RedMax BC2200E инструкция обслуживания

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING OWNER / OPERA T OR MANUAL TRIMMERS / STICK EDGERS 5850-93110 (9809) IMPORTANT : Before operating your RedMax product, read this manual carefully and completely. BT2200LDC BC2200E BC2200LDC HE220[...]

[...]

Thank you for choosing a RedMax trimmer / stick edger . This manual will provide you with full understanding of the necessary instructions for assembly , operation and maintenance of the equipment. Please read this manual carefully before starting operation. For continued safe and reliable operation, use ONL Y original RedMax parts and accessories,[...]

FOR SAFE OPERA TION ■ KNOW YOUR UNIT 1. Read this Owner's Manual carefully until you completely understand and can follow all safety rules, precautions, and operating instructions before operating the unit. 2. Restrict your unit to users who understand and follow all safety rules, precautions, and operating instructions found in this manual.[...]

■ HE2200LDC 1. Install the blade guard to the gear case with the provided 3 screws. 2. Place the blade between the cutter holders (A) and (B) while locking the gear shaft by putting the bar , one of the tools provided, through the key holes on the holder(A) and the gearcase. Use the socket and the bar as shown in the picture below to tighten the [...]

FUEL The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. When RedMax oil is not available, use an anti-oxidant added quality oil formulated for air-cooled 2-cycle engine use. RECOMMENDED MIXING RATIO GASOLINE 32 : OIL 1 Exhaust emission are controlled by the fundamental engine parameters and com[...]

■ STARTING ENGINE Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine. 1. Press the primer bulb until fuel flows out in the clear tube (5 to 7 times). Lace the choke lever in the full choke position. When restarting the engine right after stopping it, keep the choke open. 2. [...]

■ LINE HEAD USAGE • HOW TO USE 1. Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal Injury. 2. Keep the debris guard attached in place at all times when the unit is operated. • TRIMMING GRASS AND WEEDS Always remembe[...]

OPERA TION ■ METAL BLADE USAGE NOTE : Do not use the Metal Cutting Blade for model BT2200LDC and BC2200E • Always cut by guiding the head from your right to left. • When mowing a wide area, start working from the left side to avoid interference of cut grass. • A metal blade cuts best up to the point 1/3 from the edge. Use that area for cutt[...]

g. Cut only from your right to your left. h. Keep your path of advance clear of material that has been cut and other debris. 3. How you can maintain the best control: a. Keep a good, firm grip on the unit with both hands. A firm grip can help neutralize bounce. Keep your right and left hands completely around the respective handles. b. Keep both fe[...]

I . Bump head for BT2200LDC and BC2200E ■ REPLACING TRIMMING LINE To refill a new trimming line either ; A : Install the prewound reel #153577 or B : Rewind the existing reel. For replacement line, use a diameter of .080 in (2.03 mm). The engine may overheat and fail if you use a larger line. For safety reason, do not use metal-reinforced line. A[...]

• INSTALLING THE REEL 1. Insert each end of the line through the eyelet on the outer spool. Then pull the end firmly to release the line from the holding slot. MAINTENANCE 1 4 6 2 5 7 3 7.6m (25') 3.8m (12.5') Ø2.4mm 0.095In 2. Hold the inner reel in place and screw in the Bump Knob bolt in the correct direction ( clockwise for BT2200L[...]

MAINTENANCE 8 11 14 1 2 9 10 12 13 15 THIS SIDE UP THIS SIDE UP WIND LINE  11 [...]

■ SPARK PLUG Starting failure and mis-firing are often caused by a fouled spark plug. Periodically clean the spark plug and check that the spark gap is within the correct range. For a replacement plug, use Champion RCJ6Y or the equivalent. ■ STORAGE Old fuel left in the carburetor may cause starting failure. Before storing the unit, empty the f[...]

■ BT2200LDC Overall size (LxWxH) ···························································································62.2x9.7x17.9 (in) Dry weight ···················································?[...]

Fig.1 TRIMMER UNIT FOR BT2200LDC Key# Description Part Number Q'ty P ARTS LIST Fig.1 TRIMMER UNIT FOR BT2200LDC 17 Guard mount screw 153318 1 18 Guard ass'y 683445 1 19 Blade ass'y 682061 1 20 Anti-rotation screw 145569 1 21 Spool shaft 153313 1 22 Outer spool ass'y 153619 1 23 Eyelet 145566 2 24 Retainer (10 pack) 610660 1 25 S[...]

Fig.2 TRIMMER UNIT FOR BC2200E Key# Description Part Number Q'ty Key# Description Part Number Q'ty 1 Straight shaft ass'y ————— 1 2F lex drive shaft ————— 1 3 Throttle housing ass'y 181125 1 4 Throttle lever 180975 1 5 Spring 610314 1 6S crew 145569 1 7S crew 147544 5 8 Handle ass'y 6462-14100 1 9 Handle[...]

Fig.3 TRIMMER UNIT FOR BC2200LDC Key# Description Part Number Q'ty Key# Description Part Number Q'ty 1 Straight shaft ass'y ————— 1 2F lex.drive shaft ————— 1 3 Gear box ass'y 147488 1 4S crew ————— 1 5 Screw set 147677 1 6B lade driver 147489 1 7 Lower retaining washer 147490 1 8 Throttle housing a[...]

Fig.4 STICK EDGER UNIT FOR HE2200LDC Key# Description Part Number Q'ty Key# Description Part Number Q'ty 1 Curved shaft ass'y ————— 1 2F lex drive shaft ————— 1 3 Throttle housing ass'y 181125 1 4 Throttle lever 180975 1 5 Spring 610314 1 6S crew 145569 1 7S crew 147544 5 8 Handle bracket ass'y 683295 1 [...]

Fig.5 ENGINE GROUP FOR BT2200LDC. BC2200E. BC2200LDC. HE2200LDC  18 [...]

Fig.5 ENGINE GROUP FOR BT2200LDC. BC2200E. BC2200LDC.HE2200LDC Key# Description Part Number Q'ty Key# Description Part Number Q'ty 1C ylinder 5850-12110 1 2 Gasket, base 5500-12211 1 3 Bolt 1850-12130 2 4 Insulator 5850-13160 1 5 Gasket, insulator 5850-13120 1 6 Gasket, carburetor 5850-13130 1 7S crew 5850-13210 2 8 Muffler ass'y 585[...]

THE CALIFORNIA AIR RESOURCES BOARD AND KOMATSU ZENOAH Co. ARE PLEASED TO EXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR 1995 AND LATER LAWN AND GARDEN EQUIPMENT ENGINE. IN CALIFORNIA, NEW UTILITY AND LAWN AND GARDEN EQUIPMENT ENGINES MUST BE DESIGNED, BUILT AND EQUIPPED TO MEET THE STATE'S STRINGENT ANTI-SMOG STANDARDS. KOMATSU ZENOAH Co[...]

EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE MODEL BT2200LDC OR BC2200E / BC2200LDC OR HE2200LDC UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIA[...]

KOMA TSU ZENOAH AMERICA INC. 1505 Pavilion Place Suite A Norcross, Georgia 30093 © Printed in the USA[...]