Polaris Vac-Sweep 360 инструкция обслуживания

IMPOR T ANT INFORMA TION O WNER’S MANU AL SERIAL NUMBER[...]

www .polarispool.com Impor tant Inf ormation • Solar heating systems, oz one generators, and other air inducing equipment ma y cause air flow through the cleaner , adversely aff ecting cleaner balance and perf or mance. The dedicated cleaner line must be upstream of these compenents. • Highly chlorinated water can cause maintenance problems . A[...]

www .polarispool.com Congratulations on the purchase of y our new automatic pool cleaner , and thank y ou for choosing P olaris. The P olaris V ac-Sweep 360 is designed to giv e you years of dependable and efficient service. Like most mechanical de vices, the P olar is requires periodic adjustments, routine maintenance, and the replacement of certa[...]

www .polarispool.com F our quick steps to install and get maximum perf or mance from the P olaris 360: • Install the Universal Wall Fitting (UWF) with Quic k Disconnect and Eyeball Regulators • T est and adjust water pressure • Adjust f eed hose to fit pool length • Check f or proper wheel RPM (re volutions per minute) Install the Universal[...]

www .polarispool.com Installing Other P ool Connections If the pool does not hav e a dedicated retur n line, the P olar is 360 connects to most common retur n lines using special adapter kits a vailable f or purchase at a par ticipating P olaris dealer . F or pools with plastic-pipe retur n lines (without pipe threads) that are cut off flush with t[...]

www .polarispool.com 3 T est and Adjust W ater Pressure The P olaris is packaged with a pressure tester installed on the hose. Simply attach the hose to pool wall using the Quic k Disconnect fitting. T urn pump on, cover large hole with thumb and confir m that w ater is released from the Pressure Relief V alve. If water does not release from the Pr[...]

www .polarispool.com 4 Assemble Cleaner 1. Remov e the pressure tester from the hose by unscrewing the hose n ut and pulling off hose. 2. Use hose nut from the pressure tester to secure hose to the cleaner body at the f eed pipe. 3. The filter bag is packaged in the collar area on the cleaner body . Pull out the bag and snap the bag tie collar onto[...]

www .polarispool.com When oper ating correctly , the P olar is v acuums, sw eep s and scrubs all surfaces r andomly throughout the pool. The climbing ability of the P olaris depends on the pool’ s shape and w ater pressure or flo w . The P olar is climbs best in pools without sharp angles or cur ves in the transition from the pool floor to the po[...]

www .polarispool.com 1 9-100-1014 All-Purpose Bag* 1 2 9-100-1152 Housing, T urbine Upper 1 3 9-100-1114 Hub Cap 3 4 9-100-5107 E-clip, Stainless Steel 10 5 9-100-1108 Ball Bearing 8 6 C10 Tire, MaxT rax ® * 3 7 9-100-1008 Wheel, Double-side 2 8 9-100-1017 Belt Kit, Small and Large 1 9 9-100-7011 Shield, Bearing 3 10 9-100-1005 F rame 1 11 9-100-5[...]

www .polarispool.com If the P olaris cleaner displays the f ollowing actions , adjustments ma y be necessar y to restore perf or mance. Refer to the e xploded par ts diagram f or par t references . Action: Hangs up on steps or other obstacles longer than 3-1/2 minutes. Solution: 1. Check the wheel RPM. 2. V erify the back-up valv e is cycling. 3. A[...]

www .polarispool.com Action: Sweep hose constantly spra ys water out of the pool. Solution: 1. Adjust the speed of the s weep hose by tightening the adjustment screw . 2. Replace the s weep hose scrubber (par t #9-100-3105) if it is worn or missing. 3. Add a s weep hose weight (order par t #B2) to keep the s weep hose from spra ying. Action: The cl[...]