ProScan 37LC30S57 инструкция обслуживания

PROSCAN _ USER'S MANUAL Before using the TV, please read this manual thoroughly, and retain it for future reference. 3 7 L C 3 0 S 5 7 _,,,_- ,o. ,_o_o[...]

Federal Communications Commission Statement NOTE The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority. NOTE This equipment has been tested and found to comply with the limits for a class B digital Device, pursuant to part [...]

CONTENTS Important safety instructions ........................................................................................................... 3 Preparation for using your new "iV ................................................................................................. s Base installation instruction ...............................[...]

CAUTION CAUTION; TO REDUCE THE RISK OF AN ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). THERE ARE NO USER SERVICEABLE PARTS INSIDE. FOR ANY REQUIRED SERVICING, PLEASE CONTACT QUALIFIED SERVICE PERSONNEL. The lightning flash symbol with an arrowhead inside a triangle alerts the user about an uninsulated dangerous voltage that may be of sufficie[...]

ImPortant safety instructions 15. POWER SOURCE: This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery power, or other sources, refer to the operating ins[...]

Pre ration for usi r new TV Base installation instruction 1. Lay a cloth or other soft material that can afford adequate weight on a flat table to avoid damage to the LCD screen. 2. Put the TV back upward and the LCD screen downward and keep it flat on the table-board. 3. Take out the base and insert it into the installing slot in the lower part of[...]

Preparation for using your new TV Learning about your TV Operate your TVvia the buttons located on the front or side of cabinet or use the remote control, The terminals located on back of TV provides all the connections from other equipment to TV. View the front connection pane| )ut selection Up Down Up Down indicator --Remote receiver View the bac[...]

Preparation for using your new TV Selecting a location for the TV 1. Place the TV on an open stand in a location where light does not directly hit the screen. 2. Place the TV far enough from the walls to allow proper ventilation. Inadequate ventilation may cause overheating, which may damage the TV. NOTE: Please contact a local dealer for wall moun[...]

Preparation for using your new TV The back pane| connection The equipment with HDMI output jack I:_ ( such as DVD players, set=top boxes, etc.). OR Computer AUDIO AMPLIFIER DVD With Component jacks 8[...]

Preparation for using your new TV Connecting your TV Caution: Do not plug in the TV until you have finished connecting all of your equipment, Connecting to an antenna To enjoy the televison program transmitted by your local TV station, you need an indoor or outdoor antenna (not supplied). An outdoor antenna is necessary for superior picture quality[...]

Preparation for using your new TV Connecting HDMI Supports digital connections between HDMI = enabled AV devices such as (DVRs, DVD, BluRay, HDDVD, AV receivers and digital devices). No sound connection is needed for an HDMI to HDMI connection. NOTE: Some devices such as a DVR or DVD players require a HDMI signal to be set via the output in the dev[...]

Preparation for using your new TV For subscribers to Basic Cable TV Service For basic cable service not requiring a Converter/Descrambler box, connect the CATV 75 ohm Coaxial Cable directly into the Antenna Jack on the back of the television, For subscribers to Scrambled Cable "IV Service If you subscribe to a cable service which requires the [...]

Using the remote control Preparing the remote control for use Znstalling the remote control batteries 1, Open the battery cover on the back of the remote control, I 2, InstalltwoAAAsize(1,5V) batteries, Matchthe+ and = signs on the batteries to the signs on the battery compartment, 3, Close the battery cover, Note: 1,Disposeofyourbatteries inadesig[...]

Using the remote control Learning about the remote centre[ Power indicator Power ON/OFF ............................................... Select digital PICTURE: Select the picture Volume MENU: Call up the main menu OSD menu Up arrow ................................... OSD menu Left arrow OSD menu Down arrow CCD: Closed caption HTS/SAP: Hu[ti-channe[[...]

Understanding the TV features • Hultimedia - All in one TV receiver, Video Honitor and PC display, • Wider viewing angle for 16:9 and 4:3 display screens = over a 160 degree viewing angle and a 16:9 display panel, • Digital display device - Irrespective of magnetic or geomagnetic effects, this device accurately reproduces images without any d[...]

Basic operation Use [Hute] button Press the [Mute] button to mute the sound. Press the [Mute] button again to resume the sound, Select picture modes Press the [PICTURE] button to select the picture mode from four options: Standard, Movie, User and Vivid. In the "User" mode you can adjust the picture mode based upon your personal preferenc[...]

Basic operation Use [GUIDE] button Press the [GUIDE] button to display features of the ATSC program and the EPG function. Use [DISPLAY] button Press the [DISPLAY] button to view current source information. Use [EXIT] button Press the [EXIT] button to exit the OSD menu. Select channels by numbers To select a channel: Press the channel number you wou[...]

Basic operation Video mode adjustment 1. Press HENU to open the OSD option 2. Press A or Y to highlight Video, then press I_ to enter the Video menu"Refer to page 12 "Select picture mode . Press A or Y to highlight an option, then press _ or I_ to adjust the option. You can adjust: • Picture Mode = Adjusts the Picture Mode. You can sele[...]

Basic operation • Balance - Adjusts the volume of the left and right speakers. , Equalizer-You can select the frequency you want to adjust and change its value. , Surround Sound -Turns the surround sound effect on or off. • Auto Volume Control - Turns automatic volume control on or off. The option keeps the audio in a preset range to eliminate [...]

Basic operation Parental Control 1, Press MENU to open On Screen Display (OSD) option 2, Press A or Y to highlight Parental, then press i_ to enter the Parental menu, , When you first use this function, the default password is [0000], Once you input this password, you can enter, Press A or V to highlight an option, then press _ or I_ to adjust the [...]

Basic operation About HPAA Rating: The Motion Picture Association of America(MPAA) uses a rating system to qualify motion picture content. Television broadcasters employ a rating system to qualify the content of televison programs as well. The MPAA and TV ratings work with the V-CHIP feature and allow you to block out programming above the rating l[...]

Basic operation • Input Block - You can block the input source with this function. For example, if you want to block AV input, just highlight [AV] and press [ENTER].The AV input will not be seen in the screen. • Change Password = The first time you use this function, use the default password, If you want to change it, first enter the new passwo[...]

Appendix Troubleshooting Before calling a service technician, please check the following table for a possible cause of the problem and some solutions. Customer important notice: If the TV functions cannot be operated, unplug the AC cord from AC power source, wait at least 1 minute, then re-plug AC cord. This will reset the TV settings and should re[...]

Appendix Wall-mounting Bracket Installation Unit Dimension(unit: mm) Screw Diameter Screw Length(unit: mm) 200x200 M6 12 Remark: The specification of screw is just used on the back cabinet. NOTE: Wall mount bracket is not included with TV and mounting of wall mount bracket to wall may vary depending on brand and size of bracket, Customer should con[...]

Appendix Specifications IModei 37LC30S57 Diagonal display size 37Inches Television system American TV standard ATSC/NTSC system Audio multiplex BTSCsystem VHF: 2N13 UHF: 14N69 CATV:lN125 Channel coverage Digital Terrestrial Broadcast (8VSB): 2_69 Digital cable (64/256 QAM): 1_135 PC mode 640×480/60Hz, 800×600/60Hz, 1024x768/60Hz YPbPr/YCbCr mode [...]