Yamakawa M2150 инструкция обслуживания

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21

Идти на страницу of

Хорошее руководство по эксплуатации

Законодательство обязывает продавца передать покупателю, вместе с товаром, руководство по эксплуатации Yamakawa M2150. Отсутствие инструкции либо неправильная информация, переданная потребителю, составляют основание для рекламации в связи с несоответствием устройства с договором. В законодательстве допускается предоставлении руководства в другой, чем бумажная форме, что, в последнее время, часто используется, предоставляя графическую или электронную форму инструкции Yamakawa M2150 или обучающее видео для пользователей. Условием остается четкая и понятная форма.

Что такое руководство?

Слово происходит от латинского "instructio", тоесть привести в порядок. Следовательно в инструкции Yamakawa M2150 можно найти описание этапов поведения. Цель инструкции заключается в облегчении запуска, использования оборудования либо выполнения определенной деятельности. Инструкция является набором информации о предмете/услуге, подсказкой.

К сожалению немного пользователей находит время для чтения инструкций Yamakawa M2150, и хорошая инструкция позволяет не только узнать ряд дополнительных функций приобретенного устройства, но и позволяет избежать возникновения большинства поломок.

Из чего должно состоять идеальное руководство по эксплуатации?

Прежде всего в инструкции Yamakawa M2150 должна находится:
- информация относительно технических данных устройства Yamakawa M2150
- название производителя и год производства оборудования Yamakawa M2150
- правила обслуживания, настройки и ухода за оборудованием Yamakawa M2150
- знаки безопасности и сертификаты, подтверждающие соответствие стандартам

Почему мы не читаем инструкций?

Как правило из-за нехватки времени и уверенности в отдельных функциональностях приобретенных устройств. К сожалению само подсоединение и запуск Yamakawa M2150 это слишком мало. Инструкция заключает ряд отдельных указаний, касающихся функциональности, принципов безопасности, способов ухода (даже то, какие средства стоит использовать), возможных поломок Yamakawa M2150 и способов решения проблем, возникающих во время использования. И наконец то, в инструкции можно найти адресные данные сайта Yamakawa, в случае отсутствия эффективности предлагаемых решений. Сейчас очень большой популярностью пользуются инструкции в форме интересных анимаций или видео материалов, которое лучше, чем брошюра воспринимаются пользователем. Такой вид инструкции позволяет пользователю просмотреть весь фильм, не пропуская спецификацию и сложные технические описания Yamakawa M2150, как это часто бывает в случае бумажной версии.

Почему стоит читать инструкции?

Прежде всего здесь мы найдем ответы касательно конструкции, возможностей устройства Yamakawa M2150, использования отдельных аксессуаров и ряд информации, позволяющей вполне использовать все функции и упрощения.

После удачной покупки оборудования/устройства стоит посвятить несколько минут для ознакомления с каждой частью инструкции Yamakawa M2150. Сейчас их старательно готовят или переводят, чтобы они были не только понятными для пользователя, но и чтобы выполняли свою основную информационно-поддерживающую функцию.

Содержание руководства

  • Страница 1

    Model : M2150 Instruction Manual Car Stereo Comp act Disc MP3/CD-RW/CD-R/CD SD/MMC USB Media Player with PL L FM S tereo Radio, Radio Dat a System (RDS) with PTY Det achable Front Panel System[...]

  • Страница 2

    Function MODEL : M2150 Car Stereo Comp act Disc MP 3/CD-R W/CD-R/CD SD/MMC USB Media Player with PLL FM S tereo Radio, Radio Dat a System with PTY Det achable Front Panel System FEA TURES z MP3/CD-RW/CD-R/CD Playback z The best st ations memor y automatically memorizes the best (strongest) st ation in the order their strength (AS) z MP3 files playb[...]

  • Страница 3

    Content Function …………………..………. 2 LCD display …………………….. 17 W arnings ………………………….. 4 Panel release button ………….. 17 Drawings ………………………….. 5 CD slot …………………………… 18 Location …………………………… 6 CD eject button …………………[...]

  • Страница 4

    Warnings The exclamation point within the tr iangle is a warning sign alerting the user of import ant instructions accom p anying the product. The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of volt age inside the unit. The reduce the risk of electric shock, do not remove the cover . No user servic[...]

  • Страница 5

    Drawings 5[...]

  • Страница 6

    Location LOCA TIONS OF CONTROLS 1. POWER ON/OFF 2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/ F ADER/T A SEEK/PI SOUND/RETUNEL/MASK DP/BEEP 2ND 3. VOL UP/VOL DOWN FOR BASS/TREBLE/BALANCE/F ADER (+,-) 4. PRESET ST A TIONS (1,2,3,4,5,6) 5. AF FUNCTION (AL TERNA TIVE FREQUENCIES) 6. T A FUNCTION (TRAFFIC ANNOUNCE MENT) 7. PTY FUNCTION (PROGRAM TYPE)[...]

  • Страница 7

    Installation INST ALLA TION PRECAUTIONS z Choose the mounting location careful ly so that the unit will not interfere with the normal drivin g functions of the driver . z A void inst alling the unit w here it woul d be subject to high temperatures, such as from direct sunlight or hot ai r from the heater , or where it would be subject to dust, dirt[...]

  • Страница 8

    Installation Det aching and attaching the front p anel The front p anel of this unit can be det ached in order to prevent the unit from being stolen. DET ACHING THE FRONT P ANEL Before det aching the front panel, be sure to press the PWR button to turn off the unit first. Then press the button and det ach th e panel by pulling it tow ards you as il[...]

  • Страница 9

    Installation ISO CONNECTOR RCA Jack Line Out(Rear)-Gray : Red (right) : White (lef t) CONNECTOR A 1. 2. 3. 4. MEMOR Y +12V 5. AUTO ANTENNA OUTPUT 6. 7. +12V (T O IGNITION KEY) 8. GROUND The connector A no.7 must be connected by car ignition key in order to avoid that car ba ttery becomes weak when the car will be not used for long period. CONNECTOR[...]

  • Страница 10

    Installation Maintenance FUSE REPLACEMENT If the fuse blows, check the pow er connection and replace the fuse. If the fuse blows again after the repl acement, there may be an internal malfunction. In this case, consul t your nearest rep airing centre. W arning Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause se[...]

  • Страница 11

    Operation OPERA TING INSTRUCTIONS 1. POWER ON/OFF By pressing this key (1), th e unit is switched on and off. This unit is turned on by pressing any key . 2. SELECT (SEL) 3. VOLUME KNOB Rot ate V ol ume up/down knob to control the OLUME to select other functions, press the SEL(2) button shortly until the desired function is shown on the display . F[...]

  • Страница 12

    Operation T A SEEK Model: When newly turned st ation does not receive TP information for 5 sec., the radio retunes to next st ati on w hich has not the same st ation(PI) as the last st ation, but has the TP information. In T A seek mode, the current st ation can be ch anged to the completely different st ation because the unit searches TP st at ion[...]

  • Страница 13

    Operation DEEP MODE(2) When press the SEL button for more than 2 seconds, it is activated as selecting mode of these functions, 4. PRESET ST A TIONS (1,2,3,4,5,6) (A) RADIO MODE: When press short, these keys select a preset station directly . When press longer than 1 sec., current st ation is stored in preset memory bank. When PTY mode s selected, [...]

  • Страница 14

    Operation USING THE RDS FUNCTION What is RDS? The RDS (Radio Dat a System) is a di git al information system developed by the EBU (European Broadcast Union). Piggy-backed on normal FM broadcast s, RDS offers a variety of information services and automatic retuning functions for RDS-comp atible car stereos. In 1988, RDS became available in the Unite[...]

  • Страница 15

    Operation -When the unit is in CD/MP3 mode, it w ill switch to radio mode temporarily . -If the volume level was under the thres hold point, it will be raised to the threshold point. -When TP st ation is received, TP segment is turned on in LCD display . 7. PTY function (PROGRAM TYPE) PTY MUSIC---PTY SPEECH---PTY OFF While selecting PTY type, it s [...]

  • Страница 16

    Operation 9. MODE BUTT ON (MD) By pressing this key , user can select RADIO mode or CD/MP3 PLA YER mode. 10. BAND / LUD BUTTON (BND/LUD) Each band is tollgled cyclically by pressing this key FM1-FM2-FM3. Press Loudness button shortly to increase Bass and T reble effects at low volume level. LOUD appears in the display . 1 1.12. AUT OMA TIC OR MANUA[...]

  • Страница 17

    Operation 13. AUTO SEEK SEARCH TUNING (A/PS) By pressing shortly , the radio searches for each preset station. When field strength level is bigger than the thres hold level of stop level, the radio is holding at that preset number for 5sec. With releasing mute, and then searches again. By pressing longer than 1 sec., and then 6 strongest st ations [...]

  • Страница 18

    Operation 16. CD SLOT 17. CD EJECT BUTTON Press the EJECT button(17) to remove the CD. 18. P AUSE BUTTON During PLA Y mode, press P AUSE button (18) to P AUSE. Press it again to resume play . 19. INTRO BUTTON (Preview all T racks) When this button (19) is presse d, INT indication is displaye d And the first several seconds of each track of the disc[...]

  • Страница 19

    Operation HOW TO S ELECT MP3 FILES Searching T rack Press A/PS, then searching track is activated. Rot ate the volume knob to select the song you want. Press SEL to confirm. Then automatically the song you selected will st art. Press SEL, then the song y ou selected will start. Digit al audio button assigned. BAND MP3 NA VIGA TION MODE SELECT 1 PLA[...]

  • Страница 20

    Specification SPECIFICA TIONS FM SECTION Frequency range 87.5-108.0MHz Channel step 50KHz Intermediate frequency 10.7MHz Sensitivity 2 V at 30dB S/N Stereo sep aration >30dB Signal to noise radio >60dB CD/MP3 PLA YER SECTION Signal to Noise Ratio >60dB Channel Sep aration >50dB(1KHz) Frequency Response 20Hz-20KHz LINE-OUT Output 350mV m[...]

  • Страница 21

    Trouble Shooting Before going through the check list, check wiring connection. If any of the problems persist af ter check list has been made, consu lt your nearest serv ice dealer . SYMPTOM CAUSE SOLUTION The car ignition switch is not on. If the power supply is properly connected to the car accessory circuits. But the engine is not moving. Switch[...]