Orion TV32PL690D инструкция обслуживания

Operating Instructions Before operating the unit, please read this manual tho roughly . L CD- TV Model-No .: TV26PL690 TV32PL690(H) TV32FX6900(H) TV40FX6900(H) TV32PL690H TV32FX6900H TV40FX6900H 3FX0114A_EN.indd 1 3FX0114A_EN.indd 1 4/21/11 6:19:01 PM 4/21/11 6:19:01 PM[...]

2 F eatures Headphone W arning Loud music can damage y our hearing irre versibly , there fore do not set the v olume to a high lev el when listening through headphones, particularly for e xtended listening periods . Battery notice (valid in EU only) Look after our en vironment - contact y our local authorities for advice on how to saf ely dispose o[...]

3 Contents F eatures .........................................................2 Contents ........................................................3 Important safety information ...........................4 Location of controls ........................................7 Remote Control ..............................................8 Antenna connection [...]

4 Important safety information This unit has been produced according to all current saf ety regulations. The following saf ety tips should safeguar d users against careless use and the dangers connected with such use. Although this appliance has been carefully manuf actured and rigorously check ed prior to leaving the f actory , as with all electri[...]

5 Important safety information How to attach the stand NO TE: • Unplug the A C cord from the A C INPUT terminal. • Befor e beginning this process, assur e that TV is laid on a clean, safe , and cushioned space to av oid any damage to the unit. • Do not touch or press the TV -screen, glass might break under pressur e. • Be sure to follo w th[...]

6 Important safety information W ARNING T o pre vent fir e, ne v er place an y type of candle or open flame on the top or near the TV set. Moving the unit or carrying by hand When the unit is mov ed a long wa y , unplug the power cor d and disconnect the antenna, connecting cables and any f all-prev ention apparatus . • Moving without doing so co[...]

7 Location of contr ols Description of Indicators and Controls 1. Remote sensor 2. (Standby/On) indicator: The LED indicator lights up red in standby mode , and green in the pow er ON mode. 3. Loudspeakers 4. (P ower)-k e y: Preparation: Connect power-cable to A C220~240V/50Hz. a) If standby-LED is red, y ou may po wer-off . T o power-off , press p[...]

8 Remote Control F unction P age Enter standby mode or turn on the po wer 11 Display pr ogram information 13 Select an input source 12 Select picture format 18 Select channel Select T eletext page Enter passw ord 13 14 16 Select between the a vailable broadcast audio 13, 14 Display the EPG (Electr onic Progr . Guide) 16 Activ ate menu 11 Exit the m[...]

9 Remote Control Install the batteries Use batteries type UM4 (AAA-Size). Do not use old or weak batteries. The remote control ma y not work pr operly with a weak voltage fr om such batteries. Replace exhausted batteries with ne w ones. Never try to recharge normal batteries - this could cause an explosion. Note: Exhausted batteries can leak corros[...]

10 Antenna connection Note: Befor e you connect other appliances: T o avoid potentially damaging y our set, mak e sure all items are s witched off and disconnected from the mains power when y ou mak e the connections. Arrange the desired connection. When you ha ve finished making the connections , reconnect the mains pow er to the unit and switch i[...]

11 Auto setup The built-in tuner allows to r eceive TV -channels from analog cable-tv or D VB- T . If, ho we ver , you are receiving TV -channels via separate receiv er , no need to run the TV’ s auto-tuning. Just set your language here and then jump to ne xt chapter . When initially operating the TV after purchase , the menu: ‘ Auto Installati[...]

12 Selecting the input source Press INPUT SELEC T to view a signal from another device connected to y our TV , such as a V CR or D VD play er . Y ou can select each input source depending on which input jacks y ou used to connect your de vices. T o select the video input source, press INPUT SELECT or /. Then press ENTER within 6 seconds. On-screen [...]

13 Channel selection With the numbered buttons . Example: No . 2: Press 0 and within 2 seconds , press 2 . No . 29: Press 2 and within 2 seconds , press 9 . No . 929: Press 9 , 2 , 9 same as abo ve . Press P + or – to change up or down a channel. This takes appr ox. 2 seconds. If the auto search only stored 5 stations, only these 5 will appear . [...]

14 The follo wing types of broadcast are possible with NICAM transmissions Y ou can see the each signal type in the information display (P .13) when you press or change a channel Nicam Stereo broadcast signal Nicam Stereo 576i SD 902 Nicam Mono broadcast signal Nicam Mono 576i SD 902 Nicam Dual1 broadcast signal Nicam Dual1 576i SD 902 Nicam Dual2 [...]

15 Remarks on D VB- T sy stem D VB- T is at present still being dev eloped. Y ou can get information regarding the current stage of de velopment from y our specialist retailer . As a digital service DVB- T basically works differently to pr evious analogue TV reception. Reception P ossibilities: In contrast to cable TV , DVB- T is receiv ed via room[...]

16 P ass word Setup (P arental lock) P arental lock is a function of the channel provider . If it is not supported by the channel, parental lock is without function. Currently there are no channels supporting parental lock. 1 Press MENU . Select then press . 2 ‘P assw ord’ will appear . Press ‘ 0 0 0 0 ’ using the Number buttons (0-9) . (Th[...]

17 Resolution and picture quality Broadcast wide screen films in diff erent resolutions . The f ollowing table sho ws the resolution options f or wide screen film broadcast media. Broadcast media Resolution of the wide screen signal Analogue cable TV Digital cable TV D VB- T Satellite (D VB-S) DV D H DT V Satellite (D VB-S2) Blu-ra y- Disc 432i x 7[...]

18 Picture Size The required picture f ormat can be set by pr essing the PICTURE SIZE button. Press PICTURE SIZE until the required f ormat is display ed. Y ou move thr ough the follo wing formats when y ou press the button: Auto , 4:3, 16:9, 14:9, Cinema, Real (HDMI mode only). Auto The picture is automatically only then shown in a format-filling [...]

19 Other conv enience functions Y ou can change the default settings to con venience use . Selected Items Setup hint Picture Pref erence Memory Y our personal preferences Sport Bright and dynamic picture (factory-set) Standard Standard picture quality (f actory-set) Movie Movie-lik e picture setting (factory-set) Brightness / Contrast / Colour / Ti[...]

20 Other conv enience functions Selected Items Setup hint Country Set the country where you use this product. Audio Language Select pref erred audio language, if the current watching D TV channel has more than one audio language. This option is not av ailable for A TV channel. • Audio Language 2nd Select second pref erred audio language, if the c[...]

21 Selected Items Setup hint Subtitle Analog Subtitle If the receiving analog signal has the T eletext subtitle page, it displa ys the T eletext subtitle. On / Off Digital Subtitle Language Select pref erred subtitle language, if the current watching D TV channel has more than one subtitle language. Digital Subtitle Language 2nd Select second pref [...]

22 PC connection Follo w these steps: On y our PC monitor choose a resolution of 1920 x 1080 at 60Hz and sav e this configuration. Shut down your PC and connect the shut off LCD TV . Use a screensa ver to a void burning-in of static picture content. Use a PC- VGA cable (not supplied) to connect the L CD-Monitor to your PC . Make the connections car[...]

23 The HDMI input receives digital audio and uncompr essed video from a HDMI equipped de vice or uncompressed digital video from a D VI equipped de vice. When you connect to a D VI de vice with a HDMI-to-D VI adapter cable, it only transf ers the video signal, so it is necessary to use separate analogue leads to transfer the audio signals . Select [...]

24 Connection to other equipment 2. Connect video recor der (e.g. to record from D VB- T) VCR TV (All illustrated SCART cables and antenna cables are not supplied) TV Satellite antenna Satellite receiver Video recor der 1. Connecting to other equipment Attention: Pr eparation: • Disconnect all equipment from the A C-supply , to pre vent an y poss[...]

25 YP b P r (A) (B) Stereo amplifier Audio input (Coaxial digital lead, not supplied) Surround sound amplifier system DIGITAL AUDIO COAXIAL OUT (Scart-RCA cable, not supplied) Connection to other equipment 5. Connecting to a D VD pla yer or other A V device with Component Video outputs If your D VD pla yer (or other de vice) has Component Video o[...]

26 T roubleshooting table Please check the follo wing list before r equesting service. Symptom P ossible solution P age No picture, no sound Switch on the set. Check that the mains power outlet is properly connected. Select appropriate input mode. Unplug unit for 1 minute , then plug it back in. 7 12 No reception Hav e you tuned in the TV stations?[...]

Information on softw are license The follo wing open source softwar e component is included in this product: * Fr eetype 2.1.9 Portions of this softwar e are copyright © 1996-2002 The FreeT ype Project (www .freetype.org). All rights reser ved. 3FX0114A_EN.indd 27 3FX0114A_EN.indd 27 4/21/11 6:19:43 PM 4/21/11 6:19:43 PM[...]

J3FX01 14A SH 1 1/ 0 3 P 3FX0114A_EN.indd 28 3FX0114A_EN.indd 28 4/21/11 6:19:43 PM 4/21/11 6:19:43 PM[...]