate the filter from the filter frame. 3. Remove the activated carbon filter from its plastic bag. 4. Insert the activated carbon filter into the filter frame. 5. 6. Insert the filter set into the unit. 5 FIG.11 R e a t t a c h t h e f i l t e r o n t o t h e f[...]

OPERATING INSTRUCTIONS Control Panel 1. Fan speed (ventilation) button 2. Timer button 3. Display window 4. Remote control receiver 5. Heater indicator (for AC-12000H only ) 6. Mode selection button 7. Automatic mode indicator 8. Cooling mode indicator 9. Fan mode indicator 10. Temperature increase button 11. Temperature decrease button 12. Power i[...]

Setting the Mode/Function: 1. Press the MODE button to select the desired mode (cooling, fan or heating). Heating mode is only available on the AC-12000H. 2. The selected mode’s indicator light will turn on. Setting the Temperature: 1. Press the “Up” or “Down” butt on to change the set temperature. 2. The display window will indicate the [...]

Heating Mode: When the air conditioner is in heating mode, ambient warm ai r is recycled and used to heat your immediate area. The exhaust pipe will stil l need to be fitted onto the unit in order for the cold air to be removed . When in heating mode, the machine can be set on HIGH or LOW speed. Ionizer: Press IONIZER button to activate the ionizer[...]

DRAINING THE UNIT During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir. If the water reservoir is full, both the compressor and motor will stop and t he unit will beep (press any button to stop the beeping sound). The full water tank indicator ligh t will also start flashing. To resume[...]

For Continuous Drainage: • Remove the rubber plug from the drainage port and retain it for future use. • Connect the drain tube to the drainage port as shown (fig. 17). • Connect the other end of the hose to a drain. FIG.16 • The drain tube may be extended by adding an extension tube with a suitable connector. FIG.17 Please Note: 1. The dra[...]

For Heating Mode: While using the heating function, please note the following: 1. In order to properly exhaust cool air, make sure the exhaust hose and window kit are properly installed (refer to page 6 for instructions). 2. Set up the air conditioner for continuous drai nage using the drain tube (refer to page 13 for instructions). 3. The working [...]

MAINTENANCE INSTRUCTIONS Always unplug the air conditioner from the power supply before cleaning. To maximize the efficiency of the air conditioner, regularly clean the unit. Cleaning the Housing: • Use a soft, damp cloth to wipe the body clean. • Never use harsh chemicals, gasoline, deter gents, chemically treat ed cloths, or other cleansing s[...]

TROUBLESHOOTING The air conditioner does not work. y Is the air conditioner plugged in? y Is the power outlet functioning correctly? y Is the full water tank indicator light flashing? y Is the ambient room te mperature lower than the set temperature? The unit does not produce adequate cooling. y Is the unit placed in direct sunlight? If so, close a[...]

TECHNICAL SPECIFICATIONS Model Number: AC-12000E AC-12000H Power Consumption for Cooling* 1166W / 11A 1166W/11A Power Consumption for Heating * N/A 1054W/10.1A Air Volume (max. speed) 440m 3 /h 440m 3 /h Dehumidification Capacity 1.2L/hour 1.2L/hour Voltage / Frequency 115V, 60Hz Compressor Type Rotary Refrigerant Type R-410A Number of Fan Speeds 2[...]