PYLE Audio DISC CD CHANGE инструкция обслуживания

INSTRUCTION MANUAL 6 - DISC CD CHANGER PLCHD6[...]

IMPORT ANT NOTICE This Compact Disc Changer/Player has been tested and found to comply with the limits for a class B digital device in accordance with the specifications in Subpart J of part 15 of FCC Rules. This equipment generates and uses radio frequency ener gy , and it must be installed and used properly in accor dance with the manufacturer&ap[...]

2 INTRODUCTION RESET FUNCTION A RESET button is located on the front panel (to the left side of EJECT button) and is accessible only when the magazine door is opened. The RESET button is recessed in order to pr event accidental engagement, and can be activated with the tip of ball- point pen or any similar pointed object. The reset cir cuitry is pr[...]

3 LOCA TION OF CONTROLS 1. Compact Disc Magazine Slot 2. Reset Button 3. Eject Button (Press this button to eject the Magazine) 4. Slide Door WIRING CONNECTIONS CAR RADIO CD CHANGER 1 2 3 4[...]

4 HOW TO USE THE COMP ACT DISC MAGAZINE Inserting Discs Inserting Discs into the supplied magazine. Up to 6 Discs may be inserted into the magazine. The Disc are number ed from 1 (bottom tray) to 6 (top tray). Note: Do not touch the recor ded side of a Disc while inserting or removing it. Removing Discs 1. Press the Eject button to r emove the Maga[...]

5 INST ALLA TION • Use the supplied parts and mount the unit securely . The use of parts other than these supplied (specified) may loosen or damage internal components. • If installation presents any dif ficulties, consult your dealer for advice. • Before drilling a hole into the wall or floor the vehicle trunk, check that nothing is behind t[...]

ACCESSORIES x2 x2 x4 a) Bracket b) Floor base plate c) Hex bolt (M5x12) with W ashers x4 x4 x4 x1 d) Wing nut (06) e) Self tape screw (5x15) f) Self tape screw (3x15) g) Mount angle adjust key Important Angle set and locking screws • Be sure to adjust the mounting angle set scr ew (F) using the mounting angle adjust key to appropriate angle: Of f[...]

7 ø 3.5mm c) e) e) a) a) c) Press the unit to the floor , and remove the wing nuts (d), and lift off the changer Lay down the carpet. Cut 1 “ X ” on each area of the carpet wher e the mounting bolts will pass through Mount the unit in place, using 4 wing nuts (d) Attach the brackets (a) to each side of the unit using hex bolts with washers (c)[...]

VERTICAL INST ALLA TION FOR AN ANGLED INST ALLA TION, TURN TO THE 45 ° POSITION AND A TT ACH LOCK SCREW (F1) IN THE MIDDLE HOLE. 8 Press the unit to the floor , and remove the wing nuts (d), and lift off the changer Lay down the carpet. Cut 1 “ X ” on each area of the carpet wher e the mounting bolts will pass through Mount the unit in place, [...]

9 SPECIFICA TIONS General System Compact Disc audio system Usable Discs Compact Disc Operation voltage 10 - 15V Power consumption 6W or less (DC 14.4V) Operating electric current 400mA 14.4V olt Max. peak electric current 1.2A 14.4V olt Dimensions 284(W) x 186.5(O) x 74(H) mm Operational temperature range 5 ° F - 158 ° F T emperature range of sto[...]

10 OPERA TION Liquid Crystal Display (LCD) - (1) LCD display will only be active when the changer power is on. This display indicates all operation key's, including DISC number . T rack number , and DISC icon. Random Play Button - (2) (T rack or DISC Random) This is used for random selection Disc play , and sequence. Once this button is presse[...]

ERROR DISPLA Y • Error 1: There's no Magazine, and DISC is clamping. • Error 2: It is impossible to dischar ge Magazine while ejecting. • Error 3: Loading is not completed after a certain time (8 sec) passed. • Error 4: Unloading is not completed after a certain time (8 sec) passed. • Error 5: Elevator does not reach to the tar get p[...]