KitchenAid KHPF 9010 инструкция обслуживания

KHPF 9010 KHPS 9010[...]

[...]

Product description and symbols 4 Using the burners 4 Practical advice on using the hob 5 Positioning the pan supports and wok suppor t 5 Hood and cabinetry clearances (mm) 6 Injector table 6 W arnings and suggestions 7 Safeguarding the environment 8 Installation (Flush and T raditional fitting) 9 Gas connection 9 Electrical connection 10 Fixing th[...]

1. Removable pan supports 2. 1 kWh auxiliary burner 3. 1.65 kWh semi-fast burner 4. 3 kWh fast burner 5. 1.65 kWh semi-fast burner 6. Professional wok burner 7. Auxiliary burner control knob 8. Semi-fast burner control knob 9. Fast burner control knob 10. Semi-fast burner control knob 11. Professional wok burner control knob Control Symbols Off Max[...]

Read the instructions to get the best out of your hob. • Use pans with a similar diameter to the burner (see the table on this page). • Use flat bottomed pans except with the wok support. • Do not use excessive water when cooking foods and use the lid. • Ensure that pans are fully supported by the pan supports and do not protrude over the e[...]

Category II2H3+ Electric P ower: 230 V - 50 Hz If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob. Hood and cabinetry clearances (mm) Injector table 6 T ype of gas used T ype of burner Injector label Control primary air (X)(mm) Nominal heat flow kW Nominal consumption R[...]

T o get the most out of your hob, please read the instructions carefully and keep them for future consultation. • These instructions are only valid in the countries whose destination symbol is shown on the serial number plate on the hob. • The packing (plastic bags, expanded polyurethane, etc) pose a potential threat to children and should be d[...]

P acking The packing material is 100% recyclable and is labelled with the recycling symbol . Please dispose of all packing responsibly and carefully . Product This appliance is marked according to the European Directive 2002/96/EC, W aste Electrical and Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly , you will h[...]

T echnical information for the installer • This appliance can be installed into a 20mm - 50mm thick worktop. • If no oven is to be installed below the hob, a panel must be fitted under the hob to prevent hob damage and protect the cupboard contents. This panel must cover the whole of the underside of the hob and must be positioned so that an ai[...]

The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. • The appliance must be earthed. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch. • If damag[...]

Important: The following procedure must be carried out by competent technical personnel only . The hob can be installed on, or into different types of materials, such as masonry , metal, wood and heat resistant laminate coated wood (90°C). Cut an opening in the worktop to the dimensions shown in the diagram. Note: For laminated worktops with a lam[...]

Note: Refer to the injector table to ensure the correct type of injector is to be fitted. T raditional burners (T) 1. Remove the pan supports (A). 2. Remove the burners (B). 3. Unscrew the injector (C) with a no 7 box spanner . 4. Replace the injector with one suitable for the new gas type. 5. Replace burners and pan supports. Note: Before installi[...]

T o fit the double crown wok burner: Insert in the following order: 1. burner ring ( A ); 2 . decorative covering ring ( B ); 3. external burner cap ( C ); 4. internal burner cap ( D ). Note: make sure that: 1. the locating pin for the burner ring ( A ) is inserted correctly in the slot on the burner unit. 2. that the locating pin on the external b[...]

Always disconnect the hob from the electrical power supply and wait until it cools before cleaning and/or doing maintenance work. In order to keep your hob in good condition, you must keep it clean, removing any food residue each time you use it. Cleaning the hob surface: o the stainless steel surface may become stained if it comes into contact wit[...]

If the hob is not working properly , work through this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interrupted and that the control knob is turned fully on. 2. the gas supply has not run out. 3. the openings on the burner have beco[...]

5019 719 01135 Printed in Italy n 02/07 GB[...]