Zanussi ZCM 640 ZCM 641 инструкция обслуживания

MIXED FUEL COOKER ZCM 640 ZCM 641 INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance GB[...]

2 Import ant Safety Information Y ou MUST read these warnings carefully before inst alling or using the hob. If you need assistance, contact our Customer Care Department on 08705 727727 Inst allation • This appliance must be installed and serviced by a competent person as stated in the Gas Safety ( Installation and Use) Regulations Current Editio[...]

3 Content s Guide to Use the Instructions The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions S tep by step instructions for an operation Hints and T i ps Environmental Information For the User For the Inst aller Important Safety Information 2 Control Panel 3 The Oven Cavity 4 The Gas Hob Co[...]

4 T o light a burner: • Push the electric ignition button which is marked with a little spark ( ). • At the same time, push in and turn the relevant control knob anticlockwise to maximum position. • Then adjust the flame as required. • If the burner does not ignite, turn the control knob to zero, and try again. When switching on the mains, [...]

5 The minute minder will mark the end of a timed period with an acoustic alarm. The maximum timing is 60 minutes. T urn the Minute Minder knob clockwise to the maximum time position, then turn it back to the required time. The Minute minder will not affect in any way the oven operation, if it is in use. The Minute Minder Oven Function Control Knob [...]

6 INST ALLA TION Any gas installation must be carried out by a qualified gas installer or competent person, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event o[...]

7 The air inside the oven is heated by the element around the fan situated behind the back panel. The fan circulates hot air to maintain an even temperature inside the oven. The advantages of cooking with this function are: • Faster Preheating As the fan oven quickly reaches temperature, it is not usually necessary to preheat the oven although yo[...]

Shelf positions are not critical, but make sure the shelves are evenly spread. When cooking more than one dish in the fan oven, place dishes centrally on the shelves rather than several dishes on one shelf. When the oven is full, you may need to allow slightly longer cooking time. A shelf may be placed on the floor of the oven. Place dishes on a sh[...]

The oven fan operates without heat and circulates the air , at room temperature, inside the oven. This increases the speed of defrosting. However , please note that the temperature of the kitchen will influence the speed of defrosting. This function is particularly suit able for delicate food which could be damaged by heat, e.g. cream filled gateau[...]

10 Grilling Grilling must be carried out with the oven door closed. The grill pan handles must be removed from the pan. How to Use the Grill 1. T urn the oven control function knob to . 2. T urn the thermostat control knob on the required temperature. 3. Adjust the grid and grill pan runner position to allow for different thicknesses of food. Posit[...]

11 Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply . This appliance cannot be cleaned with steam or with a steam cleaning machine. The Hob T op The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. Regularly wipe over the [...]

12 FO 0287 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner . If the soilage has become set, after the oven has cooled down, the f[...]

13 If the appliance is not working correctly , please carry out the following checks, before contacting your local Service Centre. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM  There is no sp[...]

14 Zanussi Guarantee Conditions We, Zanussi, undert ake that if, within 12 months of the date of the purchase, this Zanussi appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same FREE OF ANY CHARGE for labour , materials or carriage on conditi[...]

15 Import ant Safety Requirement s This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations (current addition) and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British S tandard Codes of Practice - B.S. 6172, B.S. 5440: Part 2 and B.S. 6891: Current Editions. For[...]

16 Inst allation Positioning the Appliance (Fig. 1) This appliance cannot be positioned on a base. The appliance cannot be installed beside or between furniture units whose height exceeds the cooker worktop. Note A: The appliance is designed to be flush fitted with 2mm clearance at each side to allow for it to be pulled forward for cleaning etc. No[...]

17 LEVELLING FEET PENCIL LINE ON THE FLOOR PLAN VIEW OF THE COOKER 580 mm. 100 mm. 300 mm. 295 mm. WALL F ACE A BACK OF COOKER SIDE VIEW OF THE COOKER BASE OF COOKER ENGAGEMENT EDGE FOR ST ABILITY BRACKET Fig. 3 Fitting the St ability Bracket (Not supplied) If the cooker has to be installed with a flexible supply pipe, it is necessary that a stabil[...]

18 Electrical connections Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS COOKER MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This cooker is designed to be connected to [...]

19 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . - Turn the gas t ap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguishe[...]

Grafiche MDM - Forlì 35687-5431 06/04 CUSTOMER CARE Zanussi-Electrolux Cornwall House 55-77 High S treet Slough Berkshire SL1 1DZ 08705 727727 (*) © Electrolux plc 2004 From the Electrolux Group. The world’ s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More tha[...]