Smeg SE435XT инструкция обслуживания

Dear Customer, Thank you for having purchased one of our products. We are certain that this new, modern, functional and practical appliance, built with the very highest quality materials, will meet your requirements in the best possible way. This hob is easy to use. It is, however, important to thoroughly read the instructions in this handbook in o[...]

2 1 Normal plate Ø 145 of 1000 W 2 Normal plate Ø 180 of 1500 W 7 Control knob for electric plate n° 1 8 Control knob for electric plate n° 2 13 Warning light indicating that one or more plates are operating DESCRIPTION OF THE HOT PLATES TYPE: PAZ 04[...]

3 USE 1) SWITCHING ON THE ELECTRIC PLATES The hobs may be equipped with three types of electric plates: normal, thermostat and rapid plates indicated by a red mark. The normal plates and the rapid plates are controlled by a 7 - position switch (see fig. 1). The thermostat plates are controlled by 12 - position switch (see fig. 2). Switch on the pla[...]

4 USE WARNINGS: When the plate is switched on for the first time, or if it has remained unused for a long period, it should be dried for 30 minutes on switch position n° 1. This will eliminate any moisture that may have been absorbed by the insulating material. To correctly use the appliance, remember: - To place a pan on the plate before switchin[...]

5 CLEANING IMPORTANT: Always disconnect the appliance from the electricity main before carrying out any cleaning operation. 3) HOTPLATE If you want to preserve the surface clean and bright, periodically wash the hot plate with lukewarm soapy water. Following this, all parts should be thoroughly rinsed and dried. Never wash them while they are still[...]

6 INSTALLATION Installation and maintenance must only be carried out by a qualified installer. Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. 4) INSTALLING THE HOT PLATE Check that the appliance is in a good condition after having removed the outer packaging and inte[...]

7 INSTALLATION FIG. 8 6) ELECTRICAL CONNECTIONS Electrical connection must be carried out in compliance with the specifications and provisions in force. Before proceeding with the connections, check that: - The voltage rating of the appliance and the current sockets suits the maximum power draw of the appliance (see data label affixed to the lower [...]

8 CONVERSIONS Disconnect the appliance from the mains supply prior to any conversions being carried out. 7) CHANGING THE TYPE OF POWER SUPPLY Although they leave our factory preset for single- phase connection, certain appliances may by converted to the threephase system. Comply with the following instructions: a) Remove the hotplate from the top o[...]

9 SERVICING Always disconnect the appliance from the electricity main before proceeding with any servicing operation. 8) REPLACING THE ELECTRICAL COMPONENTS For access to the various parts, remove the hotplate from the top of the cabinet. Then overturn it, unscrew screw “Z” and remove under part. (see fig. 9). After these actions is possible to[...]

VOLTAGE 110 V~ FREQUENCY 50/60 Hz TOT. RATING 5000 W MODEL WITH 4 NORMAL PLATES 10 TECHNICAL DATA[...]

11 TECHNICAL ASSISTANCE AND SPARE PARTS This appliance, before leaving the factory, has been carefully tested and regulated by expert and specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. [...]

12[...]