Jura Capresso S9 manual

IMPRESSA S90/S95/S9 IMPRESSA 601 Instructions for use 5/02 Art. Nr. 63720[...]

Legend:  DISPLAY: serves as information.  DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Impressa S90/S95/S9 – 601 English ............................................................................................................. 6 – 22 Jura Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.[...]

Fig. 1 Fig. 4 Fig. 2 Fig. 9 Fig. 3 Fig. 7 Fig. 10 Fig. 6 Fig. 5 A B Fig. 8 1 2 3[...]

7 8 9 17 18 12 13 14 15 16 19 10 11 20 22 21 6 5 4 3 2 1 23 D C B A E F G H[...]

Instructions for use 1 Drip tray / residual water container 2 Drip tray cover 3 Cover for programming keys 4 Coffee key for 2 large cups 5 Coffee key for 1 large cup 6 Coffee key for 2 small cups 7 Coffee key for 1 small cup 8 Key for special coffee 9 ON/OFF switch 10 Rinsing key 11 Display dialogue system 12 Water tank with carrying handle 13 Cove[...]

6 T able of contents Jura Impressa 1. Description ...................................................... page 7 2. Safety instructions ............................................ page 7 2.1 Warnings .................................................. page 7 2.2 Safety precautions ...................................... page 7 3. Check before use ...[...]

7 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine and keep them in a safe place for easy reference in the future. Should you require further information or should particular pro- blems occur that are not dealt with in these operating instructions in[...]

8  If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions. 3. Check before use 3.1 Checking mains voltage The machine is set for the correct voltage before leaving our factory. Ensure that your mains volta[...]

9 When you switch on the machine or press any key, the cup illumi- nation is activated for 3 minutes. To switch on the cup illuminati- on, with the machine switched off, press any key. 5. Rinsing the machine  RINSE UNIT  Place an empty cup under the coffee-spout (15).  Press rinsing key . If the machine has been switched off and has alread[...]

10  Pull down cartridge mounting, until it engages audibly.  Fill water tank with cold, fresh tap-water and replace it.  Switch the machine on by pressing key ON/OFF.  Open front cover (3) and press key until you hear an acoustic signal.  PRESS KEY / POWDER QUANTITY  Press key several times until the following message appears: [...]

11 8.1 Drawing off powder coffee  Open cover (3)  Press selector key for pre-ground powder coffee .  FILL POWDER  Now put 1 or 2 level measuring spoons of pre-ground coffee into the pre-ground powder funnel (14).  Put 1, respectively 2 cups under the coffee-spout (15) and press the required key. Never use soluble instant coffee or qu[...]

12 11.2 Constant frothing up of milk  Pour milk into a milk container and immerse the intake-tube in the milk.  Put a cup under the pivoting nozzle (20) and press key . Your milk froths up.  STEAM INTAKE  When the required amount of froth has been attained push selec- tor key anew.  COFFEE READY With the flow-adjustment (S90/S95) you[...]

13 The following settings can be programmed:  Powder quantity  Coffee temperature  Water quantity  Steam portion  Tea portion  Filter  Water hardness  Economy mode  Timer clock  Automatic switch on time  Automatic switch off time  Supplies and cup counter  Language selection 13.1 Programming powder quantity ?[...]

14 13.4 Programming steam portion  STEAM PORTION  Press key .  PORTION /....20 SEC.  By pressing key or you can programme time in seconds (drawing off time of 3 – 250 sec.)  Press key .  STEAM PORTION  By pressing the button, you can select the next phase, or press the button in order to leave the programming. 13.5 Programmin[...]

15 13.9 Programming timer clock A programming of the timer clock is necessary if an auto- matic switch on time is required.  TIME —.—  Press key .  By briefly pressing key or you can set the hours and then confirm by pressing key .  By briefly pressing key or you can set the minutes and then confirm by pressing key .  By pressing[...]

16 If a mistake occurs while programming one of the above settings, just press key and the chosen setting moves back to its original standard setting. 14. Care and maintenance 14.1 Fill water  FILL WATER  If this message shows on the display no more coffee can be drawn off. Top up water. The water tank should be rinsed and filled with fresh w[...]

17 14.7 Unit calcified  UNIT CALCED The machine signals when decalcifying becomes necessary. Under the correct implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For further indications read Chapter 7 “Use of Claris filter cart- ridges“. 14.8 Cleaning metal contacts  EMPTY TRAY / CLEAN CONTACTS ?[...]

18  PLEASE WAIT  RINSE UNIT  COFFEE READY The powder funnel for pre-ground coffee should be cleaned after each cleaning process. Remove it from the machine, rinse it with hot tap water and replace it after drying. 16. Decalcifying Your machine has an integrated decalcifying program. It lasts approx. 50 minutes. Please use Jura decalcifying[...]

19  CLEAN CONTACTS / EMPTY TRAY (please refer to chapter 14.8)  PLEASE WAIT  RINSE UNIT  UNIT RINSING  COFFEE READY E 17. Disposal For correct disposal, you should return your coffee machine to your dealer, Jura service centre or Jura Elektroapparate AG. 18. Tips for a perfect coffee Height adjustable coffee-spout You can adjust the [...]

20 19. Messages Cause Action FILL WATER Water tank is empty Top up with water Water level indicator in tank is jammed Empty tank, rinse out, fill up and replace Tank is calcified, water level indicator is stuck Remove tank, decalcify, rinse well, fill up with water and replace FILL BEANS Bean container is empty Top up with beans Message still displ[...]

21 Cause Action CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14.6 the rinsing program 180 times Message still displayed, although machine Run cleaning program again; this time do not cleaned add cleaning tablet UNIT CALCED The espresso/coffee machine sector needs Run decalcifying program as described in decalc[...]

22 Problem Cause Action Not enough froth while – Unsuitable milk-type – Use full cream milk frothing up milk – Frothing nozzle blocked – Clean frothing nozzle – Clean Auto-Cappuccino – Clean Auto-Cappuccino as described in chapter – 11.6 If the above mentioned problems and/or messages still persist, please contact your dealer or get i[...]