Yard-Man 21A-144R401 инструкция обслуживания

Cultivator Model Number 21A -14 4R401 PRI NT ED IN U.S.A. OPERA T OR’S MANU AL FORM NO . 770-10457. fm (5/02) IMPORT ANT : READ SAFETY RULES AND INSTR UC T IO NS CAREFULL Y MTD PRODUCTS INC. P .O . B O X 368022 CL E VELAND , OHIO 44136-9722 Wa rn i n g: This uni t is equ ippe d wit h a n int ern al com bust io n engi n e and sh ou ld not be use d[...]

2 TAB LE OF CONTE NTS Conten t Page Import ant Safe Op erati on Pract ices ..... .. ..... .. ... .... ... ..... .. ..... .. ..... .. ..... .. ... .... ... .... . 3 Assem bling Your Cu lti vator.... .. ..... .. ..... .. ... .... ... .... ... ..... .. ..... .. ..... .. ..... .. ... .... ... .... . 5 Know Yo ur Cul tiva tor ... ... .. ..... .. ..... .[...]

3 SECT IO N 1: I MPOR TAN T SAF E OPE RATI ON PRAC TICE S WARNING: This symbol points out important s afety instructions which, if not followed, cou ld endanger the persona l s a fety and/or property of yourself and others. Read and follow all i n s tructions in this manual before attem pt ing to op erat e this mac hine. Failure to com ply with the[...]

4 4. Keep b y standers , helpers, pets, and children at least 50 feet from the m achine while it is i n operation. Stop machin e if an y o ne enters the area. 5. Be careful when cul t ivating in hard ground. The tines may catc h in t he ground and prop el the cultivator forward. If t his occurs, let go of the handle and do not restrain the machi ne[...]

5 SECTION 2: ASSEMBLING YOUR CULTIVATOR IMPORT ANT: This unit is shipped without gas oline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separat e engine manual before operating your m ower. NOTE: Refe rence to right or left hand side of the cultivator is observed from the ope rating position. Re movi[...]

6 On/Off Switch The On/Off sw itc h is located on the up per handle. The switch must be in the On (I) to start engine and Of f (O) to stop engine. Handle Conne ctors The handle con nectors are on each side bet ween lower and upper handle. The y are used to lock the upper handle in a set po s ition. Front H andle The front handle is used as supp ort[...]

7 • Remove t he oil p lug/dipst ick fro m the cra nkcase and pour the e nt ire bottle of oil into the oil fill hole. See F igure 3. • Wipe up any oil that may have spilled and reinstall the oil fill plug/dipstick. Fi gur e 3 Gas Fill-Up Old fuel is the primary reason fo r the uni t not running properly. Be sure to use fresh, c lean, and unleade[...]

8 • With one hand gras ping the starter handle, the other hand sho uld grasp the front handle on the cultivator for a brace. • Pull the starter rope briskly 3 to 5 times or until engine st arts. • Move chok e lever t o Open (C) pos ition. • With tines off the ground, depress t h e t hrottle lever against the upp er h andle to increase engin[...]

9 • Push t he On/Off switch to O ff (O) position to stop engine and tines and disconnect spa r k plu g t o avoid ac c ident al starting. • It may be necess ary to lay the cultivator back in a horizonta l position on a flat level surf a c e with the upper handle touc hing the ground. • Remove the click pin from each end of the tine shaft and s[...]

10 • Refill the crankcase with 3.4 fl.oz. (100 ml.) of SAE 30 SF , SG, or SH oi l. • Replace the oil fill plug/dips t ick. Air Filter Maintenance • Open the air filter cover on side of engin e by push ing the tab on the left side in and swinging the air filter cover out and off. See Figure 9. • Remove th e air f ilter and screen. Fi gur e 9[...]

11 • Wipe equip ment with a oiled rag to prevent rust. • Never store the unit with fuel in the tank where fumes may reach an open flame or spark. Engine If the unit w ill be stored for longer t h an 60 days: • Drain all gas oli ne f rom the gas tan k into a container and dispos e in accordance with federal, state, and local regulation s . •[...]

12 Model 21A-144R401 11 11 12 13 14 18 19 20 21 22 22 24 23 25 15 13 16 17 27 28 27 29 30 31 32 33 34 35 36 37 26 1 2 3 5 6 7 8 8 4 9 10[...]

13 Model 21A-144R401 Ref. No. Part No. P art Descr i p t ion 1. 747-1320 Throt tle Control 2. 732-1038 T orsion Sp ring 3. 725-2009 On/O ff Swit ch 4. 720-0294 F oam G rip 5. 746-1147 Throt tle Cab le 6. 749-1294A Upper Handl e 7. 731-1268 Upper Handl e Connector 8. 710-0405 Carri age Scr ew 5/16- 18 x 3.0 9. 725-0157 Cabl e Tie 10. 718-0812 Driv e[...]

14 Model 21A-144R401 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 69 72 71 73 74 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 92 95[...]

15 Model 21A-144R401 Ref. No. Part No. P art Descr i p t ion 1. 182339 Engine Cov er Scre ws 2. 182651 Starter Rope Eyel et 3. 182650 Engine Co ver 4. 182652 Eyel et Nu t 5. 181025 V alve Cov er Screw 6. 182098 V alve Cov er 7. 182099 V alv e Cov er Gasket 8. 182340 Rocker Adjust ment Nut 9. 182101 Rock e r Ar m Piv ot 10. 182100 Rock e r Ar m 11. [...]

MANUF A CTURER ’ S LIMITED W ARRANTY FOR: The li mited w ar r anty se t f or th belo w is giv en by MTD PRODUCTS INC ( “ MTD ” ) wi t h respec t to ne w merchandi se purc hased and used in the Uni ted States , i ts posse ssions and ter ritories . MTD warr ants t his p r odu ct agai nst d efect s in materi al and w orkmanshi p f or a period of[...]