Fujitsu FI-5110EOXM инструкция обслуживания

Color Image Scanner fi-51 10EOXM for Macintosh G G e e t t t t i i n n g g S S t t a a r r t t e e d d Please read this guide before c onnecting the scanner to your PC. P3PC-1402-03EN[...]

Contents Introduction ............................................................................................................................... ............................ 1 1. Prep aration ........................................................................................................................................................ [...]

Introduction Thank you for purchasing the ScanSnap fi-51 10EOXM Color Image Scanner product. ScanSnap, and the Sca nSnap logo are the trademarks of PFU LIMITED. Other prod uct nam es are the tradem arks or registered tra demarks of the respective companies . ScanSnap fi-51 10EOXM is a color image scanner a nd office applications. It is a complete O[...]

 Regulatory Information Bescheinigung des Herstellers / Importeurs Für den fi-5110E OX2 wid folgendes bescheini gt: FCC declaration This equipm ent has been tested and f ound to comply with the limits for a Class B digital device, pursuant t o Part 15 of t he FCC Rules. These lim its are designed to provid e reasonable protection against harmfu[...]

About the use of mercury Lamp(s) inside this product contain mercury and must be recycled or disposed of according to local, state, or federal laws. arted | 3 The scanner lam p contains mercury. To avoid unexpected i nju ry, read the following carefully. Doing the following actions may result in serious personal injuries: • Do not put the substan[...]

4 |  Safety Precautions CAUTION The following descri bes important cautions. FOLLOW THESE INSTRUCTIONS AND BE SURE TO HEED ALL WARNINGS AND CAUTIONS DESCRIBED BELOW. Install the scanner on a desk so that none of its parts protrude outside of the desktop. Also, make sure that the scanner is installed on a flat, level surface Do not install the sc[...]

1. Prep aration This chapter describes necessary preparations before using ScanSnap. A TTENTION Do not connect the scanner to your PC before installing “ScanSnap Manager”. If the scanner is connected before installing ScanSnap Manager, it will not operate correctly. Refer to Chapter 2 for the installation of ScanSnap Manager. 1.1. Checking the [...]

2. Connecting ScanSnap This chapter describe s how to connect ScanSnap to you r compuer. 2.1. Inst alling the Supplied Software Before connecting the scanner to your computer , please install the following so ftware on your computer . c Adobe Acrobat 7.0 (Application) d ScanSnap M anager (Driver) The below given table shows th e required Operating [...]

2.2.2. Connecting the USB cable 2. Double-click the ScanSnap icon. Follow the procedure below to connect the USB cable. arted | 7 B The installation of ScanSnap M anager starts up, and the “W elcome to the ScanS nap Manager Ins taller” window appears. 3. Follow the instructions to install the software. 4. After the installation is completed, re[...]

3 . How to Use ScanSnap T his chapter descri bes basic operatio n of ScanSnap. There are six tab s used to configure the scan optio ns: [Application] 3.1. Scanning Document s Select the appli cation for viewin g the scanned im ages. W ith “ScanSnap” yo u can turn paper of fice documents o n your desk into digital fi les and save t h em just by [...]

3.3. Scanning Office Document s 1. Select “ Adobe Acr obat ” at [Application:] under the [Application] tab of “Scan and Save Settings”. 2. Load the do cuments on to the sca nner . Set the paper face-down on the Paper chute cover. Scanning direction Set the backside of the paper to the front. [SCAN] button 3. Press the [SCAN] button. Ö Scan[...]

4. T roubleshooting This chapter describ es common prob lems during the usage of ScanSnap and how to remedy them. 4.1. T roubleshooting Checklist Before you ask f or repair service, please check the following items. If you cannot solve the pr oblem even after checking the fo llowing items, contact the st ore wher e you purchased the scanner , or co[...]

Symptom Check This Item Remedy Does your PC satisfy the recommended system requirements ? Check the system requirements in section 2.1, “Before Installing”, of the Operator ’ s Manual. Scanning speed will be slower whenever the CPU and memory require ments are not met. If this is the case, a t [Scanning] - [Option...] in the "Scan and Sa[...]

12 | 4.2. Clearing Paper Jams 1. Open the ADF while pulling the Cover open lever. 2. Remove t he jam med document. 3. Close the ADF cover. ADF cover Click! Cover open lever Ö You should hear the ADF cover click into position when it returns to its o riginal position.[...]

5. Daily Care This chapter describes how t o clean the ScanSnap scanne r. 5.3. Cleaning Inside of the scanner WARNING Fire/Electric Shock Before cleaning the sca nner, disconnect the AC adapter from the power outlet. 5.1. Cleaning Materials Cleaning Materials Parts No. Remarks Cleaner F1 CA99501-0013 1 bottle (10 0ml) *1) To purchase the cleaning m[...]

2. Clean the following locations with a cloth moistened with the Cleaner F1. Pad ASSY (x1) Wipe the pad assy downwards. When cleaning the pad assy, be careful not to get your hand or the cloth ca ught on t he pick spr ing (metal part). Glass (x2 on the ADF cover and the opp osite side) Clean lightly. Pick roller (x1 ) Clean lightly taking care not [...]

6. Replacing Consumables This chapter describes how t o replace consum ables. WARNING Fire/Electric Shock Before you replace the consum ables of this scanner, disconnect the AC adapter from the ou tlet to turn off the scanner. 6.1. Part Numbers and Replacement le of Consumables Cyc The following table lists the part numbers of consumables and shows[...]

6.3. Replacing the Pick Roller 16 | A TTENTION Make sure that the Pad ASSY is completely attached. Otherwise, document jams or other feeding errors may occur. 5. Close the ADF cover Ö You should hear the ADF cover click into position when it returns to its orig inal position. 6. Turn on t he scanner. Ö ScanSnap Manage r icon change s from to . 7.[...]

5. Remove the Pick roller with its shaft. Hold the left part of the shaft, and raise it to remove the shaft from the scanner while pu lling the shaft to the left . arted | 17 A TTENTION If the around the pick roller is dirty by paper -powder, it may cause a scanning error. Please remove the dirt using a dry cloth with dollop of Cleaner F1. * Don&ap[...]

18 | 11. Close the ADF cover. Ö You should hear the ADF cover click when it returns to its original po sition. 12. Turn o n the scanne r. Ö ScanSnap Manage r icon change s from to . 13. Cli ck and hold the "ScanSnap Manager" icon on the Dock menu, and sel ect [Check consum a ble supplies] from the menu. 14. In the “Check consumable st[...]