Lenoxx CD-106 инструкция обслуживания

® COMP ACT DISC PLA YER AM/FM STEREO CASSETTE RECORDER MODEL CD-106 OPERA TING INSTRUCTIONS  PLA YS ALL MUSIC COMP ACT DISCS  FULL Y PROGRAMMABLE CD PLA YER WITH REPEA T  RECEIVES AM/FM STEREO BROADCASTS  RECORDS FROM CD, RADIO, OR BUIL T -IN MICROPHONE  FM STEREO AND POWER LED INDICA TORS  2 W A Y POWER - AC/DC  BASS BOAST SY[...]

SAFETY INSTRUCTIONS The lightning flash and arrow head within the triangle is a warning sign alerting you of dangerous voltage inside the product. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: T O REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SER VICEABLE P A R TS INSIDE. REFER SER VICING T O QUALIFIED SERVIC[...]

SAFETY INSTRUCTIONS EXAMPLE OF ANTENNA GROUNDING AS PER NEC - NA TIONAL ELECTRICAL CODE It is the intent of Lenoxx that this product be used in full compliance with the copyright laws of the United States and that prior permission be obtained from copyright owners whenever copying tapes or CD s . Do not apply oil or petroleum products or solvent[...]

1. Use only the type and size of batteries mentioned in the operating instructions booklet (batteries are not included with this set, please buy the proper batteries). 2. Do not dispose the batteries into a fire. The cells may explode. Check with local codes for possible special disposal instructions. 3. Do not open or mutilate the batteries. Relea[...]

Playing a CD 1 Slide the Function Switch to CD position (power on). 3 Close the CD Door by pushing it down at the position marked CLOSE. 4 1 2 O PEN Press the CD Door Open button to open the CD Door and place the CD in the CD compartment. The label side of the CD should face upward. 2 Press the CD Play/Pause Button. The player plays all the tracks [...]

Use these buttons for additional operations T o Press or Adjust Adjust the volume V olume Control Stop playback Pause playback The Play/Pause Lamp will flash during pause. Press again to resume play . Go to the next track Go back to the previous track Locate a point in a song or while playing, press and hold down until you find the point. Tip When [...]

Playing CD tracks repeatedly (Repeat Play) T o repeat Press a single track (song) Press the Repeat Button once all the tracks (all songs) Press the Repeat Button twice 1. Slide the Function Switch to CD position. 2. Press the CD Repeat Button. T o cancel Repeat Play Press the Repeat Button until the Repeat Lamp is of f. 3. Press . 4. You may select[...]

Y ou can make a program of up to 19 tracks in the order you want them to be played. 1. Slide the Function Switch to CD position. Make sure the CD is stopped. 2. Press the Program Button. The number 0 and the Program Lamp will flash. 3. Press or to select the tracks you want to program in the order you want. 4. Press the Program Button to conf[...]

Listening to the radio Connect the supplied AC power cord or batteries (see page 14). Slide the Function Switch to RADIO position (power on). 1 2 3 1 2 3 Slide the Band Switch to the proper band position that you want. Tune into the station you prefer using the T uning Control. Adjust for the clearest sound. 8 4 This indicator will light up when re[...]

Use these buttons for additional operations To Slide or Adjust Adjust the volume V olume Control Ti p When the player is receiving from a FM stereo broadcast, the FM Stereo indicator will be on. T urn of f the Radio Slide the Function Switch to T APE position T o improve broadcast reception Reorient the antenna for FM or FM Stereo. Reorient the pla[...]

Playing a tape Connect the supplied AC power cord or batteries (see page 14). Press the Stop/Eject Button to open the tape compartment and insert a recorded tape. Close the door . 32 2 3 Press the Play Button. The player turns on and starts playing. S T OP/EJECT PLA Y Slide the Function Switch to T APE position. 1 10 FU L L R EEL EMPT Y R EEL 1 FU [...]

Use these buttons for additional operations To Stop playback Eject the cassette Get dif ferent sound effect Bass Boost Switch Ti p Press or Adjust Adjust the volume V olume Control Fast forward or rewind the tape Fast Forward Button or Rewind Button Pause playback Pause Button Press again to resume play after pause. Stop/Eject Button Stop/Eject But[...]

Recording on a tape Connect the supplied AC power cord or batteries (see page 14). Press the Stop/Eject Button to open the tape compartment and insert a blank tape. Select the program source (AM, FM, CD, or , built-in microphone) you want to record. 1 3 1 2 S T OP/EJECT T o record from the CD player, insert a CD and follow the steps to play a CD (s[...]

Use these buttons for additional operations To Turn of f the power Press the Stop/Eject Button and slide the Function Switch to T A PE position. Ti p • Adjusting the V olume or Bass Boost Switch will not af fect the recording level. Press or Adjust Stop recording Stop/Eject Button Pause Button Press the button again to resume recording. Pause rec[...]

Choosing the power sources Y ou can use the AC power or batteries as a power source. Tip The plug of the AC power cord is polarized and only fits one way into the wall outlet and back of the set. If this plug does not match your outlet, do not force it. Reverse it and try again. Tip Replace the batteries when the Power/Batt. Lamp gets dim or when t[...]

Precautions On safety  As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only .  Should any solid object or liquid fall into the set, disconnect the power , and have it checked by qualified personnel before operating it any further . On powe[...]

Precautions (continued) Notes on CDs  Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.  Do not use solvents such as benzene, thinner , commercially available cleaners or anti-static spray intended for vinyl LPs.  Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it [...]

Maintenance Cleaning the lens If the lens becomes dirty , it may cause a skipping of sound during CD operation. Clean with a commercially available lens cleaner blower . Cleaning the tape heads and tape path Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours o[...]

T roubleshooting Problem Remedy The power is not on.  Connect the AC power cord to a wall outlet securely .  Make sure the batteries are inserted correctly and they are fresh. There is no sound.  Make sure the Function Switch is at the right position as you want.  Adjust the volume.  Unplug the headphones when listening through speak[...]

Specification 19 GENERAL DESCRIPTION Power source: AC 120V , 60Hz 12W atts DC 12V (8 size C batteries) (we recommend alkaline batteries for longer life) Speakers: 3  8 ohm x 2 Output power: 2W / channel Dimensions: Width: 12 1 / 4  Depth: 10 5 / 8  Height: 7 1 / 8  W eight: 7LBs (without batteries) CD SECTION Plays disc type: Any [...]