Toro FLX34 инструкция обслуживания

Introduction The FLX34 and FLX54 series full-circle rotary sprinklers are designed specifically for golf course applications. Manufactured from durable, high-strength engineering plastic and stainless-steel components, these sprinklers incorporate many innovative and time-proven features for lasting, maintenance-free operation. Prior to installing [...]

Nozzle Performance Chart FLX34 Series Performance Chart—25° Front Nozzle Positions Nozzle Set 31 (Yellow) Nozzle Set 32 (Blue) Nozzle Set 33 (Brown) Nozzle Set 34 (Orange) Nozzle Set 35 (Green) Nozzle Set 36 (Gray) Nozzle Set 37 (Black) 102-0725 102-7001 102-0727 102-7002 102-6908 102-0730 102-4261 Red Plug Red Plug Red Plug Red Plug Red Plug Re[...]

Precipitation Rate Formulas • Square-spaced sprinklers in pattern: GPM of full circle x 96.3 (Spacing) 2 • Triangular-spaced sprinklers in pattern: GPM of full circle x 96.3 (Spacing) 2 (0.866) • Area and flow: Total GPM of zone x 96.3 Total irrigated Square feet of zone • Single row: GPM of full circle x 96.3 (Spacing) (Scallop) Sprinkler [...]

Connecting Hydraulic Control Tubing Step 1 – Route control tubing from the controller to the sprinkler location(s). Note: Leave an 18" (45.7 cm) service loop of tubing at each sprinkler to facilitate movement of sprinkler and service operations. Refer to Hydraulic Control Systems Table for tubing run length and sprinkler elevation informatio[...]

Winterization Winterizing the irrigation system is required in freezing climates to prevent damage from water expansion when it freezes. Following are three key points for successfully winterizing the system, however, Toro provides a complete “Winterization and Pressurization Guide” (P/N 373-0849) that is available from your local Toro Distribu[...]

Pilot Valve Operation (Electric Models Only) The pilot valve controls the operation of the main valve located in the base of the sprinkler body. The main valve is operated by the release of water metered through the pilot valve when it is activated either manually at the sprinkler or by the irrigation system controller. Another important function o[...]

Valve won’t close (Hydraulic) – Leak in control tubing • Isolate and repair – Pilot valve leak in controller • Confirm by observing constant dripping from discharge line of controller. Refer to Controller Service Manual – Valve cylinder misaligned with sprinkler body communication tube • Remove valve assembly and install correctly –[...]

Servicing Procedures The FLX34 and FLX54 series sprinklers are designed to provide the user trouble-free operation for many years without scheduled maintenance. If it becomes necessary to disassemble the sprinkler to correct a malfunction or replace a component, all internal parts of the sprinkler can be accessed from the top. Refer to the Troubles[...]

Servicing Main Valve WARNING! If the valve snap ring is difficult to remove, residual water pressure may be remaining in the system. To prevent possible serious injury due to valve being ejected upward under pressure, confirm the following conditions exist prior to removing the snap ring and valve. A. Water supply to sprinkler is shut off at source[...]

Servicing Pilot Valve WARNING! Never stand or lean over the sprinkler while the irrigation system is being filled, during manual or automatic operation or when performing sprinkler service procedures. Direct contact with irrigation spray, a failed or improperly installed sprinkler connection or sprinkler components forcibly ejected upward under pre[...]

NOTES:[...]

NOTES: © 2015 • The Toro Company, Irrigation Division • www.toro.com Form Number 373-0858 Rev. A[...]