United States Stove 6037 инструкция обслуживания

USSC 1 851595 CORN & PELLET MUL TIFUEL ST OVE 6037 OWNER’S MANUAL Installation - Operation - Maintenance Instructions - Repair Parts READ THIS ENTIRE MANUAL , THOROUGHL Y , BEFORE A T TEMPTING TO INST ALL AND/OR BURN YOUR NEW AMERICAN HARVEST CORN AND PELLET MUL TI-FUEL ST OVE. F AILURE T O FOLLOW THESE INSTRUCTIONS MA Y RESUL T IN PROPERTY D[...]

2 USSC SPECIFICATIONS United States Stove Company ( manufacturer of the American Harvest Multifuel Pellet Stove ) reserves the right to alter products, specifications and price without notice. Safety T ested & Listed to ASTM- E 1509, ULC -C 1482, (UM) 84-HUD, by OMNI T est Laboratories, Inc. , B ea verton, Oregon USA NOTE: YOUR UNIT MUST BE INS[...]

USSC 3 Ashes will have to be Remov ed from the stove periodically . See cleaning procedure. Y ou can minimize cleaning required and maximize efficiency by maintaining the correct draft settings. See “Setting the Draft” further in the manual. The draft setting on your stove may have to be changed from time to time to accommodate your specific bu[...]

4 USSC FLOOR PROTECTION The American Harvest Multifuel Stove may be installed on a combustible floor , with proper floor protection, or on a masonry hearth. The hearth or noncombustible floor protector must extend a minimum of (6) inches (152mm)in front and (6) inches (152mm) from each side of the ash remo val door . INSTALLATION REQUIREMENTS SHELL[...]

USSC 5 CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches (152mm). PARA[...]

6 USSC NOTE: These are guidelines only. Proper venting is accomplished by design and common sense. In most installations 3” inch diameter venting is adequate. If it does not vent properly you will have to change it to 4”. DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN • • • • • • [...]

USSC 7 For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air . Connection to outside the house is REQUIRED for mobile home installations. W e strongly urge us[...]

8 USSC Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA -B365 The American Harvest Corn/Pellet Stove Model 6037 may be installed as follows: 1) A freestanding unit MOBILE HOME INSTALLATION REQUIREMENTS IN ADDITION TO THE STANDARD INSTALLATION INSTRUCTION, THE FOLLOWIN[...]

USSC 9 Locate proper position f or the type “PL ” wall thimble (F). Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole. The size of hole opening will vary with brand of wall thimble. P osition stove approximat[...]

10 USSC T ermination Cap Fresh Air Intake (Optional 67F AK) With 90 Degree Elbow or Hood (Pest Guard, 3/8” Mesh Maximum) Clean Out Cover Te e Wall Thimble 6” Min. Non Combustible Hearth Plate Support Bracket 9” Min. THROUGH THE WALL, VER TICAL PIPE INST ALLA TION WITH TERMINA TION CAP The Hearth Pad is not required under the unit if the floor[...]

USSC 11 Y our American Harvest Corn/Pellet Stove comes to you with the glass door installed in place, ready f or use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (4) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges. If the door is tight, tap ge[...]

12 USSC STOVE CONTROLS Adjustable Door Handle lifts up and turns left to open. Ash Dump Shutoff Pull out to empty ashes out of the firebox area. Make sure to push all the way in when done. Front View Left/Front View Circuit Board Control Panel Manual Draft Adjustment Slide in or out to adjust the amount of draft flowing through the firebox. Service[...]

USSC 13 LIGHTING INSTRUCTIONS CAUTION: DO N OT USE CHEMICALS OR FLUIDS TO ST ART THE FIRE HOT WHILE IN OPERA TION. KEEP CHILDREN, CLO THING AND FURNITURE AW AY . CONT ACT MA Y CAUSE SKIN BURNS. • • • • • • • • • • • • Before lighting your American Harvest for the first time, make sure that all items are out of the hopper , a[...]

14 USSC SETTING THE DRAFT A proper draft setting is crucial to the successful burning of solid fuels. Draft refers to the amount of air flowing through the burn chamber of your stov e. T oo much or too lit tle draft will cause your stove to burn improperly and may r esult in the fire burning out or excessive deposits (clinkers). Please follow these[...]

USSC 15 The 6037 has (2) front cleanout slides that must be in the closed position when burning the unit. • • • • • Set the stove on high fire. Open the draft to 100% and allow the stove to burn for 15 minutes. Resume desired heat and draft setting. Shut down the stove as directed in the operating instructions. Allow the stove to cool to [...]

16 USSC FUEL ADDITIVE Chicken Scratch for my Corn Burner? Y es - Cr azy as it may sound, ground Oyster Shells, (calcium carbonate) same as fed to chickens, is the ideal additiv e to promote clean burning, especially when the Corn Fuel is extra high in starch. And it’s available at your local Feed and Seed. The “aver age” mixture is 1/2 pound [...]

USSC 17 COMPONENT OPERA TION ST ART OPERA TION END CIRCUIT BOARD FUNCTIONS ST ART -UP SEQUENCE OF EVENTS Once the control panel is turned to one of the five heat settings, a timer begins that will start, stop and continue operation of the American Harvest as a preset temperature is achieved. Exhaust Blower Agitator Auger Room Fan Automatic Shutdown[...]

18 USSC Exhaust Blower Agitator Auger Room Fan Automatic Shutdown COMPONENT SHUTDOWN OPERA TION END CIRCUIT BOARD FUNCTIONS continued... SHUTDOWN SEQUENCE OF EVENTS Once the AMERICAN HARVEST has reached the normal operating temperature and switched to the “OFF” position, the unit will continue to operate on a much lower setting for 10 minutes. [...]

USSC 19 TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: T oo rich air/fuel mixture ? Fire burns with a lazy , orange flame and/or fuel builds up in the firepot. Glass may become dirty . ? Fire goes out or stove shuts down. Fuel may stop feeding. ? Fire goes out or stove shuts down. Fuel may stop feeding. Increase air [...]

20 USSC WIRING DIAGRAM[...]

USSC 21 REPAIR PARTS DIAGRAM-6037 45[...]

22 USSC K EY PAR T # DESCRIPTION QTY. 1 69437B Ash Pan Guide Assy . , P ainted 1 2 25309B Pedestal, Painted 1 3 25158B P edestal T rim, P ainted 1 4 25317B Pedestal Back, Painted 1 5 69364B Ash Pan, Painted 1 6 69443 Hopper Assembly 1 7 891118 Safety Guard 1 8 25315B Cabinet T op, P ainted 1 9 25316B Hopper Lid, Painted 1 10 89899 Br ass Knob 2 11 [...]

USSC 23 Notes[...]

24 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND- ABLE SERVICE FROM YOUR AMERICAN HARVEST, AND EN- ABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER- ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBER WHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER. WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE [...]