InFocus IN1100 Bedienungsanleitung

Regulatory models: W1100, W1102 IN1100, IN1102 010-1712-04[...]

1 Declaration of Conformity Manufactu rer: InFocus Corporation 1 3190 SW 6 8th Parkway, Port land, Oregon 97223-8368 USA We declare un der our sole responsibility that this projector conform to the following directives and norms : EMC Directive 2004/1 08/EC EMC: EN 5502 2 EN 55024 EN 61000-3 -2 EN 61000-3 -3 Low Voltage Dire ctive 2006/9 5/EC Safet[...]

2 Table of Contents Introduction 3 Positioning the projector 5 Projector and device connec tor guide 6 Connecting a computer source 9 Required computer connections (DisplayLink or VESA) 9 Optional computer connections 9 Displaying an image 10 Adjusting the image 11 Connecting a video devi ce 12 Video device connections 13 Composite video connection[...]

3 Introduction Your new digital pro jector is simple to connect, easy to use, and straightforward to maintain. The IN1100 has native XGA 1024x768 resolution, and the IN1102 has WXGA 1280x800 resoluti on. This guide applies to all products. They are co mpatible with a wide variety of computers and video d evices. Product specifications To read the l[...]

4 Connector panel The projector provides the following connectors: •V E S A c o m p u t e r •S - v i d e o •C o m p o s i t e v i d e o • Audio in • USB DisplayL ink connector, for c omputer vide o input. This US B connection also provides slide advance (and mo use control when used with an optional remote control only) audio in S-video c[...]

5 Positioning the projector To determine where to position the proj ector, consider the size and shape of your screen, the location of your powe r outlets, and the distance between the projector and the rest of your equipmen t. Here are some general guidelines: • Position the projector on a flat surfac e at a right angle to the screen. The projec[...]

6 Projector and device connector guide The following illust ration and table shou ld help you find the connect ors to use and obtain the best reso lution possib le from your input devices, such as computers, standard VCRs, DVD play ers (progressive and interlaced), HDTV sources (1080i, 1080p and 720p HDTV formats), TV and satellite tuners, camcorde[...]

7 Video Dev ice Video Compatibility If Your Device Connector Is Attach to Adapter or Labeled Connector on Projector For Setup Instructions, see Comments Standard Broadcast TV ( not HDTV) via: cable, digital cable, satellite TV, DVD, or VCR NTSC, PAL, and SECAM formats Composite video or S-video Video 2 or Video 1 Composite video connecti on on page[...]

8 HDTV (High Definition TV) 1080i, 1080p, 720p Component 480i VGA Component video Computer 2 Computer 2 via optional VESA to Component adapter VESA connecti on on page 13 Component vide o connection on page 13 Progressive DVD 1080i, 1080p, 720p Component 480p and 480i VGA Component video Computer 2 Computer 2 via optional VESA to Component adapter [...]

9 Connecting a computer source Required computer connections (DisplayLink or VESA) If your computer has Windows XP SP 2 or newer*, conne ct the USB cable between your computer's USB port and the projector's DisplayLink co nnector , then follow the instructions on th e screen. See the DisplayLink Manager User's Guide for more inform a[...]

10 Displaying an image Touch the Power button. The Power button blinks green and the fans start to run. When the lamp comes on, the start up sc reen displays and the Power button is ste ady green. It can take a minute for the im age to achieve full brightness. ? No start up screen? Get help on page 15. Turn on your computer or video device. The ima[...]

11 Adjusting the image If necessary, adjust the height of the projector by pressing the elevator foot release button to extend the foot. If necessary, rotate the leveling fo ot located at the rear of the projector. Avoid placing your hands near the ho t exhaust vent at the side of the projector. Position the projector th e desired distance from the[...]

12 Connecting a video device You can connect vi deo devices such as VCRs, DVD players, camcorde rs, digital cameras, vi deo game consoles, HD TV receivers, and TV tuners to the projector. You can connect the audio di rectly to the projector to get sound from the built-in speaker, or you ca n bypa ss the projector’s audio system and connect the au[...]

13 Video device connections No video cables are provided with the projector. You can order cables from InFocus or provide your own. Composite video connection Plug the composite vid eo cable’s ye llow connector into the video-out connector on the video device. Plug the other yellow connector into the yellow Video 2 connector on the projector. Plu[...]

14 Shutting down the projector The projector automatically displays a black screen afte r no active source is detected for 30 minutes. This black screen helps preserve the life of the projector. The image returns when an ac tive source is detected or a remote or keypad button is pressed. Screen Save Time You can make the black screen appear after a[...]

15 Problem Solution Result No start up screen Plug power cord into the projector press power button Correct image Only start up screen appears If your computer is using the projector's DisplayLink connector, see the DisplayLink User's Guide for troubleshooting information. Press the Source button activate laptop’s external port Computer[...]

16 Problem Solution Result No computer image, just the words “Signal out of range” Press the Aut o Image butt on on keypad adj ust computer ref resh rate in Control Panel > Disp lay > Settings > Adva nced > Adapte r (location varies by operating system ) You may also need to set a different reso lution on your computer, as shown in [...]

17 Image fuzzy or cropped Set your computer’s display resolution to the native resolution of the projector (Start > Settings > Control Panel > Display > Settings tab) Image clear and not cropped Image not centered on screen Move projector, adjust zoom, adjust height Correct image Problem Solution Result A A For a laptop, disable lapto[...]

18 Image not square Adjust Keystone on keypad Square image Image not sharp Adjust Sharpness in the Basic Picture menu Correct image Image does not fit 4:3 or 16:9 screen Change aspect ratio to 4:3 or 16:9 in Basic Picture > Aspect ratio menu Correct image Problem Solution Result AB AB[...]

19 Image reversed left to right Turn off Rear Project in Setup menu Correct image Projected colors don’t match source Adjust color, tint, brightness, contrast in the Basic Picture menu Correct image The video embedded in my PowerPoint presentation does not play on the screen If your computer is using the projector's DisplayLink connector, se[...]

20 Lamp won’ t turn o n, T emper ature ligh t is on Make sure vents aren’t blocked, turn off the projec tor and allow it to cool for one minute Lamp turns on “Replace lamp” message appears at startup, lamp won’t turn on, Lamp light is turned on Lamp must be replaced (see page 34) Lamp turns on Problem Solution Result A Temperature light S[...]

21 Still need assistance? If you need assistance, visit our website at www.infoc us.com/service or c a l l u s . Check out our HOW TO section there fo r additional info rmation. See the Quick Start Poster/Booklet for su pport contact information. This product is backed by a limited warranty. An extended warranty plan may be purchased from your deal[...]

22 Using the remote control The remote uses two (2) AA batteries. Th ey are easi ly inst alled by removing the cover from the remote’s back, aligni ng the + and - ends of the batteries, sliding them into place, an d then replacing the cover. Caution : When disposing of the batteries, be sure to do so in an environmentally proper manner. To operat[...]

23 Using the audio Using the projector’s speaker To use the projector's spea ker, connect the audio source to the projector's Audio In c onnector. To adjust the volume, press the Volume buttons on the keypad or remote. Troubleshooting Audio If you aren’t hearing the audio, check the following: • Make sure the volume is turned up eno[...]

24 Using the keypad buttons Most buttons are describe d in detail in other sections, bu t here is an overview of their functions: Power –turns the projector on and off (page 10). Auto Image –resets the projector to the source. Presets –cycles through the availabl e preset settings (page 28). Keystone –adjusts squareness of the image (page 1[...]

25 Optimizing computer images After your computer is connec ted prop erly and the co mputer’s image is on the screen, you can optimize the im age using the onsc reen menus. For general information on using the menus, s ee page 27. • Adjust the Keystone, C ontrast, or Br ightness in the Basic Picture menu ( page 28 ). • Change the Aspect Ratio[...]

26 Optimizing video images After your video devic e is connected prop erly and the image is on the screen, you can optimize the im age us ing the onscreen menus. For general informatio n on using the m enus, see page 27. • Adjust the Keystone, Contrast, Bright ness, Color, or Tint in the Basic Picture menu ( page 28 ). • Change the Aspect Ratio[...]

27 Using the menus To open the menus, press the Menu button on the keypad or remote. (The menus automaticall y close after 60 seconds if no but tons are pressed.) Use the arrow buttons to move up and do wn to highlight the desired menu, then press the Select butto n. To change a men u setting, highli ght it, press Select , then use the up and down [...]

28 Basic Picture menu To adjust the following settings, highlight the setting, press Select , use the up and down arrows to adjust the values, then pr ess Select to confi rm the changes. Brightness : changes the intensity of the image. Contrast : controls the degree of differenc e between the lighte st and darkest parts of the picture and changes t[...]

29 Advanced Picture menu BrilliantColor™ : produces an expanded on-s creen color spectrum that delivers enhanced color saturation fo r bright, true-to-life images. Choose Normal Look for most video sourc es and Bright Look for most computer sources. White Peaking : (video sources only) increases the brigh tness of whites that are near 100%. Color[...]

30 Setup menu Language : allows you to select a language for the onscreen display. Custom Key : allows you to assign a differen t function to the Custom button, allowing you to quickly and easily us e the effect. Highlight an effect and press Select to choose a different one. • Source Info : the default action. Shows the Source Info menu. • Pro[...]

31 Rear Project : reverses the image so you can project from behind a translucent screen. Auto Keystone : automaticall y adjusts vert ical image. Prevent PC Screen Saver : prevents your computer from going into Screen Save mode. The projector must be connected to the PC via a USB cable for this feature to work. Search Screen : allows you to display[...]

32 Status and Service menu Source Info : a read-only displ ay of current source settings. Projector Info : a read-only di splay of current projector settings. Reset Lamp Hours : resets the lamp hours used counter in the Projector Info menu to zero. Do this only after changing the lamp. Factory Reset : restores all set tings to thei r default. Servi[...]

33 Maintenance Cleaning the lens 1 Apply a non-abrasive camera lens cleaner to a s oft, dry cloth. • Avoid using an excessi ve amount of cleaner, and don’t apply the cleaner directly to the lens. Ab rasive cleaners, solvents or other harsh chemicals might scratch the lens. 2 Lightly wipe the cl eaning cloth over the lens in a circular motion. U[...]

34 Replacing the projection lamp The lamp hours used timer in the Projec tor Info menu counts the number of hours the lamp has been in use . Twenty hours before the lamp life expires, the message “Change lamp” appears on the screen at startup. • NOTE : You can order new lamps from www.infocus.com (in select areas), your retail er or your deal[...]

35 • Be extremely careful when removing the lamp housing. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp module is des igned to contain most of the se fragments, but use caution when removi ng it. Before replacing a ruptured lamp, cl ean the lamp compartment an d dispose of cleaning materials. Wash [...]

36 INDEX Numerics 16x9 vs 4x3 12 A Advanced menu 29 Aspect Ratio 12, 28, 30 B Blank Key 30 Blank Screen 30 Brightne ss 28 BrilliantColor 29 C cable box 12 cleaning the lens 33 Color 28 Color Space 29 Color Temperature 29 Computer In connector 9 connecting computer 9 video devic e 12 connector panel 4 connectors on projector 7 contacting InFocus 21 [...]

37 connecting vi deo devices 1 2 connector panel 4 customization 26 image size 5 keypad buttons 24 language 30 maintenance 33 menus 27 offset 5 positioning 5 registering 3 reset 32 safety considerations 2 security lock 33 setting up 5 shutting down 14 Status Indicator Panel 14 troubleshooting problems 14 R Rear 30 registering your projec tor 3 remo[...]