Hoover SteamVac V2 manual

The Easy to Use Deep Cleaner Deep Cleaner ® ™ ™ SteamV ac™ V2™ Deep Cleaner cleans carpet fibers by applying hot tap water and cleaning solution. www .hoover .com ENGLISH ➜ pp. 1-17 ESP AÑOL ➜ pág. 18-27 FRANÇAIS ➜ p. 28-37[...]

2 Impor tant Safeguar ds! When using an electrical appliance, always follow basic precautions, including the following: W ARNING: T o reduce the risk of fire, electric shock, or injury: • Use indoors only . • Use only on surfaces moistened by the cleaning process. Do not immerse product. • Connect to a properly grounded outlet only . See “G[...]

3 Fill in and Save Please enter the COMPLETE model and serial numbers in the spaces provided and save. The model and serial numbers are located on the data label on the back of the handle. Model No. ____________________________ Serial No. _____________________________ Hint: Attach your sales receipt to this owner ’s manual. V erification of date [...]

Attach hose/cor d hook Inser t tabs on hook into slots on back of cleaner . Snap hook onto cleaner . Slide tabs (E) on caddy into slots (F) on back of cleaner . 4 The assembled cleaner will look like this drawing. Model with SpinScrub™ hand tool is shown. 1-2 Attach upper handle Remove clean water tank (upper tank) from deep cleaner . W ith cord [...]

5 1-9 1-11 1-10 1-12 1-13 1-15 1-16 1-17 G H Rotate top of caddy toward cleaner handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner . Storing hose and tools Pr ess hose, a few inches fr om nozzle connector end (I), into caddy . Bring hose up and over top of caddy . Press hose into opposite side of caddy . Loop hose at bottom[...]

6 1-18 Pull tool down and outward. T o reposition the tool, reverse this pr oce- dure. 1-19 How to reattach tool cover The tool cover is designed with a break- away feature which allows it to snap fr ee if it is pushed open too far . T o reattach, align hinges of cover with holes on sides of tool storage area. Snap door into place.[...]

7 2. How to use The assembled deep cleaner will look like the drawing. Model with SpinScrub™ hand tool is shown. 2-1 2-2 1. Hand grip 2. Solution trigger: press to release cleaning solution 3. ON/OFF switch 4. W ash/Rinse switch 5. SpinScrub™ hand tool (not included with all models) 6. Carrying handle 7. Clean water tank handle 8. Clean water t[...]

Automatic shut of f When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced). At that time, the yellow float disk will rise to the top of the recovery tank lid (B). The deep cleaner will no longer pick up dirty solution and the motor sound will become not[...]

9 2-13 2-14 2-15 2-16 Fill container (16 oz.) with HOOVER Carpet/Upholstery Detergent or HOOVER Bare Floor Cleaner . Do not use Bare Floor Cleaner on carpet or upholstery . Do not use any type of wax with your ‘SteamV ac’ deep cleaner . T o assure proper r esults, use only HOOVER detergent. Replace container cap and tighten. NOTE: Use only HOOV[...]

10 Befor e you begin cleaning a. V acuum thoroughly - For carpet, use a HOOVER vacuum cleaner with an agitator for best results. V acuum uphol- stery with a vacuum cleaner with clean- ing tool attachments. Use a crevice tool to reach into tufts and folds. Do not use the ‘SteamV ac’ deep cleaner as a dry vacuum cleaner . b. For upholstery , chec[...]

Carpet Cleaning Slide nozzle completely onto cleaner . Press down on nozzle to secur e it. Replace recovery tank (Fig. 2-17). The nozzle must be in the proper position in order for the recovery tank to go on properly . Raise cleaner to upright position and replace clean water tank (Fig. 2-15). 3-6 ON OFF WASH Rinse 3-7 Read “Before you begin clea[...]

12 Cleaning bare floors 3-9 How to attach bare floor attachment (A vailable at additional cost if not includ- ed with your cleaner .) Unplug deep cleaner from electrical outlet. T o prevent possible leaking, remove clean water tank (Fig. 2-10) and recov- ery tank (Fig. 2-16) before positioning bare floor attachment. Set tanks aside (do not set tank[...]

3-15 3-16 Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger . 13 Drain suction hose by turning deep cleaner ON and holding nozzle up for several minutes. Do not press trigger . Unplug deep cleaner from electrical outlet. Disconnect hose and solution tube from deep cleaner . Unplug deep cleaner fr[...]

3-20 14 A B 3-18 Using the scrub tool W ith a little solution, test the scrub tool on a hidden area before using on the desired surface. If no surface change is visible, continue to use as described below . 1. Attach hose and solution tube as instructed in Figs. 3-10 to 3-12. 2. Place handle in upright position. 3. Fill clean water tank according t[...]

4-1 4-2 T o replace brushes Align posts (A) on both ends of brush assembly with slots (B) in cleaner hous- ing. Make sure that the squar e post (C) also aligns with the square hole (D). T ur n brushes slightly until post fits easily into hole. Press brush assembly firmly to snap into place. 4-3 A A B B C D 3-22 W ith handle in upright position, til[...]

16 Storage Befor e storing: • Empty clean water tank and let air dry . Replace on deep cleaner . • Unused detergent can be stored in the detergent container . • Empty recovery tank, rinse tank and lid thoroughly with clean water and let air dry . Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on [...]

17 Full One Y ear W arranty (Domestic Use) Y our HOOVER® appliance is warranted in normal household use, in accordance with the Owner’ s Manual against original defects in material and workmanship for a period of one full year from date of pur- chase. This warranty provides, at no cost to you, all labor and parts to place this appliance in corre[...]

HOOVER et sont des mar ques déposées ® ® HOOVER y son marcas r egistradas ® HOOVER and are r egistered trademarks 1-03 F7400-900 Litho USA 56518-161[...]