Regency C33-NG2 инструкция обслуживания

WARNING: If the information in these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Installation and service must be performed by a qualif[...]

2 Regency CLASSIC C33-2 Freestanding Gas Stove To the New Owner: Congratulations! You are the owner of a state-of-the-art Gas Stove by Fireplace Products International Ltd. The Regency Gas Series of hand crafted appliances has been designed to provide you with all the warmth and charm of a woodstove, at the flick of a switch. The models C33-NG2 and[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 3 T ABLE OF CONTENTS Safety Label Safety Label ............................................................. 4 - 5 Installation Before you start .......................................................... 6 General Safety Information .... ...................................... 6 Installation Checklist ...[...]

4 Regency CLASSIC C33-2 Freestanding Gas Stove This is a copy of the label that accompanies each CLASSIC Freestanding Gas Stove - Nat- ural Gas . We have printed a copy of the contents here for your review. The safety label is located on the back panel. NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 5 SAFETY LABEL This is a copy of the label that accompanies each CLASSIC Freestanding Gas Stove - Propane . We have printed a copy of the contents here for your review. The safety label is located on the back panel. NOTE: Regency units are constantly being im- proved. Check the label on the unit and if t[...]

6 Regency CLASSIC C33-2 Freestanding Gas Stove INST ALLA TION IMPORT ANT : SA VE THESE INSTRUCTIONS The CLASSIC Freestanding Gas Stove must be installed in accordance with these instructions. Carefully read all the instructions in this manual first. Consult the "authority having jurisdiction" to determine the need for a permit prior to st[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 7 Diagram 4 9) Lift the fan assembly in through the pedes- tal and up through the cut out as shown in diagrams 3 and 4. 10) Put the insulation gasket on the back of the fan. Line up the keyhole slots with the matching screws and pull back slightly to lock into place. While holding fan assembly in place, [...]

8 Regency CLASSIC C33-2 Freestanding Gas Stove INST ALLA TION PEDEST AL ASSEMBL Y 1) For easier assembly, tip the stove on its back (preferably onto a soft surface to prevent scratching). 2) Unscrew the 4 bolts in the underside of the stove. Align the holes in the corners of the pedestal top with the corresponding holes in the base of the stove. Us[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 9 VENTING This heater is a vented appliance and must be connected to a chimney/flue in accordance with installation codes. Note: The rear cover plate is only at- tached when outside air is being used. Do not install it when using room air for combustion. For your safety this heater is equipped with a ven[...]

10 Regency CLASSIC C33-2 Freestanding Gas Stove HIGH ELEV A TION This unit is approved in Canada for altitude 0 to 4500 ft. (CAN1 2.17-M90) with the orifice sup- plied. GAS PIPE PRESSURE TESTING The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas sup[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 11 Diagram 2 LOG SET INST ALLA TION WARNING: Dangerous operating conditions may occur if these logs are not positioned in their approved locations. Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere wi[...]

12 Regency CLASSIC C33-2 Freestanding Gas Stove FINAL CHECK Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly. This includes: 1) Clocking the appliance to ensure the correct firing rate (rate noted on label) after 15 minutes. 2) If required, adjusting the primary air to en- sure that the fl[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 13 INST ALLA TION It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance. Listed below are some examples. All are normal operating sounds and should not be considered as de[...]

14 Regency CLASSIC C33-2 Freestanding Gas Stove OPERA TING INSTRUCTIONS LIGHTING PROCEDURE IMPORTANT: Gas cock knob cannot be turned from "PILOT" to "OFF" unless it is partially depressed. 1) Turn burner OFF using "ON/OFF" switch. 2) Turn gas control knob so indicator points to "OFF" position and allow 5 minu[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 15 COPY OF THE LIGHTING PLA TE INSTRUCTIONS OPERA TING INSTRUCTIONS 1 ) Push in the gas control knob slightly and turn clockwise to “OFF”. Do not force. FOR YOUR SAFETY READ BEFORE LIGHTING A ) This appliance has a pilot which must be lighted by hand, following the instructions below exactly. B ) BEF[...]

16 Regency CLASSIC C33-2 Freestanding Gas Stove PILOT ADJUSTMENT Periodically check the pilot flames. Cor- rect flame pattern has three strong blue flames: 1 flowing around the thermopile, 1 around the thermocouple and 1 flowing across the burner (it does not have to be touching the burner). Note: If you have an incorrect flame pat- tern, contact y[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 17 7) Install the replacement glass. When placing the replacement glass in the door, make sure that the glass gasketing will properly seal your unit. 8) Put glass in place and then position glass retainer rod. Note: Do not use substitute materials. If your glass does break, do not continue to use your un[...]

18 Regency CLASSIC C33-2 Freestanding Gas Stove MAINTENANCE 8) If optional fan is installed, remove thermo- disc to bracket by removing three (3) phillips head M5 screws. 9) Remove front cover with Piezo Igniter by removing two (2) sheet metal screws. 10) Loosen four (4) phillips head M5 valve mounting screws from underside of fire- box. Push valve[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 19 MAIN ASSEMBL Y PARTS LIST P ar t # Description 1 ) 846-913 Door Assy-Gold (no glass) 846-915 Door Assy-Black (no glass) 3 ) 846-302 S mall G lass 4 ) 936-243 Glass Gasket (7/8") 5 ) 846-920 Glass Retainer Clips (8/set) 6 ) * Screw 1/4 - 20 x 3/8" 7 ) 948-170/P Small Glass Retainer 9 ) 846-97[...]

20 Regency CLASSIC C33-2 Freestanding Gas Stove PARTS LIST BURNER & LOGS P ar t # Description 52) 910-190 Pie zo Ig nito r & Nu t 53 ) * Control Panel 908-672 Control Panel Decal 462-560/P Valve Assembly - S.I.T. - NG 462-561/P Valve Assembly - S.I.T. - LP 63) 910-378 Valve S.I.T. - NG 910-380 Valve S.I.T. - LP 66) 910-034 Pilot Assembly-3 [...]

Regency CLASSIC C33-2 Freestanding Gas Stove 21 BASE OPTIONS PARTS LIST 490-921 Complete Floor Shield 100) 948-216 Regency Logo 102) 904-257 Magnetic Catch (Large) 103) * 11" Pedestal Hinge 108) 910-246 Bu rner ON/ OFF Sw itch (2-way) 109) 910-272 LT. Dummy Plug 110) * Strain Relief for power cord 121) * Access Panel 140) 850-126 Cast Legs - B[...]

22 Regency CLASSIC C33-2 Freestanding Gas Stove _____________________________________________________________________________________ ____________________________________________________________ __________________________________________________________ ____________________________________________________________ ___________________________________[...]

Regency CLASSIC C33-2 Freestanding Gas Stove 23 W ARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our facility. FPI Fireplace Products International Ltd. is pleased to extend this limited lifetime warran[...]

Installer: Please complete the following information Dealer Name & Address: ______________________________________________ __________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: [...]