Meade te346w инструкция обслуживания

TE346W Slim W eather For ecaster with Indoor/ Outdoor T emperatur e, Indoor Humidity and Atomic Clock USER MANUAL[...]

INTRODUCTION Thank you for selecting a Meade Instruments W eather Forecaster . This device combines precise time keeping, monitoring and displaying of current temperature data from up to three remote locations (additional sensors are required). Meade Instruments is the world’ s leading designer and manufacturer of telescopes for professional and [...]

INST ALLA TION Communications between the main unit (receiver) and the remote sensor (transmitter) is wireless. This allows you to greater flexibility in choosing the location of remote sensor . The remote transmits data up to 164 feet (50 meters) over an open, unobstructed area. The remote sensor can be located either indoors or outdoors, allowing[...]

REMOTE TEMPERA TURE SENSOR (TS01) FEA TURES • Remote data transmission to the main unit via 433 MHz frequency • Single transmission channel • Case can be wall mounted using accessory hanger A. BA TTERY COMP ARTMENT • Holds two AAA-size batteries B. W ALL-MOUNT RECESSED HOLE • Mounts the remote sensor on the wall BA TTERY INST ALLA TION NO[...]

PLACEMENT • The remote sensor should be placed under eaves or a similar location with free air circulation, sheltered from direct sunlight and extreme weather . • Ideally , place the remote sensor over soil, rather than asphalt, which would cause false readings. • A void placing the remote sensor near sources of heat, such as chimneys and hea[...]

FRONT REAR A J K L C B F E D H I G 6[...]

A. WEA THER/ OUTDOOR TEMPERA TURE window B. INDOOR TEMPERA TURE/ HUMIDITY window C. CLOCK window D. DOWN (? ) button • Select the next available mode • Press and hold for 2 seconds to search for wireless signal from remote sensor . • Decrease parameters. G. ALARM button • When time mode has been selected, press once to display the alarm tim[...]

BA TTERY INST ALLA TION • Remove the battery door located at the back of the main unit. • Insert two (2) CR2032 lithium cell batteries and replace the battery compartment door . PLACEMENT • When mounting the main unit on the wall or vertical surface, fold the table stand back into the unit. • Make sure that the main unit is locating within [...]

SEARCH FOR REMOTE SENSORS • The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN (? ) button. OPERA TION • T o select the indoor/ outdoor temperature mode, press UP (? ) or DOWN (? ) until the icon flashes with a beep sound alert. VIEWING REMOTE (CHANNEL) TEMPERA TURE Static Display:[...]

CLOCK WINDOW WWVB RADIO CONTROLLED TIME The NIST (National Institute of Standards and T echnology) radio station (WWVB) is located in Ft. Collins, Colorado. It transmits an exact time signal continuously throughout the most of the continental United States at 60 KHz frequency . The main unit can receive this WWVB signal through the internal antenna[...]

• The atomic clock receiver is programmed that it will search for the time signal daily for 0:00, 3:00, 6:00, and 12:00 am. • T o enable or disable the atomic time receiver , press and hold UP (? ) button for 3 seconds. If time reception is activated, a tower icon will start flashing. If reception is disabled, the tower icon will disappear . ?[...]

SETTING THE ICE W ARNING ALARM (PRE-AL) If W eekday (W) or Single day (S) alarm is MODE, the Ice W arning Alarm (Pre-AL) can be programmed. • Press ALARM button once to enter into the Ice W arning Alarm setting mode. The abbreviation OFF with a PRE-AL next to it will be displayed. • Press and hold ALARM button for two seconds. The number 30 wil[...]

PRECAUTIONS This product is engineered to give you years of satisfactory service if handled carefully . Here are a few precautions: • Do not immerse the units in water . • Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits. • Do not subject the product to excessi[...]

FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly [...]

Battery Safety Instructions • Always purchase the correct size (2 x 1.5V AAA, 15A/15AC ANSI, LR6 IEC), (2 x ANSI/NEDA-5004LC, IEC-CR2032) and grade of battery most suitable for the intended use. • Replace all batteries of a set at the same time. • Clean the battery contacts and also those of the device prior to battery installation. • Ensur[...]

Meade Instruments Corp. 27 Hubble Irvine, CA 92618 U.S.A. © 2011 Meade Instruments Corp. All Rights Reserved. All user manual contents and information are subject to change.[...]