Windster RA.3130/3136 инструкция обслуживания

WINi:JS're~TM MODEL: RA.3030/3036 RA.3130/3136 OPERATION MANUAL c@~s 230302 Please read and save this guide through before using your range hood Store the guide away in a safe place so that you will know where it is. when you want to refer to it.[...]

A. Important Safety Instructions Read and Save These Instructions CAUTION- To reduce risk of fire and to properly exhaust air. be sure to duct air outside- Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. WARNING- To reduce the risk of fire or electric shock. do not use this fan with any solid- [...]

WARNING- To reduce the risk of injury to persons in the event of a range top grease fire. observe the following: A- SMOTHER FLAMES with a close- fitting lid. cookie sheet. or metal tray, then turn off the burner. Be careful to preven burns. If the flames do not go out immediately, EVACUATE AND CALL THEFIRE DEPARTMENT. B- NEVER PICK UP A FLAMING PAN[...]

B. Safety Notes 1. All electrical work must be done in accordance with local and/or national electrical code as applicable for safety. This product must be grounded if your are unfamiliar with methods of installing electrical wiring, secure the services of a qualified electrician. 2. Turn off power at service entrance before installing wiring or se[...]

c. Tools and Materials Required ~ Drill. electric of ratchet drive. with 3/16" wood bit (for drilling starter holes and 1 ¥4 "wood bit (to drill an access holes in the cabinet or kitchen wall for the electric power line) ~ One common screwdriver. ~ Plier (for opening electrical knockout). ~ Two 1" (thick)x2" (wide)x12" (ap[...]

E. Preparing The Range Hood 1. Remove the top electrical knockout. you may plan to bring power to the range hood either through the cabinet or through the wall (Fig.1) ~"~I Knooko", ~~~ ~ Fig. 2. Insert a screwdriver into the knockout slot and bend the knockou back and forth. (Fig.2) You may have to use pliers to pull the loosened knockou[...]

F. Preparing The Installation Location Note: Please also refer P.11 "J. Making the Electrical Connection' 1. A. If you want to move the electric range to make room for working on the cabinet turn off the 220 volt power for the electric range at the service entrance. B. Before moving a gas range. shut off the gas. Note: Omit steps 2a throu[...]

4. Screw the four 1" wood screws (tor mounting the hood) into the exact center of the arrow and of the keyhole mounting slots marked on the cabinet bottom (for flush installations), or marked on the 1 "x2" wood strips (tor recessed cabinet installation) (Fig.7) Do not turn the mounting screws in all the way. Allow 3/8" of screw [...]

Wiring to power supply & SAFETY WARNING RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHE[...]

H. Mounting Range Hood To Cabinet Note: Please also refer P.11 "J. Making the Electrical Connection' 1. Position the hood in place so that: a. The electrical line is routed through the appropriate Knockout opening. This step will have to be accomplished while positioning the hood (Fig.1 0) b. The large part of the keyhole mounting slots o[...]

I. Mounting Range Hood Without Cabinet Note: Please also refer P.1 0 "J. Making the Electrical Connection' 1. Using metal brackets and screws (included), center hood onto board and install screw. 2. Remove the hood from the board and nail the wood board onto the wall. (Be sure the nail is in the center of the stud) 3. Place the range hood[...]

J. Making the Electrical Connection 1. Turn the six nuts at the front/back of bottom board. ( Fig.13) 2. Remove screws on wiring case. fish out wires through the knockout. (Fig.13) screw Fig.! 3. Mark the electrical connection by fastening all wires to the existing wall wiring according to the their colors. (Black to Black, White to White. Green to[...]

K. Use and Care Operate switches (Fig.9) ABC 0 I I I .... Switch A: I e I ON I OFF I DELAY Fig.9 "ON" - When the hood is "OFF", turn on the blower by press" . button once the blower will operate at second speed and LED light indicate "2", "OFF" - During operation, contiune to press" . "button t[...]

L. Halogen light replacement Note: The halogen light will be very hot when it is working Never touch it with bare hand(s). Before changing halogen light ensure the unit is switched off and the halogen light is cool. ~q B Q Note: Ensure the unit is switched off. Before changing lamp. A. Using suitable tool (small screw driver) gently pry off the lam[...]

M. Maintenance Instruction 1. Maintenance shall be important than repair. Please take care of the needed maintenance in order to secure and extend the excellent functions and using life. Note: Before repairing the range hood. Disconnect the power source. 2. After using the machine. wipes the machine by neutral detergent in order to keep it clean an[...]

o. Parts Layout Diagram 15 ~~ -15- 1 Machine body 7 Chamber 13 Safety mesh 2 Control switch 8 Motor 14 Oilcollector (round) 3 Halogen light 9 Fan 15 Hanging bracket 4 Transformer 10 Oiltunnel 16 Inner ductcoyer (optional) 5 Capacitor 11 Bottom board 17 Outer duct coyer (optional) 6 I Capacitor bracket 12 Oilcollector (oval) 18 Duct coyer-mounting b[...]

P. Circuit Diagram NOTE: Any faults with this unit should only be attended to by a qualifiec technician. G)§@@ -16-[...]

Q. Size o Model: RA-3030 / RA-3036 o Model: RA-3130 / RA-3136 / RA-3142 / RA-314E -17-[...]