Whirlpool RJE-363P инструкция обслуживания

01 304NCH FREE-STANDING ELECTRIC RANGE Model RJE-363P Control Panel Bake Element Air-Flow Oven n-m- Model and Serial Number Plate Automatic Oven Light Switch 5torage Drawer. [...]

I I I’ Oven Signal Light Lock Light Clean Light Oven Temperature Control Knob Oven Selector Knob Table of Contents YOUR RESPONSIBILITIES ........................... USING THE SURFACE UNIT CONTROLS .............. USING THE OVEN CONTROLS ....................... l Baking.. ......................................... l Broiling ........................[...]

Surface Unit Signal Light I Oven Light Switch Surface Unit Control Knobs Minute Timer Start Time Knob Surface Unit Indicators Your responsibilities . 1s colllwcted 011ly to the rqht k~nti of outlet. u,ith the 11yht electric wppl~ illid yrouldlrig (see “Irlsrallatlorl I:istructionb. I l IL uwd 01ily for jobs expected of home I-ally25 l 15 c~)ut [...]

I I I’ PUSH IN and turn to setting. To bake, turn the Oven Selector Knob to BAKE. To broil, turn the Oven Selector Knob to BROIL. Using the surface unit controls Surface Unit Control Knobs must be pushed in before turning. Turn either way to the setting you want. A design by each knob tells which unit is turned on by that knob. (For example, [::I[...]

ALWAYS broil with the door open about 4 inches (10 cm). screw; NOTICE positioi of notches. Lower: move black part toward “LO.” One notch equals about 10°F (5°C). “4 Higher: move black part toward “HI.” One notch equals about 10°F (5°C). The following chart suggests broiling times and oven-rack po- sitions for different kinds of meat[...]

Setting the clock to the correct time of day 1. Push in the Minute Timer Knob and turn it clockwise to set the hands to the correct time of day. 2. The Minute Timer hand will turn as you set the clock. When the clock Clock and Timer Knob is set, let the knob pop out. Then, while it is out, turn the Minute Timer hand clockwise to “OFF” If you pu[...]

3. Push in and turn the Start Time Knob clockwise to the time you want the oven to start. 4. Push in and turn the Stop Time Knob clockwise to the time you want the oven to shut off. 5. Turn the Oven Temperature Control Knob to the temper- ature you want to use to cook the food. 6. Set the Oven Selector to “TIMED.” When cooking is finished, turn[...]

To remove rack, pull forward until rack stops, lift front and pull. To replace the oven light, remove glass cover. I 1 1 Oven rack positions Your oven has two racks. Always put the racks where you want them to be before you turn on the oven. To remove a rack, take hold of it on the front edge and pull it out .mtil it stops. Then lift up the front e[...]

The optional rotisserie If you would like a rotisserie with your oven. you can order a kit (Part No 2618811 from your dealer. Easy installation instructions come with the kit. Accessory canning kit (Part No. 242905) The large diameter of most water-bath or pressure canners com- bined with high heat settings for long periods of time can shorten the [...]

Setting the controls to the Self-Cleaning cycle: 1. Set the Oven Selector Knob to “CLEAN.” c J 3. The clock and dials for start and stop time should all have the right time of day. 5. Lock the oven door by moving the Lock Lever all the way to the right. When it is all the way over, the Clean Light will come on. If the Clean Light doesn’t come[...]

7. When the oven has cooled ojf all the way, wipe out any residue or ashes from the bottom. How the Self-Cleaning cycle works: l When oven controls are set to “CLEAN.” the oven gets much hotter than it does for cooking. This high heat causes so11 on the inside oven walls to burn off. or break up and mostly disappear. While this is happening, a [...]

Special tips: l If the cleaning cycle doesn’t get the oven as clean as it should be, the time set for cleaning was probably not long enough. Set the cleaning time longer next time. You can set it for more than 3 hours, if you want. l Plan to clean the oven before it gets too heavily soiled. Other- wise, you may notice more smoke than you would ex[...]

Removing surface units and reflector bowls: 1. First, be sure the Surface Unit Controls are all “OFF” and that the surface units are cool. 2. Lift each surface unit about an inch (2.5 cm) at the edge away from the plug-in (receptacle). Pull the unit straight away from the plug-in. Do not luash surjace units: they will burn themselves clean duri[...]

PART WHAT TO USE HOW TO CLEAN Outside of appliance Soft cloth, warm soapy water l Wipe off regularly when range is cool. Nylon or plastic scouring pad l Do not allow food containing acids (such as for stubborn spots vinegar, tomato, lemon juice or milk) to remain on surface. Acids will remove the glossy finish. l Do not use abrasive or harsh cleans[...]

IF YOU NEED SERVICE OR ASSISTANCE, WE SUGGEST YOU FOLLOW THESE FOUR STEPS: 1. Before calling for assistance.. _ Performance problems often result from little things you can find and fix yourself without tools of any kind. If nothing operates: l Is the range plugged into an operating outlet or wired into a live circuit with the proper voltage? (See [...]

2. If you need assistance*. . . Call the Whirlpool COOL-LINE” service assistance tele- phone number. Dial free from: Continental U.S. . . . . . . . . . . . . . . . . . . . . . . . . . . . (800) 253-1301 Michigan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (800) 632-2243 Alaska & Hawaii . . . . . . . . . . . . . . . . .[...]