InSinkErator 2200 инструкция обслуживания

Inst ant Hot W at er Dispenser Owner ’ s Manual Serie s 22 00 Serie s 1100 Inst allation, Car e & Us e Inst alacion, cuidado & uso Inst allation, soin et utilisation[...]

Equipment Y ou May Need: W e ar e delighted that you have chosen the InSinkErator ® Instant Hot Water Dispenser to be a part of your home. This unique appliance will save you time and effort in the kitchen, and you’ll enjoy discovering new uses for it each day . That’ s exactly why millions of people are now using an InSinkErator Instant Hot W[...]

HOW TO USE THIS INSTRUCTION MANUAL Provides a step-by-step narrative describing the installation step, with check boxes that can be marked as you progr ess through the installation. Contains simple illustrations that provide visual instruction to support the narrative. CAUTIONS, WARNINGS and DANGERS that will r equire your attention during the step[...]

COMPONENTS IN THIS P ACKAGE SST -FL TR Filter Head 3/8" T ube s (2) Filter Di s charge T ube Filter Cartridge 3/4" S crew s (4) Bra ss Nut / Ferrule / T ube In s ert F-HC1100 F-GN1100 F-HC2215 F-GN2215 F-HC2200 F-GN2200 S emi-circular Mounting Plate Rubber O-Ring Hex Nut Hex T ool Quic k Connector Plug (1) S nap-Connect Fitting (3 piece s[...]

B Q At tank top, depress r elease ring or gray release tab into quick-connect fitting securing blue 1/4 " tube and gently pull line off tank fitting. Pull white 7/16 " tube and clear 5/16 " tube off fittings. Q If not already equipped, the included snap-connect fitting must be installed. Q T o install snap-connect fitting, unscrew br[...]

The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch that operates your disposer . PREP ARA TION ST AR T HERE PROPER IN S T ALLA TION S HOULD T AKE ABOUT 2-4 HOUR S Q Identify locations for the dispenser faucet, tank and filter . Q Check to make sure th[...]

Property Damage: Do not pinch or b reak copper t ub in g . Do not d i s tort the la s t 1 inch of t ub in g . Q From under the sink, place the semi-circular mounting plate onto the threaded stud. Q Place hex nut onto the threaded stud. Ensure faucet head is at desir ed angle. Q Insert screwdriver into hole on side of hex tool (creating a “T”), [...]

A Q Select a spot under the sink to mount tank vertically within reach of both plumbing and electrical connections. The tank should be within 16 " or less of faucet water lines and within 30 " or less of a standard gr ounded outlet. Q While holding tank in place on the spot selected for installation, use a pencil to mark locations for 2 h[...]

Property Damage: Do not exten d the copper line s farther than the 16" provi d e d . Personal Injury: Do not locate filter a b o ve an o u tlet or other electrical d evice . In s tall hea d an d b rack et s o that connection s req u ire no s tretchin g , kinkin g or pinchin g of t ub in g . It is normal for approximately 2 oz. of water to disc[...]

Scalding Hazard: The fa u cet d i s pen s e s near - b oilin g (212ºF) water which can in s tantly ca us e s cal ds or bu rn s . U s e car e when operatin g thi s appliance . Property Damage: Join remainin g t ub e to col d water su pply only . C Q T ur n on the cold water supply . Q Depress the dispenser’ s HOT h andle and hold it until water f[...]

Property Damage: T o avoid wa ter damage, replace any loose or split tubing. Periodically inspect the unit for any signs of leakage and immediately remove from service any unit suspected of leaking. Personal Injury: This tank is a non-pressurized tank. DO NOT modify this system. DO NOT close vent tube or connect other type dispensers or valves to t[...]

CARE AND USE Electric Shock Hazard: T o prevent electrical shock, disconnect power before servicing unit. Use only a properly grounded and polarized electric outlet. Scalding Hazard: Do not allow water to boil. May result in severe burns. Factory temperature pre-set is 200˚F . T o reset the thermostat to 200° , turn the indicator one notch to the[...]

FIL TRA TION INFORMA TION T o reduce the risk associated with ingestion of contaminates due to use with wa ter that is microbiologically unsafe or of unknown quality , do not use with water tha t is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. T o reduce the risk associated with property d[...]

TROUBLESHOOTING WHA T TO DO Water and steam spits forcefully from spout without turning on the dispenser faucet. Water is not hot. • Unit is boiling. May be normal during initial setup. • The unit is unplugged. • The electric outlet is inoperative. • Activate faucet lever to release some water from the tank. • Adjust water temperature usi[...]

Inst ant Hot W at er Dispenser Owner ’ s Manual Serie s 22 00 Serie s 1100 The Emers on logo is a trademark and service mark o f Emerson Electric Co. 1.800.5 58.57 00 www .insinkerat or .com © 2007 InSinkEr ator , a division of 44069 REV . A Printed in USA Emerson Electric C o. All Rights Res erved. Inst allation, Car e & Use Inst alacion, c[...]