NewAir AC14000H инструкция обслуживания

PLEASE  READ  AND  SAVE  THESE  INSTRUCTIONS   NewAir  AC ‐ 14000E,  AC ‐ 14000H  Portable  Air  Conditioner  Owner’s  Manual  K0080-1-2[...]

BEFORE USE GENERAL S AFETY INSTRUCTIONS: • AL W A YS OPERA TE THE UNIT IN AN UPRIGHT POSITION AND PLACE IT ON A FLA T , LEVEL SURF ACE A T LEAST 14” (36 CM) FROM ANY OBJECTS OR COMBUSTIBLE SURF ACES (FIG 1 & 4). • DO NOT PLA CE OBJECTS ON THE UNIT , AND DO NOT COVER OR OBSTRUCT THE INLET OR OUTLET GRILLS (FIG 2). • CLOSEL Y SUPERVISE AN[...]

PARTS LIST Front: Back: 1. Control panel 2. Louvers 3. Carrying handle 4. Casters 5. Air filters 6. Air inlets 7. Exhaust air outlet 8. Cord wrap 9. Rubber plug / drainage hole Accessories: 10. Hose adapter (goes over the exhaust hose and into the back of the unit) 11. Exhaust hose 12. Round connector (to be used in between the hose and window kit [...]

INSTALLATION INSTRUCTIONS Installing the Exhaust Hose and Window Kit: The unit is a portable air conditi oner that may be moved from room to room. Hot air must be exhausted out of the room fo r the appliance to work. This can be done with the included window kit or by cutting a hole into a wall. 1. Venting Through a Window (Using the Window Kit) FI[...]

Positioning the Exhaust Hose: • Slide the hose adaptor over the opening on the back of the unit. • Then insert one end of the exhaust hose into the adapter. • Avoid kinks and bends in the exhaust hose. This can cause moist air to accumulate, resulting in overheating and unexpected shut offs. • The exhaust hose may be extended from 12” (30[...]

Installing the Activated Carbon Filters: 1. Remove the filter frames from the unit (left and right sides). 2. Separate the filter s from the filter frames. 3. Remove the activated carbon filters from their plastic bags. 4. Attach the activated carbon filters onto the filter frames. 5. Re-fix the filters to the filter frames (make sure the active ca[...]

OPERATING INSTRUCTIONS Control Panel: FIG.13 1. ON/OFF (power) button 2. Full water tank indicator 3. Fan mode indicator 4. Mode selection button 5. Heater indicator (AC-14000H only) 6. 7. Swing button 8. Sleep mode indicator 9. Sleep mode button 10. Temperature decrease button 11. Temperature display 12. Remote control receiver 13. Timer display 1[...]

7 Turning the Unit On and Off 1. Press the ON /OFF button. The unit will aut omatically begin operat ing. If the ambient temperature is higher than 74 o F, the unit will work in coo ling mode. If the temperature is at or below 74 o F, the unit will work in ventilation (fan) mode. 2. At this time, the indicator lights will show any functions that ar[...]

Sleep Mode: 1. When in cooling mode, press the SLEEP bu tton. The set temperature will increase 2 o F on the first hour, another 2 o F on the second hour, and then mainta in that temperature. 2. When in heating mode, press the SLEEP bu tton. The set temperature will decrease 2 o F on the 1st hour, another 2 o F on the second hour, and then maintain[...]

Ionizer: Press IONIZIER button to activate the ionizer f unction. This will remove harmful particles from the air. Error Messages: If there is an error with the air conditioner, the L CD screen will display “E1” or “E2.” If either of these error messages appears, please contact the manufactu rer or a service center. All of the above functio[...]

DRAINING THE UNIT During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir. If the water reservoir is full, both the compressor and motor will stop and t he unit will beep (press any button to stop the beeping sound). The full water tank indicator ligh t will also start flashing. To resume[...]

For Continuous Drainage: • Remove the drain knob and rubber plug from the drain hole and retain it for future use. • Connect the included drain tube to the drain hole. • Connect the other end of the tube to a drain (see Fig. 18). FIG.17 • The drain tube may be extended by adding an extension tube with a suitable connector. FIG.18 Please Not[...]

For Heating Mode (AC-14000E Only): While using the heati ng function, please note the following: 1. In order to properly exhaust cool air, make sure the exhaust hose and window kit are properly installed (refer to page 4 for instructions). 2. Set up the air conditioner for continuous drai nage using the included drain tube (refer to page 12 for ins[...]

MAINTENANCE INSTRUCTIONS Always unplug the air conditioner from the power supply before cleaning. To maximize the efficiency of the air conditioner, regularly clean the unit. Cleaning the Housing: • Use a soft, damp cloth to wipe the body clean. • Never use harsh chemicals, gasoline, deter gents, chemically treat ed cloths, or other cleansing s[...]

TROUBLESHOOTING The air conditioner does not operate. y Is the air conditioner plugged in? y Is the power outlet functioning correctly? y Is the full water tank indicator light flashing? y Is the ambient room te mperature lower than the set temperature? y Is the filter dusty or dirty? y Is the air inlet or outlet blocked? The unit does not produce [...]

TECHNICAL SPECIFICATIONS Model Number: AC-14000E AC-14000H Power/Ampere Consumption for Cooling* 1420W / 12.8A Power/Ampere Consumption for Heating* N/A 1420W / 12.8A 450m 3 /h Air Volume (max. speed) Voltage / Frequency 115V, 60Hz Compressor Type Rotary Refrigerant Type R-410A Number of Fan Speeds 3 Timer 1 ～ 24 hours Exhaust Pipe Dimensions Ø [...]