Winegard TN-2055 инструкция обслуживания

Ver. 1.5 4/1/2009 - 1 - TravelNet Internet Only Cellular Router Installation Gu ide ATTENTION INSTALLER Parts List: • TravelNet Cellular Router (TN-2033, T N-2055) • 110 volt adapter with green connector • Edimax BR-6204W G WiFi Preconfigured Router • 110 volt adapter with plug connector • 3 foot Ethernet Cable • (2)External Antenna (wh[...]

Ver. 1.5 4/1/2009 - 2 - TravelNet’s Cellular Router System is Preconfigured And Ready to Install with these Easy Steps Installation Instructions: 1. Install the TravelNet Rout er and Edimax Router equipment i n a convenient place such as upper cabinet (Velcro works well on the base of th e each unit). Mount the unit so that the d iagnostic lights[...]

Ver. 1.5 4/1/2009 - 3 - Figure 2 Note that the antenna mount s are anchored to the 7” x 7” alumi num ground plane and that everything is well sealed. Figure 3 3. Insert the small end of th e cable through the ¾” diameter hole in t he stainless antenna mount and feed the cable th rough. Next screw the brass antenn a mount nut to the antenna m[...]

Ver. 1.5 4/1/2009 - 4 - Figure 4 4. Route the 2 antenna cab les to the cable entr y hole in the coach roof. Securel y attach the cable entr y c over over the cable entry point on t he coach roof using screws and caulk (Figure 6) Antenna cables sh ould be directed to the TravelNet R outer. Figure 5 5. Attach the 3 foot Ethernet cable to the Tr avelN[...]

Ver. 1.5 4/1/2009 - 5 - Figure 6 6. Carefull y attach the ant enna cables to the SMA Antenna Mount s on the TravelNet router. Caution should be taken to not over tighten the S MA cable connectors. Figure 7 7. Connect power supplies for both devices to AC source or 12 VDC source. When a 12 VDC source, order the appropri ate pigtail accessories and p[...]

Ver. 1.5 4/1/2009 - 6 - Figure 8 8. Check table below for LED status. Light Status LINK SVC LAN Off No Connect ion (IP address ) No Power No Connection On Green-- 1XRTT Connection Yellow Blinking-- No Signal (RSS I) Red-- Connected to LAN On Red— EV-DO Connection Yellow Solid— RSSI < -88 On Green Solid -- RSSI > -88 9. If you are activati[...]

Ver. 1.5 4/1/2009 - 7 - Activation I nstru ctions for model T N-2055 and TN-2 03 3 : ( Sprint TN-2033 users skip to page 9 ) Verizon TN-2055 Activation: 1. Connect an Ethernet Cab le directl y to the TravelNet Cellular Router and th e Laptop. 2. Enable the Local Area Network, when connected, go to the nex t step. 3. Open a web browser (Internet Ex [...]

Ver. 1.5 4/1/2009 - 8 - Figure 1 1 8. Click on the Over The Air Activation b utton. 9. If Network Stab ility is OK For Activation ( if Not Ok for Activation, wait 3 minutes.) If Not OK for Activation for 15 additio nal minutes, contact Support. 10. Click the Activate button. 11. Wait 3 minutes, th en check status. If still in progress, wait an addi[...]

Ver. 1.5 4/1/2009 - 9 - 19. Click on the Status- W ireless button, and verify that there is a Current IP address. This may take several minut es depending on the carrier network. Figure 1 3 20. Click on the Home button. 21. Click on the Restart button and confirm b y clicking the Restart butt on again, and wait 30 seconds. 22. Do a restart of all n[...]

Ver. 1.5 4/1/2009 - 10 - 5. Enter the user name ‘ctek ’ and password ‘ctek’ 6. Click the Log In button. 7. Click on the Activation but ton. 8. Click on the Over the Air Activ ation button Figure 1 6 9. If Network Stabilit y is Ok for Activation then go to step 9, i f Not Ok, then wait 3 minutes. If still Not Ok, call support. Figure 1 7 10.[...]

Ver. 1.5 4/1/2009 - 11 - Figure 1 8 15. At the bottom of the page, click the Update butt on. 16. Ok, then click the Home button. 17. Click on the Restart button and confirm b y clicking the Restart butt on again, and wait 30 seconds. Figure 1 9 18. Click on the Home button. 19. Click the Status- Wi reless button, verify that there is a Current IP a[...]

Ver. 1.5 4/1/2009 - 12 - Figure 20 WEP Ke y Setup Figure 2 1 1. Log into the E dimax WiFi Ro uter at 192. 168.2.1 2. Enter the Username ‘admin’ an d Password ‘1234’ 3. Go to W IRELESS SETTINGS > SECURIT Y 4. Encryption t ype: select WEP 5. Key Length : 64-bit 6. Key Format : Hex (10 Characters ) 7. Default T x Key: Key 1 . 8. Encryption [...]

Ver. 1.5 4/1/2009 - 13 - Figure 22 WEP Key Set up Parameters Default Description Key Length 64-bit You can select the W EP key length f or encryption, 64-bit or 128 -bit. Larger W EP key length re quires 26 hexadecimal c haracters Key Format Use hexade cimal digits (in the "A-F", "a-f" and "0-9" range) to be the W EP K[...]

Ver. 1.5 4/1/2009 - 14 - To connect your X P comput er to your wi reless netw ork Configuring the Windows XP Wireless Clients (With WEP) Configuration of the Wi ndows XP wireless clients for WEP key authenticat ion depends on whether you are usin g Windows XP wit h SP2 or Windows XP with SP1 and whether the wireless network adapt er driver supports[...]

Ver. 1.5 4/1/2009 - 15 - To connect your Windows Vista computer to your wireless network Vie w and connect to available w irel ess netw orks Applies to all editio ns of Windows Vist a. If you have a mobile PC, you can see a list of available wireless netwo rks, and then connect to one of those n etworks, no matter where you are. The wireless networ[...]

Ver. 1.5 4/1/2009 - 16 - QUESTIONS? CA LL OUR SUPPORT LINE: 877-47 5-7771 or visit our website FAQ a t http://www.winegard.com TravelNet Winega rd Company Support: (87 7) 475-7771 FAX: 847-9 91-3328[...]