Samsung 76E, 76V, 77V инструкция обслуживания

SAMTRON 76E/76V/77V[...]

Main > Index Main Page On-Screen Display Safety Instructions Troubleshooting Notational Check List Power Q & A Installation Self-Test Feature Check Cleaning Other Introduction Specifications Unpacking General Specifications Front Preset Timing Modes Rear PowerSaver Bottom Setup Information Connecting Your Monitor Service Installing the Monit[...]

Main > Safety Instructions > Notational Notational Power Installation Clean Other Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric sh[...]

Main > Safety Instructions > Power Notational Power Installation Clean Other When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. z If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the [...]

Main > Safety Instructions > Installation Notational Power Installation Clean Other Do not cover the vents on the monitor cabinet. z Bad ventilation may cause a breakdown or fire. Put your monitor in a location with low humidity and a minimum of dust. z An electric shock or fire could result inside the monitor. Do not drop the monitor when mo[...]

Main > Safety Instructions > Clean Notational Power Installation Clean Other When cleaning the monitor case or the surface of the CRT, wipe with a slightly moistened, soft fabric. Do not clean Flat monitor with water. Use a water-diluted mild detergent. (Some detergents contain significant amounts of alcohol-based solvents, which can damage ([...]

Main > Safety Instructions > Other Notational Power Installation Clean Other Do not remove cover(or back). No user serviceable parts inside. z This may cause an electric shock or a fire. z Refer servicing to qualified service personnel. If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming[...]

Keep the monitor away from any magnetic substances. z This may cause discoloring or distortion of the image.[...]

Unpacking Front Rear Bottom Monitor and Stand (Some models include a stand attached. ) Please make sure the following items are included with your monitor. If any items are missing, contact your dealer . Power Cord Stand Quick Setup Guide Warranty Card (Not available in all locations) User's Guide and Driver Installation CD USB Hub (Option) SA[...]

Main > Introd uction > Unpacking Unpac king Front Rear Bottom Monitor and Stand (Some models in clude a stand attached. ) Please m ake sure th e followi ng item s are inclu ded with your m onitor. If an y item s are miss ing, contact your de aler . Power Co rd Stand Qu ick Setup Guide Warranty Card (No t available in all locations) User'[...]

Main > Introduction > Front Unpa cki ng Fro nt Rear Bottom 1. Exit button Use this but ton to Exit th e active menu or t he OSD. 2,3. A djust bu ttons These buttons al low you to hi ghlight and adjust i tems in the men u. 4. M enu butt on Use this button to open the OSD and activate a highlighted menu item . 5. Powe r ind icator Indicates nor[...]

Unpacking Front Rear Bottom 1. Exit button Use this button to Exit the active menu or the OSD. 2,3. Adjust buttons These buttons allow you to highlight and adjust items in the menu. 4. Menu button Use this button to open the OSD and activate a highlighted menu item. 5. Power indicator This light glows green during normal operation, and blinks green[...]

Unpacking Front Rear Bottom (The configuration at the back of the monitor may vary from product to product.) 1. Power port Connect the power cord for your monitor to the power port on the back of the monitor. 2. Signal Cable Connect the signal cable to the video port on your computer, video board, video card, or graphics card. Note: See Connecting [...]

Unpacking Front Rear Bottom 1. Signal Cable Connect the signal cable to the video port on your computer, video board, video card, or graphics card. 2. Power port Connect the power cord for your monitor to the power port on the back of the monitor. 3. Tilt/Swivel Base You can separate the base from the monitor.[...]

Connecting Your Monitor Installing the Monitor Driver Base Installation 1. Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet. 2. Connect the signal cable to the video port on your computer, video board, video card, or graphics card. 3. If you are using a Ma[...]

Connecting Your Monitor Installing the Monitor Driver Base Installation When prompted by the operating system for the monitor driver, insert the CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appropriate for the operating system you have. Prepare a blank di[...]

4. Click the " Install " button in the " Warning " window. 5. If you can see following "Message" window, then click the "Continue Anyway" button. Then click "OK" button. This monitor driver has been applied to Microsoft for the Windows logo, and this installation does not damage the correct operatio[...]

Connecting Your Monitor Installing the Monitor Driver Base Installation Windows XP | Windows 2000 | Windows Me | Windows NT | Linux When prompted by the operating system for the monitor driver, insert the CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appro[...]

6. Select " Don't search ,I will.. " then click " Next " and then click " Have disk ". 7. Click the " Browse " button then choose A:(D:Driver) and choose your monitor model in the model list and click the " Next " button. 8. If you can see following " Message " window, then click the[...]

10. Monitor driver installation is completed. Microsoft ® Windows ® 2000 Operating System When you can see "Digital Signature Not Found" on your monitor, follow these steps. 1. Choose " OK " button on the " Insert disk " window. 2. Click the " Browse " button on the " File Needed " window. 3. Choo[...]

Microsoft ® Windows ® NT Operating System 1. Click Start , Settings , Control Panel , and then double-click Display icon. 2. In Display Registration Information window, click Settings Tab and then click All Display Modes . 3. Select a mode that you wish to use (Resolution, Number of colors and Vertical frequency) and then click OK . 4. Click Appl[...]

Connecting Your Monitor Installing the Monitor Driver Base Installation Tilt/Swivel Base | Attaching and Removing the Base With the built-in pedestal, you can tilt and/or swivel the monitor for the most comfortable viewing angle. Note: The base is detachable. If your monitor was supplied with the base detached, attach the base as follows. Remove th[...]

Attaching the Base 1. Place the monitor upside-down on a flat work surface. 2. Align the tabs on the base with the corresponding slots on the bottom of the monitor. 3. Press the base onto the monitor until the tabs are fully engaged in the slots. 4. Push the base toward the front of the monitor until the release latch clicks into the locked positio[...]

On Screen Display (OSD) Menu System 1 E x it b u tt on: U se thi s b u tt on t o E x it th e ac ti ve menu or th e OSD. 2,3 Adjust buttons: These buttons allow you to highlight and adjust items in the menu. 4 Menu button: Use this button to open the OSD and activate a highlighted menu item. 1E i tb t t U thi b tt t E it th ti th SAMTRON 76E/76V[...]

On Screen Display (OSD) Menu System 1 E x it b u tt on: U se thi s b u tt on t o E x it th e ac ti ve menu or th e OSD. 2,3 Adjust buttons: These buttons allow you to highlight and adjust items in the menu. 4 Menu button: Use this button to open the OSD and activate a highlighted menu item. 1E i tb t t U thi b tt t E it th ti th SAMTRON 77V[...]

Main > Troubleshooting > Check List Check List Q & A Self-Test Feature Check Before calling for service, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the warranty card, the phone number on the Information section or contact your dealer . Sy[...]

The screen shows strange colors or just black and white. Is the screen displaying only one color as if looking at the screen through a cellophane paper? Check the signal cable connection. Make sure the video card is fully inserted in it's slot. Have the screen colors become strange after running a program or due to a crash between applications[...]

5 . If you h ave pro bl ems i n i ns t a lli ng th e a d ap t er ( v id eo ) d r i ver, b oo t th e compu t er i n S a f e M o d e, remove the Display Adapter at the " Control Panel , System , Device Administrator " and then reboot the computer to reinstall the adapter (video) driver. Note: If problems repeatedly occur, contact an authori[...]

Main > Troubleshooting > Q & A Check List Q & A Self-Test Feature Check Question Answer How can I change the frequency? Frequency can be changed by reconfiguring the video card. Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.) How can I ad[...]

Main > Troubleshooting > Self-Test Feature Check Check List Q & A Self-Test Feature Check Self-Test Feature Check | Warning Messages | Environment | Useful Tips Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly. 1. Turn off both your computer and the monitor. 2. Unplug the vide[...]

1 . If th ere are any woo f er spea k ers near th e mon it or, unp l ug an d re l oca t e th e woo f er t o ano th er room. 2. Remove all electronic devices such as radios, fans, clocks and telephones that are within 3 feet (one meter) of the monitor. 3. Degauss the monitor if any devices were removed from the area. z A monitor recreates visual sig[...]

General PowerSaver Preset Timing Modes General Model Name SAMTRON 76E Picture Tube Type 17"(43cm) Full square type (40.6cm viewable) Deflection angle 90 ° Dot Pitch 0.23mm (Horizontal) Screen type Aluminized tri-color phosphor dot trio with black matrix. Anti-doming invar shadow mask. Mult i -layer coated with anti-static. Maximum Resolution [...]

General PowerSaver Preset Timing Modes This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you move the computer's mouse or press a key on[...]

General PowerSaver Preset Timing Modes If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows. Table 1. Preset Timing Mod[...]

General PowerSaver Preset Timing Modes General Model Name SAMTRON 76V Picture Tube Type 17"(43cm) Full square type (40.6cm viewable) Deflection angle 90 ° Dot Pitch 0.23mm (Horizontal) Screen type Aluminized tri-color phosphor dot trio with black matrix. Anti-doming invar shadow mask. Multi-layer coated with anti-static/Glare. Maximum Resolut[...]

General PowerSaver Preset Timing Modes This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you move the computer's mouse or press a key on[...]

General PowerSaver Preset Timing Modes If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows. Table 1. Preset Timing Mod[...]

Main > Specifications > General General Pow erS aver Preset T iming Modes General Model Name SAMTRON 77V Picture Tube Type 17"(43cm) Full square type (40.6cm viewable) Deflection angle 90 ° Dot Pitc h 0.23mm (H o ri zontal) Screen type Aluminized tri-co lor phosphor dot t rio with black mat rix. Anti-doming invar shadow mask. M u l t i [...]

Service Terms Regulatory Authority SAMTRON SEOUL 15TH FL, JOONGANG DAILY NEWS BLDG. 7, SOONHWA-DONG,CHUNG-KU, SEOUL, KOREA, 100-759 TEL : (82-2) 727-3114 SAMTRON U.S.A. SAMTRON COMPUTER PRODUCTS CUSTOMER SERVICE 400 Valley Road Suite 201, Mt. Arlington, NJ 07856 TEL : 973-601-6200, FAX : 973-601-6001 1-800-SAMTRON (1-800-726-8766) SAMTRON CANADA SA[...]

Information > Terms Service Terms Regulatory Authority Dot Pitch The image on a monitor is composed of red, green and blue dots. The closer the dots, the higher the resolution. The distance between two dots of the same color is called the 'Dot Pitch'. Unit: mm Vertical Frequency The screen must be redrawn several times per second in or[...]

Main > Information > Regulatory Service Terms Regulatory Authority FCC Information | IC Compliance Notice | MPR II Complianc e (Except SAMTRON 76V) | European Notice (Europe only) | PCT Notice | VCCI | TCO'95-Ecological requirements for personal computers (TCO applied model only) TCO'99-Ecological requirements for personal computers[...]

PCT Notice VCCI This is a Class B product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual. TCO'95-E[...]

reasonable for the user. Labelled products must meet strict environmental demands, for example in respect of the reduction of electric and magnetic fields, along with physical and visual ergonomics and good usability. TCO Development Unit 1996-11-29 On the page this folder you will find a brief summary of the environmental requirements met by this [...]

Why do we have environmentally labelled computers? In many countries, environmental labelling has become an established method for encouraging the adaptation of goods and services to the environment. The main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the p[...]

Service Terms Regulatory Authority Information in this document is subject to change without notice. © 200 3 Samsung Electronics Co., Ltd. All rights reserved. Reproduction in any manner whatsoever without the written permission of Samsung Electronics Co., Ltd. is strictly forbidden. Samsung Electronics Co., Ltd. shall not be liable for errors con[...]