JBL 2.4G инструкция обслуживания

CONTROL ® 2.4G JBL ® ON AIR OWNER’S GUIDE ®[...]

2 Declaration of Conformity We, Harman Consumer Group International 2, route de T ours 72500 Ch â teau du Loir France declare in own responsibility that the product described in this owner ’ s manual is in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001 Laurent Rault Harman Consumer Group International Ch â teau du Loir[...]

READ FIRST! Important Safety Precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’ s instructions. 8. Do not install near [...]

4 THANK YOU FOR CHOOSING JBL ® For more than 60 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We’re confident that the JBL system you have chosen will provide every note of enjoyment that you expected – and that when you [...]

5 NOTES: For the sake of simplicity, throughout this manual we have used the term “source” when describing connections and operation. This would apply to any device such as an A/V receiver , audio component, computer or portable music player . The JBL On Air Control 2.4G is designed for use in most countries worldwide, depending upon local regu[...]

6 Some computer sound cards feature preamp outputs in addition to or instead of speaker outputs. If your computer does feature preamp outputs, we recommend that they be used instead of speaker outputs. If you would like to connect the computer to the JBL On Air Control 2.4G using preamp outputs on your computer , follow the steps in Connection A. C[...]

7 When connected properly , the top LED on the front of the active speaker should be green. When first plugged in, it will sometimes take several seconds for the Control 2.4G active speaker to initialize and “wake up.” Until then, the top LED will be in red. Once the top LED is green, the bottom LED should flash green until the transmitter and [...]

8 Adjusting the V olume Application 1 Adding surround speakers to a home theater system: In this application, the output level of your Control 2.4G active speakers will not only be dependent on the volume setting of your A/V source; it will also need to be properly adjusted after installation and before use in order to be able to work correctly wit[...]

9 Adjustable wall brackets are included for the two speakers and transmitter module. The included brackets are for wall-mounting only . It is not to be used for ceiling mounting. Ceiling mounting of the Control 2.4G transmitter and/or speakers is not recommended, regardless of bracket used. Wall-Mounting the Speaker s Using W all Brackets Pr ovided[...]

10 Wall-Mounting the Speaker s Using Third-P arty Wall Brackets Each JBL On Air Control 2.4G wireless speaker contains a 1/4"-20 threaded insert on the back to facilitate the use of third-party wall brackets. Please consult your JBL dealer or distributor for recommendations. NOTES: Customer is responsible for proper selection and installation [...]

S PECIFICA TIONS F requency Range (±3dB): 5 0Hz – 20kHz Amplifier Output: 15 Watts per channel Low-Frequency Driver: 4" (100mm) Magnetically shielded High-Frequency Driver: 1/2" (12mm) T itanium-laminate, magnetically shielded Operating Range: Up to 70' (21m) depending upon conditions RF Operating Frequency: 2.4GHz Dimensions Spea[...]

JBL and Control Series are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Pro Sound Comes Home is a trademark of Harman International Industries, Incorporated. ® PRO SOUND COMES HOM E ™ Harman Consumer Group, Inc., 250 Crossways Park Drive, Woodbury , NY 11797 USA 8 500 Balboa[...]