Planar PJT195RW инструкция обслуживания

[...]

1 Contents Preface ......................................................................................... 2 Installation ................................................................................... 4 Unpacking ..................................................................................................................................[...]

2 Preface This manual is designed to assist users in setting up and usin g the LCD Monitor. Information in this document has been carefull y checked for accuracy; however, no guar antee is given to the correctness of the contents. The information in this document is subject to change without notice. This do cument contains proprietary information p[...]

3 Important Safety Instructions Please read the following in structions carefully. Th is manual should be retained for future us e. 1. To clean LCD Monitor screen; -- Power off LCD Monitor and unplug the AC Cord. -- Spray a non-solvent cleaning solution onto a rag. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor near a[...]

4 Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable wor kspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sur e that LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monitor uses very little power, some ventilation is needed to ensure that [...]

5 Viewing Angle Adjustment The LCD Monitor is designed to allow users to have a comfortable viewing angle. The viewing angle can be adjusted from -2°to +90°.(See fig. 1-1) Figure 1-1 Warning Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand. [...]

6 Connecting the AC Power 1. Connect the power cord to the LCD Monitor.(See Fig. 1-5) 2. Conn ect the power cord to an AC po wer source. Figure1-5 Connecting the Audio Cable 1. Connect the audio cable to the "LINE OUT" jack on your PC's audio card or to the front panel' s “AUDIO OUT” jack of your CD ROM drive. (See Fig. 1-6)[...]

7 Display Controls User Controls A brief description and the location of all LC D Monitor functions controls and indicators: Figure 2-1 1 Power LED will be Green when monitor is on, be yellow when in power saving mode, be dark when monitor in off mode. 2 Power ON/OFF switch. Push to power on or power off. (Toggle switch) 3 Menu/Enter Shows main OSD[...]

8 Adjusting the Monitor's Display Main OSD Main Menu icon Sub Menu item Sub Menu item Description STANDARD Default Setting. Reflec ts native display capability. MOVIE Displays scenes in clearest detail. Pictures and photographs appear in vibrant colors with sharp detail. GAME Enhances color. TEXT Optimal balance of brightness and contrast prev[...]

9 FULL Selects wide format for display. Expansion Mode ASPECT Selects 4:3 format for display. Auto Adjustment Auto adjusts the H/V Position, Phase and Clock of picture. (available in analog mode only) H. Position Adjusts the horizontal position. (available in analog mode only) V. Position Adjusts the vertical position. (available in analog mode onl[...]

10 Information Shows the resolution, H/V frequency and input port of current input timing. Icon Function Description 9300 CIE coordinated Color Temperature of 9300°K Sets the CIE coordinate color temperature to 9300°K 7500 CIE coordinated Color Temperatur e of 7500°K Sets the CIE coordina te color temperature to 7500°K 5000 CIE coordinated Colo[...]

11 OSD Lock Out Function When monitor is in normal display, you can enable the “OSD LOCK OUT” function. Option 1 : OSD & Power button lock-all 5 buttons including the “POWER” button are locked. Press and hold the “ Aut o / Ex i t ” and “ ”buttons at the same time for 3 seconds to lock all 5 buttons The monitor will show an “OS[...]

12 Technical Information Specifications LCD Panel Size 19W" Display Type Active matrix color TFT LCD Resolution 1440 x 900 Display Dot 1440x (RGB) x 900 Display Color 16.7M with FRC or Dithering Video Input Signal Analog RGB 0.7Vp-p Input Impedance 75 Ohm ± 2% Polarity Positive, Negative Amplitude 0 - 0.7 ± 0.05 Vp Multi-mode Supported Horiz[...]

13 Power Management Mode Power Consumption* AC Input LED Color DPM On 42 W maximum 240 VAC Green DPM Off 2 W maximum 240 VAC Yellow DC switch off 1 W maximum 240 VAC Dark * Meeting VESA DPM requirements measured from A C Input end of AC power cord. S y n c I n p u t A n a l o g Signal Separate TTL compatible horizontal and vertical synchronization.[...]

14 Standard Timing Table If the selected timing is NOT included in table below, th is LCD monitor will use the most suitable available timing. SYNC WIDTH FRONT PORCH BACK PORCH TIMING NAME FH (KHz) FV (Hz) SYNC POLARITY TOTAL/ ACTIVE (DOT / LINE) (DOT / LINE) PIXEL FOREQ.(MHz) 640x350 31.469 + 800 640 96 16 48 VGA-350 70.087 – 449 350 2 37 60 25.[...]

15 SYNC WIDTH FRONT PORCH BACK PORCH TIMING NAME FH (KHz) FV (Hz) SYNC POLARITY TOTAL/ ACTIVE (DOT / LINE) (DOT / LINE) PIXEL FOREQ.(MHz) 1024x768 60.023 + 1312 1024 96 16 176 VESA-768-75Hz 75.029 + 800 768 3 1 28 78.75 1024x768 60.24 – 1328 1024 96 32 176 80 1152x864 54.054 + 1480 1152 96 40 192 (60Hz) 59.27 + 912 864 3 13 32 80 1152x864 63.851 [...]

16 Troubleshooting This LCD Monitor has been pre-adjusted using factor y standard VGA timings. Due to the output timing differences among various VGA cards in the market, users may initial ly experien ce an unstable or unclear displa y whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. R[...]

17 Touch Screen Driver Installation The PJT155R/ PJT175R/ PJT195RW is available with USB connection. The touch software is located on the enclosed CD-ROM for these operating systems: Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded, Linux, Apple® Mac OS Please Note: The PJT155R/ PJT175R/ PJT195RW is Microsoft® Windows® HID (Human Int[...]

18 PJT155R/ PJT175R/ PJT195RW Install Instructions If you are using a PC running Wind ows® 7, VISTA, XP, 2000, ME, 98, NT4.0, follow the instructions below: 1. Power on the PC. 2. Be sure the USB cable is connected from the PC to the LCD display. 3. Download the driver online and execute. 4. Follow the step-by-step instructions as shown on the pop[...]

19 Product Registration and Technical Support Register Your Planar Products Today Thank you choosing Planar. To assure you receiv e all the benefits of your Planar product and services, re gister your Planar product today. Visit our website to register your product at http://www.planar.com/support /product_registration.html Cables, Replacement Lamp[...]

Customer Service 24x7 Online T echnical Suppor t: http://ww w .planar.com/support 1195 NW Compton Drive Beaverton, OR 97006-1992 T el: 1-866-PLANAR1 (866-752-6271), or +1 503-748-5799 outside the United States, Hours: 24 hours a day , 7 days a week 2012 Planar Systems , Inc. Planar is a register ed trademark of Planar Systems , Inc. Other brands an[...]