Danby DPAC8399 Bedienungsanleitung

Portable 4 Season Home Comfort The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ord[...]

Table Of Contents Page Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Electrical and Unit Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Energy-Saving Tips. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [...]

Cuidado y Mantenimiento 1) No use gasolina, bencina, diluyentes ni ningún otro producto químico para limpiar esta unidad, ya que estas substancias pueden perjudicar la terminación de la unidad y deformar las piezas de plástico. 2) Nunca trate de limpiar la unidad vertiendo agua directamente sobre la superficie de la misma, ya que ello puede det[...]

Electrical Specifications 1. All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions regarding the following instructions, contact a qualified electrician. 2. Check available power supply and resolve any wiring problems BEFORE installation and operation of this unit. 3. [...]

Window Installation Installation Accessories Fig. 1 Description Quantity Flexible exhaust hose with adapters ............................3/set stretches from 19 1 /2" (50 cm) up to 74 3 /4" (190 cm) Window exhaust adapter (flat mouth).............................1pc Adjustable window/patio door slider kit .....................3/set from 2[...]

External Water Tank Feature: This unit is equipped with a secondary “External Water Tank” feature. (tank quick connect to be installed by customer) The main unit is inclusive of a factory installed “quick connect” fitting located at the rear of the unit. When the external tank is connected to the main unit, it will increase total running ti[...]

External Water Tank Instructions (cont'd) 3. Position the external water tank on the support tray, making sure the quick connect on the water tank is aligned with the factory installed quick connect at the back of the cabinet. See Fig.37 4. To make the connection, simply "push" the water tank quick connect into the cabinet quick conn[...]

Window / Patio Door Kit Installation Your window kit has been designed to fit most standard “vertical” and “horizontal” window applications. Now with the addition of a 3rd slider section, (Fig.2b) , it is possible to install this kit in a patio door application (up to a maximum height of 80"). Please refer to Fig. 2, Fig. 2a, & Fig[...]

CLOCK: Allows you to initiate and/or change the TIME OF DAY setting. TIMER ON: Used to initiate the AUTO ON start time program, in conjuction with the & key pads. TIMER OFF: Used to initiate the AUTO OFF stop time program, in conjuction with the & key pads. Fig. 5 Fig. 6 Green light while cooling. Red light while heating. Green light while [...]

Setting TIME OF DAY (Clock) Instructions: 1) Push and hold the CLOCK key pad for three (3) seconds. The clock display will flash indicating “12.00” for approximately 10 seconds. Fig. 8. 2) Push either the ^ or v key pad, to enter the correct time of day. Each depression of the key pad will increase or decrease the time of day setting (1 minute [...]

Air Conditioner Operating Instructions (cont’d) 5) Press the FAN key to select the desired fan speed setting (Low-Med-High) . See Fig. 14. Your selection will be displayed in the LCD window (each depression of the fan key will advance to a different setting). 6) Press the SWING key to activate the automatic air swing (oscillating) feature (the ?[...]

DRY(Dehumidifier) Operating Instructions 1) Press the I/O (on/off) key pad to switch on the unit. 2) Press the MODE key until the word DRY (Dehumidifying) is displayed in the LCD display window. Fig. 17. Each depression of the MODE key will advance to a different mode setting (Cool-Heat-Dry-Fan) . 3) Press the appropriate or key to set a dehumidify[...]

DRY (Dehumidifier) Operating Instructions (cont’d) 6) To connect the continuous drain option. Remove the water tank from the cabinet. Inside the cabinet (water tank area) you will find a section of hose hanging beside the water tank, which is plugged/capped at the end. Remove the plug from the end of the hose and install the drain hose connector [...]

Heater Operating Instructions 1) Press the MODE key until the word Heat is displayed in the LCD window. Fig. 20 . Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Heat-Fan) . The red indicator light will come on indicating the “Heating” mode is operational (there may be a slight delay of 5-10 seconds before the[...]

Fan Operating Instructions 1) Press the I/O (on/off) key pad to switch on the unit. 2) Press the MODE key until the word FAN is displayed in the LCD window. Fig. 25 . Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Heat-Fan) . No indicator mode light is visible during operation of the FAN mode (this is normal). 3)[...]

Auto-Timer Instructions NOTE: Auto-Timed programs cannot be set with the hand held remote control. The TIME OF DAY CLOCK must be set before the AUTO-TIMER feature will operate. The AUTO-TIMER feature offers a unique selection of multiple choice, fully automatic on/off (start/stop) programs between 0 - 23 hrs, 50 min. under any one mode of your Port[...]

Setting the AUTO-ON TIMER (cont’d) 5) All of the settings are now registered. TURN THE UNIT “OFF” USING THE I/O SWITCH. 6) To set the AUTO-ON timer, the unit must be turned to the “off” position (non-operational). 7) Press the TIMER-ON key pad to initiate the AUTO-ON time sequence. Fig. 32. The display window will indicate TIMER-ON and th[...]

Setting the AUTO-OFF TIMER Before setting the AUTO-OFF timer, the time of day clock must be set/operational. 1) To set the AUTO-OFF timer, the unit must be turned on (I/O switch) and operational. 2) Press the TIMER-OFF key pad to initiate the AUTO-OFF time sequence. Fig. 33. The display window will indicate TIMER-OFF and the word OFF will flash for[...]

Setting the AUTO-ON & AUTO-OFF TIMER Before setting the AUTO-ON & AUTO-OFF Timer, the time of day clock must be set/operational. You must also select the appropriate operating MODE . After the appropriate settings have been made, turn off the unit. 1) Press the TIMER-ON key pad to initiate the AUTO-ON time sequence. (Fig. 32) . The display [...]

Remote Control Features The hand held remote unit allows you to control all operational aspects (excluding Auto-Timed Programs) of your Portable 4 Season Home Comfort Appliance from the convenience of your favorite armchair. Here are some things you should know about operating the unit with the hand held remote. Upper Control Buttons I/O: Power swi[...]

Remote Control Operating Instructions 1. Sending Signal: When the main unit is turned on (I/O button), this symbol (1A) will appear in the remote LCD window. The remote must be aimed directly at the control panel on the main unit when initiating commands. When a remote control button is depressed (excluding L, R, Clock, & set˚C/˚F), the follo[...]

Remote Control Operating Instructions (cont’d) 6. Swing Setting: Press the remote “Swing” button to activate the automatic air swing (oscillation) feature. The symbol " " will momentarily appear in the LCD window confirming the "swing" feature is activated and/or deactivated. 7. L(Lock) Button: Press the remote “L” but[...]

Care and Maintenance 1) Do Not use gasoline, benzene, thinner or any other chemicals to clean this unit ,as these substances may cause damage to the finish and deformation of plastic parts. 2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause deterioration of electrical components and wiring[...]

LIMITED PRODUCT WARRANTY This quality product is warranted to be free from manufacturer’s defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer. This warranty is available only to the person to whom the unit was originally sold by Danby or by an authorized distributo[...]

GARANTIE LIMITÉE Cet appareil de qualité est garantie exempt de tout vice de matière première et de fabrication, s’il est utilisé dans les conditions normales recommandées par le fabricant. Cette garantie n’est offerte qu’à l’acheteur initial de l’appareil vendu par Danby ou par l’un des ses distributeurs agréés et elle ne peut[...]

Table des matières Page Introduction........................................................................................................ 25 Spécifications électriques de l’appareil.............................................................. 26 Conseils pour la conservation d’énergie.....................................................[...]

Introduction Danby est extrêmement reconnaissant de votre achat de l’appareil de “Confort au foyer”. Votre famille est maintenant pourvue de tous les conforts pour le domicile, chalet ou bureau. Ce manuel d’utilisation vous offre des renseignements pratiques pour le soin et entretien de votre nouvel appareil. Un appareil Danby bien entrete[...]

Spécifications électriques 1. Toutes les installations électriques doivent être accomplies par un technicien qualifié selon les normes régionales et nationales. Consultez un technicien qualifié si vous avez des questions au sujet des instructions suivantes. 2. Vérifiez l’alimentation disponible et trouvez les solutions à tous les problè[...]

Installation dans la fenêtre Accessoires d’installation Fig. 1 Description Quantité Boyau flexible d’échappement avec raccords ............................ 3/jeu s’étire de 19 1 /2 po. (50 cm) à 74 3 /4 po. (190 cm) Adapteur pour échappement par la fenêtre ............................. 1 pièce (extrémité plate) Jeu d’installation [...]

Le réservoir d’eau externe: Cet appareil est équipé d'un "deuxième réservoir d'eau externe" (le raccord rapide doit être installé par le client). L'unité primaire comprend un "raccord rapide" installé à l'usine et situé à l'arrière de l'appareil. Lorsque le réservoir d'eau exter[...]

Instructions d’installation du réservoir d’eau externe (suite): 3. Mettez le réservoir d’eau externe à la bonne position sur le rebord de soutien. S’assurez que le raccord rapide du réservoir d’eau est aligné sur le raccord rapide intstallé à l’usine à l’arriére du caisson. Voir Fig.37 4. Pour faire la connexion, poussez le r[...]

Installation du jeu de fenêtre / porte patio La conception du jeu de la fenêtre permet l’ajustement de l’appareil à la plupart des fenêtres à coulissement “vertical” ou “horizontal”. L’incorporation d’une troisième section coulissante, (Fig.2b) permet l’installation du jeu dans une porte patio (jusqu’à une hauteur de 80 p[...]

Fig. 5 Fig. 6 Lampe verte pendant le refroidissement Lampe rouge pendant le chauffage Lampe verte pendant la déshumidification Fig. 7 Un avertisseur signale 8 BIPS et la lampe témoin rouge WATER FULL (plein d’eau) clignote toutes les 0,5 secondes. FONCTION DES TOUCHES DE COMMANDE Fig. 5 Les touches du panneu de commande “‘s’allument” au[...]

Réglage de l’HEURE (horloge): 1) Appuyez sur la touche CLOCK pendant trois (3) secondes. L’affichage indique “12.00” pendant environ 10 secondes. Fig. 8. 2) Appuyez sur la touche ou pour obtenir l’heure exacte. Chaque appui sur la touche augmente ou décroît l’heure indiquée une minute à la fois. Fig. 9. 3) Lorsque l’affichage ind[...]

Instructions d’utilisation du climatiseur (suite) 5) Appuyez sur la touche FAN pour choisir la vitesse du ventilateur de votre choix (Low–Med–High ). Voir la Fig. 14 . Votre choix est indiqué sur l’ ACL . Chaque appui sur la touche de ventilation change le réglage). 6) Appuyez sur la touche SWING pour activer le balayage d’air (oscillat[...]

Instructions d’utilisation du déshumidificateur 1) Appuyez sur la touche I/O (mise en marche/arrêt) pour mettre l’appareil en marche. 2) Appuyez sur la touche MODE jusqu’à ce que le mot DRY (déshumidificateur) soit indiqué sur l’ ACL . Fig. 17. Chaque appui sur la touche MODE change le mode (Refroidissement–chaleur-déshumidification[...]