JVC LVT1358-001A инструкция обслуживания

MICRO COMPONENT SYSTEM UX-S59 —Consists of CA-UXS59 and SP-UXS59 INSTRUCTIONS LVT1358-001A [B] g Cover[B]_UX-S59.fm Page 1 Tuesday, March 15, 2005 12:10 PM[...]

G-1 Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an [...]

G-2 Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for venti[...]

G-3 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to u[...]

1 Contents Introduction ........................................................ 2 Precautions.......................................................................... 2 How to Read This Manual .................................................. 2 Getting Started ................................................... 3 Step 1: Unpack..................[...]

2 Introduction Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System. • Leave sufficient distance between the System and the TV. • Keep the speakers away from [...]

3 Getting Started Step 1 : Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Step 2 : Prepare the Remote C[...]

4 Step 3 : Hook Up If you need more detailed information, see page 6. AM EXT GND AM EXT GND AM LOOP ANTENNA Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary. Turn the power off to all components before[...]

5 ANTENNA AM EXT GND AM LOOP FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Non-striped Black striped 3_Connection.fm Page 5 Monday, March 28, 2005 2:24 PM[...]

6 To assemble and connect the AM loop antenna To assemble the AM loop antenna To connect the AM loop antenna Make sure to connect the wire correctly: The white end to AM EXT, the black end to GND. • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. • Mak[...]

7 Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Disc tray indicators • 1–5: Disc tray number •: Tray indicator – Lights when the disc is detected. – Blinking whil[...]

8 Daily Operations —Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. • Without pressing STANDBY/ON , the System turns on by pressing one of the source selecting buttons in the next step. 2 Select the source. Playback automatically starts if the selected source is ready to start. • If you press AUX, start playback sou[...]

9 Listening to the Radio To select the band (FM or AM) To tune in to a station While FM or AM is selected... Frequency starts changing on the display. When a station (frequency) with sufficient signal strength is tuned in, the frequency stops changing. • When you repeatedly press the button, the frequency changes step by step. To stop searching m[...]

10 To tune in to a preset station 1 Select a band (FM or AM). 2 Select a preset number for the station you store. Playing Back a Disc This System can play back the following discs—regular CD and CD-R/CD-RW (recorded either in the audio CD or MP3 format). • Caution for DualDisc playback The Non-DVD side of a “DualDisc” does not comply with t[...]

11 Playing Back Other Equipment To connect other equipment By using an stereo mini plug cord (not supplied), you can connect equipment with analog audio output jacks such as an MD player, or a TV, etc. If the audio output on the other equipment is not stereo mini plug type, Use a plug adapter to convert the stereo mini plug to the corresponding plu[...]

12 Adjusting the Volume Adjusting the Volume You can adjust the volume level from level 0 (VOL-MIN) to level 31 (VOL-MAX). To drop the volume in a moment Adjusting the Sound To emphasize the sound—SOUND TURBO This function emphasizes the sound. To reinforce the bass sound —AHB PRO You can reinforce the bass sound to maintain rich, full bass at [...]

13 Changing the Display Brightness —DIMMER You can dim the display window. Setting the Clock Without setting the built-in clock, you cannot use the Daily Timer (see page 19). • To exit from the clock setting, press CLOCK/TIMER as required. • To go back to the previous step, press CANCEL. 1 Activate the clock setting mode. • If you have alre[...]

14 Receiving FM Stations with RDS Radio Data System (RDS) allows FM stations to send an additional signal along with their regular program signals. • When tuned to an FM station which provides the RDS service, the RDS indicator lights on the display. This System can receive the following types of RDS signals. To show the RDS information While lis[...]

15 3 Start searching. The receiver searches 30 preset FM stations, stops when it finds the one you have selected, and tunes in to that station. • If no program is found, “NOT” and “FOUND” appear alternately on the display. • To stop searching any time during search, press PTY SEARCH. To continue searching after it stops on an unwanted s[...]

16 Programming the Playing Order— Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You cannot enjoy MP3 discs for program play. • You can repeat all the programmed tracks by pressing REPEAT. 1 Before starting playback, press PROGRAM. 2 Select a disc by pressing CD 1 – CD 5. 3 Select tracks[...]

17 To check the programmed contents While the PRGM indicator is shown on the display and before playback... To modify the program While the PRGM indicator is shown on the display and before playback... To exit from Program Play While the PRGM indicator is shown on the display... Pressing 7 also cancels Program Play. • While in Program Play (PRGM [...]

18 Playing Repeatedly—Repeat Play You can repeat playback. For CD: For MP3 (Track mode): For MP3 (Group mode): Prohibiting Disc Ejection—Child Lock You can lock the disc trays so that no one can eject the loaded discs. • This is possible while the System is on standby. While the disc trays are closed... • Only CD 1 0 can work for this funct[...]

19 Timer Operations Setting the Timer Using Daily Timer, you can wake up with music, etc. • You can store three Daily Timer settings; however, you can activate only one of Daily Timers at the same time. • To exit from the timer setting, press CLOCK/TIMER as required. • To correct a misentry during the process, press CANCEL. You can return to [...]

20 2 Make the timer setting as you want. 1 Set the hour then the minute for on-time. 2 Select the playback source—“TUNER FM,” “TUNER AM,” “CD,” or “AUX IN.” 3 For “TUNER FM” and “TUNER AM”: Select a preset number or “P – – –” by pressing PRESET UP or PRESET DOWN, then press SET. For “CD”: Select a disc by pre[...]

21 Additional Information Learning More about This System Daily Operations—Playback (see pages 8 to 11) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be [...]

22 Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. General: Adjustments or settings are suddenly canceled before you finish. ] There is a time limit. Repeat the procedure ag ain. Operations are disabled. ] The built-in microprocessor may malfunction due to external el[...]

23 Specifications Amplifier section Output Power: 120 W (60 W + 60 W) at 6 Ω (10% THD) Speakers/Impedance: 6 Ω – 16 Ω Audio Input AUX: 400 mV/50 k Ω Tuner section FM tuning range: 87.50 MHz – 108.00 MHz AM (MW) tuning range: 522 kHz – 1 629 kHz CD player section Dynamic range: 85 dB Signal-to-noise ratio: 85 dB Wow and flutter: Immeas[...]

24 Main unit 7 Remote sensor 8, 20 8–10 9, 10, 16, 17 8, 12 10, 16 8 12 13 11 ST ANDBY PHONES AUX VOLUME SOUND TURBO DIMMER DOWN UP CD 1 CD 2 CD 3 CD 4 CD 5 00000 CD FM/AM AUX 5-CD 5-CD CHANGER, PLA Y&EXCHANGE 8_AdditonalInfo.fm Page 24 Wednesday, February 16, 2005 5:47 PM[...]

0305MWMMDWBET EN © 2005 Victor Company of Japan, Limited UX-S59 MICRO COMPONENT SYSTEM Cover[B].fm Page 2 Wednesday, February 16, 2005 5:47 PM[...]