Wharfedale S2500 инструкция обслуживания

PROFESSIONAL POWER AMPLIFIERS Power Protect Bridge Peak A Peak B Professio nal Amplifie r Signal CH. B CH. A 2 8 3 7 1 9 4 6 0 10 5 2 8 3 7 1 9 4 6 0 10 5 Signal[...]

TABLE OF CONTENTS PAGE 1. FRONT AND REAR PAN EL REFERENCE DRAWINGS 2. WARNINGS AND WARRANTY INFORMATION 3. INTRODU CTION 4. GETTING STARTED 5. FRONT PANEL FEATURES AND CONTROLS 6. REAR PANEL FEATURES AND CONTROLS 7. INPUT “A” AND “B” MODE SWITCHES 8. MODE SWITCH OPERATION 9. OUTPUT “A” AND “B” WIRING OPTIONS 10. USING OUTPUT “A”[...]

+ 1+ 1- POS NEG OUTPUT B 1+ 2+ POS NE G BRIDGED M ONO 2+ 2- POS NE G 1+ 1- OUTPUT A OUTPUT B OUTPUT A OUTPUT B BRIDGED MONO A + _ B BRIDGED + _ _ SLEEVE = GROUND SHIELD MODEL S-SERIES Professional Power Am plifier WWW.WHARFEDALEPRO .COM POWER BREAKER CAUTION 2= HOT (+ ) XL R ¼” 1= GROUND SHIE LD 3= COLD (- ) TIP=HOT(+) RING=COLD( -) AC 100V-120V[...]

WARNINGS AND WARRANTY INFORMATION Unpacking: All Wh arfedale Pro pr oducts are fully tested b efore leaving the factor y. After unpacking , please i nspect the unit . In the event of any noticed damage du e to shipping, cont act your dealer and the shippin g provider immedia tely to file a shipping damage claim. Reta in the shipping carton an d all[...]

3 Introduction Thank you for your purchase of a Wharfedale Pro S-Series professional power amplifier. Please read this manual completely to ensure proper operation and complete understanding of the features of these products. The Wharfedale Pro S-Series power amplifiers are designed for ea se of use, and quality audio performance in portable sound [...]

Getting Started 1. AC Power Connections All S-Series power amplifiers are equip ped with an internal AC power supply. Connect the appropriate grounded IEC power cable to the power amp BEFORE connecting it to the power outlet. It is important to allow adequate ventilation to the powered amplifier a s it may become warm during extended periods of ope[...]

FRONT PANEL - FEATURES AND CONTROLS 1. Power switch: Push to turn powe r on or off. 2. Power On LED: Th is LED lights when the power is on for the amplifier. 3. Protect LED: This LED will light up when a fault is detected in the amplifier operation. 4. Bridge LED: This LED lights up when the amplifier is set to BRIDGED mode. 5. Peak A LED: This LED[...]

6 REAR PANEL – FEATURES AND CONTROLS 1. INPUT “A” XLR and ¼” Ba lanced Line Input jacks: These XLR inputs are balanced input jacks and ¼” TRS (Tip / Ring / Sleeve) balanced / unbala nced inputs. These jacks are designed to b e connected to +4dBu ba lanced or unbalan ced line level so urces. 2 . INPUT “B” XLR and ¼” Balanced Line [...]

INPUT A & B MODE SWITCHE S The MODE SWITCHES for the S-2500 provide the means to configure the amplifier in f or a variety of different applications. The following legend shows the available s elections. 7 Switch 1: is not used INPUT A Switch 2: Engages the signal LIMITE R in the ON (up) position and dis engages it when OFF (do wn). Switch 3: S[...]

MODE SWITCH OPERATION LIMITER A limiter is a circuit that prevents signal over load and distortion in an audio s ignal path. When engaged, the internal limiter circ uit will keep the audio signal from going over a preset level threshold, thereby helping to prevent signal d istortion within th e amp lifier and in the speaker system. The limiter also[...]

OUTPUT “ A ” AND “ B ” WIRING OPTIONS Output wiring options consist of NL-4 “Speak on®-type” female connecto rs for the left and right o utputs along with industry standard binding posts for dire ct wiring conn ections or wiring with banana plugs. 9 NL-4 CONNECTOR WIRING OUTPUT “ A ”& “ B ” FULL RANGE: FULL RANGE 1+ = POSIT[...]

USING OUTPUT JACK “ A ” NL-4 FOR BOTH OUTPUTS 10 BRIDGED-MONO MODE NL-4 WIRING * : FULL RANGE SHARED OUTPUT 1+ = POSITIVE - OUTPUT A 1 - = NEGATIVE - OUTPUT A 2+ = POSITIVE - OUTPUT B 2 - = NEGATIVE - OUTPUT B BRIDGED MODE 1+ = POSITIVE 2+ = NEGATIVE USING OUTPUT “A” NL-4 S-SERIES Professional Amplifiers Positive lead from OUTPUT A Negative[...]

BINDING POST WIRING OPTIONS 11 As shown in the graph ic above, the stereo and bridged mono a pplications can be connected as indicated. Binding post wiring can be do ne with spade connectors, bare wire ends tightened into the binding posts or via banana plugs inserted into the e nd of the binding pos ts. BRIDGE CONNECTING BARE ENDED SPEAKER CABLE L[...]

NEGATIVE LEAD TO SPEAKER POSITIVE LEAD TO SPEAKER 12 CONNECTING SPEAKER C ABLE WITH SPADE LUGS CONNECTING SPEAKER CA BLE WITH BANANA PLUGS NEGATIVE LEAD TO SPEAKER POSITIVE LEAD TO SPEAKER S-SERIES Professional Amplifiers + _ A + _ A[...]

BRIDGED MONO NEGATIVE LEAD TO SPEAKER POSITIVE LEAD TO SPEAKER CONNECTING SPEAKER CAB LE BRIDGED-MO NO 13 BRIDGE S-SERIES Professional Amplifiers + _ A + _ B B + _ BRIDGED-MONO MODE REQUIRES SWITCH #10, #11 & #12 TO BE IN THE “UP” (ON) POSITION MODE SWITCHES ON 1 2 3 4 5 6 7 8 9 101112[...]

GENERAL OPERATING INSTRUCTIONS Make sure that the power switch is set to t he OFF position while making conne ctions to and from the power amplifier. Connect all external com ponents. Speakers, Microphones , instruments , etc. Check for secure connections. Turn all level controls down on mixers, amplifiers and signal processing devices. Connect the[...]

15 S-SERIES Professional Amplifiers S -10 0 0 SP E C IF ICA T ION S Out put P ow e r S t e re o: B rid ge d: THD + N Fre que ncy Re s pons e H um a nd N oi s e V ol ta ge Ga i n I nput S e ns i tivi ty Ma x i m um I np ut Le ve l I nput I m pe da nce C ontrols Lo w C ut Fil t er : S I GN AL I ndic ators: C LI P ind i c at or s : Limit er : A mplif [...]

16 S-SERIES Professional Amplifiers S -15 0 0 S PE CIF ICA T ION S Output P ow e r S te re o: B ridg e d: THD + N Fre que ncy Re s pons e H um a nd Nois e V ol ta ge Ga i n I nput S e ns i tivi ty Ma x i m um I n put Le ve l I nput I m pe da n ce C ontrols Lo w Cu t Filt er : SIG N A L I ndic ator s : C LI P i nd ic ators: Limit er: Am plif i er P [...]

17 S-SERIES Professional Amplifiers S -25 0 0 SP EC IF ICA T ION S Output P ow e r S te re o: B rid ge d: THD + N Fre que ncy Re s pon s e H um a nd N oi s e V ol ta ge Ga i n I nput S e ns i tivi ty Ma x i m um I np ut Le ve l I nput I m pe da nce C ontrols Lo w Cut Fil t er : SIG N AL I ndic ator s : C LI P i nd ic ators: Limit er : Am plif i er [...]

Wharfedale International LTD. IAG HOUSE Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE29 6XU, England www.wharfedalepro.com IAG Professional reserve s the right to al ter or improve specifi cations without notice. All rights rese rved © 2007 Wharfeda le Pro Wharfedale Pro is a member of the Interna tional Audio Group[...]