Strong Pools and Spas RIO Rotational Molded resin whirlpool spa инструкция обслуживания

OWNER’S MANUAL P .O. Box 108 Northumberland, P A 17857 1-800-STRONG-9 1-800-787-6649 ™ 1/9/07 CAUTION: More than one GFCI used on the electrical circuit will render this spa inoperable. This spa must be on a dedicated circuit.[...]

T able of Contents Introduction ................................................................................................................................. 1 Safety Instructions ............................................................................................................ .......... 2 Installation Instructions ..................[...]

1 Introduction The Rio Spa Please use this space to record the pertinent information about your new spa here: Date of Purchase: ________/________/_______ Color: _________________________________ Serial #  Y our Strong Spas Spa Serial Number is located on the Control Pack box panel. Congratulations on your purchase o[...]

2 W ARNING People with infectious diseases should not use a spa. The use of alcohol, drugs or medication before or during spa use may lead to uncon- sciousness with the possibility of drowning. Do Not use the spa immediately following strenuous exercise. Persons suffering from heart disease, diabetes, high or low blood pressure or any other serious[...]

3 Spa Location: Improper installation may result in equipment damage and will void the warranty . Y our spa must be placed on a flat, level surface. The space you choose to install your spa is a very important decision, you should consider all of the listed suggestions. Check your local code office for understanding of building, fencing, gates, ele[...]

4 Connections should be made using copper conductors only . The connecting wire and circuit breakers or fuses must be sized to accommodate the total ampere load as specified on the equipment module data label. Strong Pools and Spas only makes electrical recommendations, always consult a certified electrician. It is recommended that a licensed elect[...]

5 Control Panel Identification There are FOUR unions that may require hand tightening prior to operation of your spa. When filling the spa with water , keep observing these fittings for any slight water drips. If a drip is observed, just hand tighten until dripping ceases. BEFORE ST ART UP! IMPOR T ANT UNION ADJUSTMENTS Jets T ouch the “Jets” b[...]

6 Startup Preparations - Make sure that if spa is equipped with gate valves, that valves are opened. (Usually found in the Rio spas, these gate valves are easily noticed in your access area by the distinct “T” shaped handle.) - When filling your spa remove the filter , and place hose into filter area.This will fill the plumb- ing first, and hop[...]

7 Changing Filter Cycles T roubleshooting No power to spa: 1. Check for power at outlet 2. Check reset on GFCI cord (Press test then reset) 3. Check proper connection of cord to pack 4. Check fuse in pack (.5A 250 V UDL slow blow) the thicker wire of the two fuses. 5. Must have very good ground connection - If none call tech support T rips Breaker:[...]

8 T roubleshooting Poor W ater Flow: 1. Clean filter 2. Check if adjustable jets (are all open) 3. May have air lock, prime pump by loosening top pump union. 4. If water diverted valves are present make sure they are all the way open. 5. If gate valves are present, make sure they are all the way open. 6. If none of this works possible line obstruct[...]

9 Spa Maintenance The maintenance and care of your spa is simple and easy to carry out, and if performed regu- larly as scheduled, problems will be minimal. It is important that the following procedures be read through and carried out on a regular basis for the best, long term, overall performance of your spa. The filtering cycle of your spa should[...]

10 CONCENTRA TED CHLORINA TING GRANULES - The minimum chlorine level in the spa should be at least 2PPM (parts per million). Chlorine level should be tested frequently and the chemical added to maintain a safe level of 2PPM. This type of chemical can be added in quantities of 0.5 ounce per 500 gallons of spa water . Check the chlorine level at leas[...]

11 Jet 2” Jets, V alves, Injection and Suction T op Air Control V alve (Air Control V alve should be turned off when spa is not in use. The spa will heat up faster .) Bottom Suction T u r n c o u n t e r c l o c k w i s e t o o p e n[...]

12 For current update changes on warranties, consult our website at www .strongspas.com W ARRANTIES Shell: Lifetime Plumbing: 1 year Strong Spas warrants the original retail purchaser the integrity of the spas plumbing against leaks as a result of defects in material or workmanship for a period of 1 years. (parts and labor) Stainless jets - all jet[...]

13 FOR YOUR RECORDS: For future use, it is advisable that you write down some information pertaining to the model of the spa you have purchased. If you are unsure of the model name, frame size, etc., contact your dealer immediately to acquire the information needed. When making a warranty claim or just purchasing replacement parts, it is necessary [...]

RET AIN THIS BOOKLET FOR FUTURE REFERENCE: FOR ANY MISSING P ARTS, PROBLEMS OR QUESTIONS CALL: MONDA Y THROUGH FRIDA Y 8:30 AM - 5:00 PM E.S.T . (570) 275-2700 • GIVE YOUR NAME • TELEPHONE NUMBER (AREA CODE) • NAME OF SP A • NAME OF MODEL • QUANTITY AND TYPE OF P ARTS • REASON FOR REQUEST A. DAMAGED B. DEFECTIVE PLACE ST AMP HERE STRONG[...]