Enterasys SecureStack C2 C2RPS-POE manuale d’uso

SecureS t ack C2 PoE Redundant Power Supply C2RPS-POE Inst allation Guide C2RPS-POE POWER 9033995-0 1 Caution: Do not use this product with Se cureS tack C2 non-PoE devices. Any SecureS tack C2 device without a “P” suffix in the model number (C2xxxx-xx) indicates a SecureS tack C2 PoE non-compliant device and is not compatible with this power s[...]

[...]

i Notice Enterasys Networks  reserv es  the  right  to  make  changes  in  specifica tions  and  other  information  containe d  in  this  document  and  its  web  site  without  prior  notice.  The  reader  should  in  all  cases  consult  Enterasys Netw orks[...]

ii Regulatory Compliance Information Federal Communications Commission (FCC) Notice This  device  co mplies  with  Pa r t  15  of  the  FCC  rules.  Operation  is  subjec t  to  the  following  two  conditions:  (1)  this  device  may  not  cause  harmfu l  interference, [...]

iii Electromagnetic Compatibility (EMC) This  product  complies  with  the  following:  47  CF R  Pa r t s  2  and  15,  CSA  C108.8,  89/336/EEC,  EN 55022,  EN 61000 ‐ 3 ‐ 2,  EN 61000 ‐ 3 ‐ 3,  EN 55024,  AS/NZS CISPR  22,  VCCI V ‐ 3.  Compatibilidad Electromágnetica ([...]

iv Declaration of Conformity Application  of  Co uncil  Directiv e(s): 89/336/EEC 73/23/EEC Manufacturer’s  Na me: Enterasys Networks, Inc. Manufacturer ’ s  Address : 50  Minuteman  Road Andover,  MA  01810 USA European  Representativ e  Address: Enterasys Networks,  Ltd. Nexus  House,  Newbury  Bus[...]

v Enterasys Networks, Inc. Firmware License Agreement BEFORE  OPENING  OR  UTILIZING  THE  ENCLOSED  PRODUCT , CAREFULL Y  READ  THIS  LICENSE  AGREEMENT . This  document  is  an  agreement  (“ Agreement”)  betwee n  the  end  user  (“Y ou”)  and  Enterasys Netw orks, Inc. ?[...]

vi 3. APPLICABLE  LAW. This  Agreem ent  shal l  be  interpreted  and  governed  under  the  laws  and  in  the  state  and  federal  cour ts  of  the  Commonwealth  of  Massachusetts  wi thou t  regard  to  its  conflicts  of  laws  provisions.  You  ac[...]

vii 8. AUDIT  RIGHTS. You  here by  acknowl edge  that  the  intellectual  property  rights  associated  with  the  Program  are  of  critical  value  to  Enterasys  and,  accordingly,  You  hereby  agree  to maintain  complete  books,  records  and  accounts [...]

viii[...]

ix Contents About this Guide Using This Guide ......... ................ ............. ............. ............. ................ ............. ............. .... ................... xi Structure of This Guide ............. ................ ............. ................ ............. ............. ................ ... ................ . xi Using[...]

x Tables 1-1 Powered Device (PD) PoE Pow er Classification s... ............. ............. ................ ............. ........ 1-3 2-1 Contents of N-POE Chassis Carton . ............. ............. ................ ............. ................ ............. .. 2-2 2-2 C2RPS-POE Status LED Indications and R ecommended Actions ...... .........[...]

SecureStack C2 Installation Guide xi About this Guide This  guide  provide s  an  overview ,  installation  and  troubleshooting  instructions,  and  specifications  for  the  Enterasys  SecureStack  C2RPS ‐ POE  power  supply,  which  can  provide  a  redundant  power  sourc[...]

Using the SecureStack C2 Manual Set xii About this Guide Using the SecureS t ack C2 Manual Set Other  manuals  have  been  develope d  for  the  SecureStack  C2  Po E  swi tch  devices  that  can  be  connected  to  the  C2RPS ‐ POE  pow er  supply  for  power  redundancy . The [...]

Conventions Used in This Guide SecureStack C2 Installation Guide xiii Conventions Used in This Guide The  following  conventions  are  used  in  this  guide: Note: Calls the reader ’s attention to any item of information that may be of special import ance. Caution: Contains information essential to avoid damage to the equipme[...]

Conventions Used in This Guid e xiv About this Guide[...]

SecureStack C 2 Installation Gui de 1-1 1 Introduction This  chapter  provides  the  following  information: For information about... Refer to page... C2RPS-POE Overview 1-2 C2RPS-POE S tatus LED 1-2 Power Classifications and Deployment 1-2 Getting Help 1-4[...]

C2RPS-POE Overview 1-2 Introduction C2RPS-POE Overview The  purpose  of  the  C2RPS ‐ POE  is  to  provide  power  backup  to  an  Enterasys  SecureStack  C2  Po E ‐ compliant  stacka ble  switch.  If  for  some  reason  the  switch  looses  power  from  its  in[...]

Power Classificati ons and Deployment SecureStack C 2 Installation Gui de 1-3 The  num ber  of  PDs  that  can  be  supported  by  the  connected  SecureStack  Po E  switch  can  be  estimated  by  ad ding  up  the  maximum  power  requirement  of  each  connected  PD [...]

Getting Help 1-4 Introduction The  SecureStack  PoE  switch  has  six  of  its  P oE/data  ports  conne cted  to  PDs  with  the  following  Class  ratings:  •O n e  does  not  support  PoE  (no  pow er) •O n e  has  no  Class  rating  (Defaults  to  Cl[...]

SecureStack C2 Installation Guide 2-1 2 Installation This  chapter  provides  the  installation  instructions  to  install  all  the  components  of  a  C2RPS ‐ POE. To  correctly  install  the  C2RPS ‐ POE,  follow  the  order  of  information  list ed  below . Required T [...]

Unpacking the C2RPS-POE 2-2 Installation Unp a cking the C2RPS-POE To  unpack  the  C2RPS ‐ POE,  proceed  as  follows: 1. Open  the  box  and  remov e  the  packing  material  protecting  the  devices. 2. V erify  the  contents  of  each  carton  and  compare  the  conten[...]

Installing the C2RPS-POE on a Flat Surface SecureStack C2 Installation Guide 2-3 Inst alling the Rubber Feet To  install  the  rubber  feet,  refer  to  Figure 2 ‐ 1  and  proceed  as  follows: 1. Place  the  C2RPS ‐ POE  on  its  back  on  a  stur dy  flat  surface  to  gain [...]

Installing the C2RPS-POE on a Flat Surface 2-4 Installation Guidelines for Inst allation Locate  the  C2RPS ‐ POE  within  152  cm  (5  ft)  of  its  power  source  and  on  a  surface  as  shown  in  Figure 2 ‐ 2 . If  the  switch  is  being  instal led  as  a  st[...]

Rack Mounting the C2RPS-POE SecureStack C2 Installation Guide 2-5 Rack Mounting the C2RPS-POE To  install  the  switch  in  a  19 ‐ inch  rack,  yo u  need:  •T w o  rackmount  brackets  and  mounting  screws  (rackmount  kit)  shipped  with  the  switch. •F o u r  user ‐ sup[...]

Rack Mounting the C2RPS-POE 2-6 Installation Att aching Bracket s and Inst alling in Rack Proceed  as  follows  to  install  the  switch  into  a  19 ‐ inch  rack: 1. Attach  the  rac kmoun t  brackets  to  the  switch,  as  shown  in  Figure 2 ‐ 3 ,  using  the  eight  M3 [...]

Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-7 Connecting C2RPS-POE Cable and AC  Power C ord The  C2RPS ‐ POE  is  connected  to  the  SecureStack  PoE  switch  using  a  C2RPS ‐ POE  cable,  as  follows: 1. Connect  one  end  of  the  C2RPS ‐ POE[...]

Connecting C2RPS-POE Cable and AC Power Cord 2-8 Installation If  you  need  additional  help,  contact  Enterasy s  Networks.  Refer  to  “ Getting  Help ”  on  page 1 ‐ 4  for  instructions. Figure 2-5 C2RPS-POE Cable Figure 2-6 Power Connector on C2RPS-POE  (rear view) 1 AC power plug 3 Redun[...]

Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-9 Figure 2-7 C2RPS-POE Cable and AC Power Cord Connection s If  you  need  additional  help,  contact  Enterasy s  Networks.  Refer  to  “ Getting  Help ”  on  page 1 ‐ 4  for  instructions. 1 Switch device 4 Switch de[...]

Connecting C2RPS-POE Cable and AC Power Cord 2-10 Installation[...]

SecureStack C2 Installation Guide A-1 A Specifications This  appendix  provides  information  about  the  f ollowing: Enterasys  Netw orks  reserves  the  right  to  change  the  specifications  at  any  time  without  notice. C2RPS-POE S pecifications The  following  sections  desc [...]

C2RPS-POE Redundant Power Supply Output Connector A-2 Specifications C2RPS-POE Redundant Power Supply Output Connector For  pin  location  and  function,  refer  to  Figu re A ‐ 1  and  Ta b l e A ‐ 2 ,  respectively .  Figure A-1 C2RPS- POE Redundant Power Supp ly Connector Pin Location s Physical Dimensions 4.[...]

Compliance Standards SecureStack C2 Installation Guide A-3 Compliance S t andards The  C2RPS ‐ POE  meets  the  safety  an d  electromagnetic  compatibility  (EMC)  requirements  listed  in  Ta b l e A ‐ 3 : T able A-2 C2RPS-POE Redundant Power Supply Connector Pin Functi ons Pin Number Function 1 - 50 V retu[...]

Compliance Standards A-4 Specifications[...]