Roadmaster VR500CS-BT инструкция обслуживания

[...]

W elcome! Dear Customer , CONGRA TULA TIONS. The VR500CS-BT MP3/CD Player with AM/FM Receiver , USB Port and SD Card Slot, Electr onic Anti-Shock (ESP) & Fold-down Detachable Face, when used as described, will give you years of dependable service in your car , truck, RV , or mini-van. W e have taken numerous measures in quality control to ensur[...]

Precautions • Handle the disc by its edge to keep the disc clean. Do not touch the disc’ s surface. • Do not use a CD with paste or ink residue on it. • Do not use CDs with labels or stickers attached. The label may leave a sticky residue when it begins to peel. • Clean the discs with an optional clean- ing cloth. Wipe each disc from the [...]

• Disconnect negative battery terminal before starting installation. Consult the vehi- cle’ s owner’ s manual for proper instruction. • The unit is designed for a 12V olt DC negative gr ound operation system only . Before installing the unit, confirm that your vehicle is a 12V olt DC negative ground system. • Be sure to connect the color [...]

Before Y ou Install Automotive audio equipment installations can be challenging at times, even to the most experienced of installation technicians. If you are not confident working with electrical wiring, removing and re-installing interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have t[...]

Installtion 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 25mm) 5. Screw 6. Strap 7. Plain washer 2. Mounting Sleeve 3 . Scr ew 1 . Dashboar d Bend the tabs to secure the Mounting Sleeve in the dashboard. DIN FRONT -MOUNT (Method A) After inserting the Mounting Sleeve into the dashboard, select tabs on top, bottom, and sides, then bend t[...]

DIN REAR-MOUNT (Method B) Installation using the screw holes on both sides of the unit. 1. Screw holes on the side of the unit. 2. Screws. Use either truss screws (5 x 8mm) or flush surface scr ews (4 x 8mm), depending on the shape of the screw holes in the bracket. 3. V ehicle’ s Factory Mounting Bracket 4. Dashboard or Console 5. Hook (Remove t[...]

Installation 7 The VR500CS-BT has the ability to use two microphones. One micr ophone is built-in, the other is a remote micr ophone. Built-In Microphone The built-in microphone is located on the fr ont right side of the unit. There is no setup requir ed for this microphone and it is tuned to pick-up the voices of the front and r ear seat passenger[...]

Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requir es a tight connection to the vehicle’ s metal chassis. The ar ea around the gr ound connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical[...]

Location Of The Controls 9 1 2 3 4 5 6 7 8 1. Answer/ Green Phone 2. V olume/SEL/Enter 3. Disc Slot 4. Liquid Crystal Display (LCD) 5. 0-9, #, & * Key Pad buttons 6. Random / No. 4 7. No.1 / T op 8. No.5 / Down 10 9. Intro/No. 2 10. Eject 11. No. 6 / UP 10 12. SD/MMC Card Slot 13. USB Port with Cover 14. Microphone Jack 15. Subwoofer/Pound Sign[...]

Remote Control 1. Power On/Off 2. V olume Up 3. Select/Menu/Enter 4. V olume Down 5. Intro/No. 2 6. No.1/T op 7. No. 5/Down 10 8. No. 4/Random 9. No. 8/T A Control 10. No. 7/AF 11. No. 0/Stereo 12. Star Symbol/Scan 13. PHONE 14. Green Phone Icon 15. No. 3 16. Next T rack/Fast Forward 17. No. 6/UP 10 18. Previous/Fast Reverse 19. No. 9/PTY 20. Mode/[...]

Basic Operation 1. T uning the Unit On / Of f Press any Button to turn the unit on, the dis- play will show a message WELCOME to in- dicate it is ready for use. Press the POWER button for 2 seconds to turn the unit off. 2. Mode Selection Press the BAND Button to select Radio Mode. Press and hold the MOD/MUT But- ton to cycle the Play Mode between A[...]

Before Connecting T urn the VR500CS-BT ON, then turn your cell phone’ s Bluetooth Function ON. 1. Pairing 1. Press the “PHONE” button. 2. Press and hold the V olume Knob until you see “DISP OFF”, 3. Press the V olume Knob repeatedly to cycle through to “P AIRING”. 4. Press and hold the V olume Knob until the word “P AIRING” blinks[...]

Bluetooth Connection 13 10. Recently Received Calls After connecting with cell phone; 1. Press the “PHONE” button. 2. Press and hold the V olume Knob until you see “OUT NUM”, then press the V olume Knob until the display shows “IN NUM”. 3. Press and hold the V olume Knob and the display will show the most r ecent received call. 4. Rotat[...]

Radio Operation 1. Choose Radio Band Press the BND•ID3 Button anytime to ac- cess the radio function. The unit comes with five bands - three FM (FM1, FM2, and FM3) and two AM (AM1 and AM2) Band selects. Each of the five bands can store up to six preset stations, for a to- tal of 30 preset memory stations. NOTE: T o change the r eceiving range fr [...]

Radio Operation (Cont) 1. AF - Alternative Frequency Press the AF button and the unit will choose the strongest FM signal for the selected station, so that you do not have to re-tune the station when driving between different transmitter coverage areas. When AF is on, it means RDS information is received; when AF is flashing, it means RDS informati[...]

CD Operation (Cont) cally switch to Radio Mode. 2. Multi-Session CD Reading This unit can read multi-session CDs. The multi-session r eading will be activated automatically if the player detects a file that is written in multi-session format. Pr ess and hold the V olume Knob until “DSP OFF” is shown on the LCD, then pr ess the V olume Knob to c[...]

Press the |<< Button to go to a previous track. T rack numbers will be shown on the display . Press and hold the |<< Button to fast reverse. Disc will play normally when the >>| or |<< Button is released. 4. Play/ Pause CD On the Remote or Head Unit, press the “BND•ID3” button to pause the CD. Press this button again t[...]

4. Scanning T racks On the Remote or Head Unit, press the 2 / I NT Button to play the first 10 seconds of each track. Press this button again to resume playback. 5. Repeat On the Remote or Head Unit, press the F/PS / R PT Button to repeat the same track continuously . “RPT ON” will appear on the display . Press this button again to stop repeati[...]

1. RCA Output The RCA Output Jacks are on the back of the unit. (Refer to Wiring Diagram) This out- put is for connecting an amplifier , equalizer , or other audio componement that requires a pre-amp out connection. (Red = Right, White = Left) Follow the manufacturers in- structions for the audio component that you are connecting. 2. Sub W oofer Ou[...]

20 Specifications GENERAL Operating Power ................................................................... 12 V olts DC, Negative Ground Output Wiring ............................................................ Designed for using four speakers only Maximum Output Power ............................................................................[...]

Limited W arranty VIRTUAL REALITY VIDEO LABS ® products are designed and manufactured to provide a high level of trouble- free performance. VIRTUAL REALITY VIDEO LABS® warrants, to the original purchaser , that its products ar e free fr om defects in material and workmanship for 30 days from the date of original purchase, as part of our commitmen[...]