Zanussi ZUD 9154 инструкция обслуживания

REFRIGERA T OR ZUD 9154 2222683-22 INSTRUCTION BOOKLET[...]

Instructions for the User Important Safety Instructions 3 Description of the Appliance 4 Operation 4 Before use 4 Setting the temperature 4 Fresh food refrigeration 4 The door shelves 5 Normal Operating Sounds 5 Health and Safety Guidelines 6 Defrosting 6 Maintenance and Cleaning 7 Internal cleaning 7 Periodic cleaning 7 Changing the light bulb 7 W[...]

IMPORT ANT SAFETY INSTRUCTIONS 3 These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. General Safety ■ This appliance c[...]

DESCRIPTION OF THE APPLIANCE OPERA TION Before use Remove all securing tapes. W ash inside the appli- ance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger . Dry thoroughly . Setting the temperature The temperature inside the refrigerator is regulated by a thermostat co[...]

5 D338 T o help you use your refrigerator correctly , here are some more useful hints: Raw meat (beef, pork, lamb & poultry): wrap in polythene bags and place on top of the salad draw- ers. Meat can only be stored safely in this way for one or two days at the most. Fruit & vegetables : these should be thoroughly cleaned and placed in the bo[...]

Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever . The following tips should help you to ensure that the food in your home is in as perfect condition as possib[...]

1. Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (avail- able from your nearest Zanussi Service Force centre). 2. Replace the light cover by sliding it into its original position and replacing the screw . When the appliance is not in use When the applianc[...]

8 If after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. Symptom S[...]

SER VICE AND SP ARE P ARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. The addresses are listed on the followin[...]

10[...]

11[...]

Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part there- of is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: ■ The[...]

TECHNICAL SPECIFICA TIONS Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance. The following table shows which ambient temperature is correct for each climate classification. SN +1[...]

ELECTRICAL CONNECTION W ARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suit- able for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should [...]

Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: 1 1 2 3 4 5 6 8 7 2 BUILDING-IN INSTRUCTIONS 15 Before carrying out any work, remove the plug from the power socket. Grid preparation Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove[...]

16 3 10 11 9 12 13 Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the gasket or accelerate this process by heating up the part involve[...]

17 596 555 max + - 4. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. 5. T o adjust the height proceed as follows: - Loosen or tighten the two front feet. - The rear feet are adjusted by turning the screw in the fro[...]

18 7. Screw appliance into place and retain the cabinet with screws through the securing brackets into the worktop or adjacent woodwork as necessary . 8. T o mount the furniture door proceed as shown in the figures: 6 a b 10 1 2 3 4 C 7 8 ab clic clic c C C[...]

19 9 b a = = 1 2 10 1 2 3 45 ° 9/a 275 275 max 100 11 = = 10 UPPER P AR T OF KITCHEN FURNITURE P ANEL LOWER P AR T OF KITCHEN FURNITURE P ANEL 12[...]

20 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ■ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dime[...]

[...]

[...]

[...]

© Electrolux Household Appliances Limited 2000[...]