Ice-O-Matic VRC инструкция обслуживания

INSTALLATION AND PARTS MANUAL REMOTE CONDENSERS MODELS: VRC Ice-O-Matic 11100 East 45th Av e Denver, Colorado 80239 Part Number 9081245-01 Date 3/08[...]

*[...]

Remote Condenser Introduction Page i How To Use This Manual Ice-O-Matic provides this manual as an aid to the service technician in installation a nd maintenance of remote condensers. Do not attempt to perform installation, start-up or maintenance unless you h ave read and fully understand this manual. If, at any time, you encounter conditions that[...]

Remote Condenser Table of Contents Page ii Introduction Page i T a b l e o f C o n t e n t s Page ii Freight Claim Procedure Page iii W a r r a n t y Page iv General Information Page 1 Installation Guidelines Page 2 Remote Refrigeration System Page 4 C o m p o n e n t D e s c r i p t i o n Page 5 I n s t a l l a t i o n Page 6 Service Parts VRC Pag[...]

Remote Condenser Freight Claim Procedure Page iii Freight Claims Important! Inspect Promptly This merchandise has been carefully inspected and packed in accordance with the carrier’s packing specifications. Responsibility for safe delivery has been assumed by the carrier. If loss or damage occurs, you as the consignee must file a claim with the c[...]

Remote Condenser Warranty Page iv Ice-O-Matic Parts and Labor Domestic & International L imited Warrant y Mile High Equipment LLC (the “Company”) warr ants Ice-O-Matic brand ice machines, ice di spensers, remote conde nsers, water filters, and ice storage bins to the end customer against defects in ma terial and factory workmanshi p for the[...]

Remote Condenser General Information Page 1 Condenser Dimensions (Inches) Model Length Width Height Compatible With: VRC1001 29.18 29.50 38.90 ICE0500R4 VRC1061 29.18 29.50 38.90 ICE0605/6R4, EMF1106R2 VRC2061 29.18 29.50 38.90 IC E0805/6/R3, ICE1005/6/7R3, EMF2306R2 VRC2661 29.18 29.50 38.90 ICE1405/6/7R3, ICE1506R3 VRC5061 37.78 29.50 38.76 ICE18[...]

Remote Condenser General Information Page 2 Introduction Ice-O-Matic Remote Condenser Systems are comprised of three components. The pre-charged remote condenser, the pre-charged ice maker and the pre-charged line set. The pre-charged line sets are available in 25, 40, 45, 60 or 75 foot line set lengths. The 60 foot line set will require adding an [...]

Remote Condenser General Information Page 3 The VRC remote condensers incorporate the mixing valve in the condenser. This configuration allows up to a 100 foot calculated remote line set run. Reference the diagram below to calculate the maximum 100 foot line set run. Limitations for new remote machines that have the mixing valve mounted in the cond[...]

Remote Condenser Remote Refrigeration System Page 4 The Remote Refrigeration System is shown in the above diagram. During the freezing cycle, high temperature and high pressure liquid refrigerant is directe d from the condenser through a mixing valve, receiver, liquid line solenoid heat exchanger and a filter drier. The expansion valve meters refri[...]

Remote Condenser Component Description Page 5 Mixing Valve (Headmaster, Low Ambient Control Valve) This valve serves as the head pressure regulating valve. It contains a pre-determined charge of nitrogen in the valve bellows. When the temperature at the condens er is above 70°F (21°C), the refrigerant flow from the compressor is directed by the m[...]

Remote Condenser Installation Page 6 Electrical Connections 1. The icemaker and the remote condenser both require a solid earth ground that meets National, State and Local Codes. 2. Reference the ice machine and condenser date plate for current requirements to determine wire size for electrical hook up. 3. Make sure the supply voltage is the same a[...]

Remote Condenser Installation Page 7 Support Leg Installation-VRC 1. After removal of the packaging and fasteners, lift the condenser assembly off of the skid. 2. Locate the legs and leg braces attached to the condenser assembly. Cut the wire ties and separate the legs from the condenser. 3. Locate the fasteners that are in a bag attached to the co[...]

Remote Condenser Installation Page 8 Vertical Air Flow[...]

Remote Condenser Installation Page 9 Proper Tubing Routing When installing the discharge and liquid lines from the remote condenser to the icemaker, please use the following guidelines: 1. The remote condenser (#2) should always be installed above the icemaker (#4) as shown with a vertical air flow on page 8. 2. All excess tubing (#1) should be rou[...]

Remote Condenser Service Parts Page 10 Item Description VRC1001 VRC1061 VRC2061 VRC2661 VRC5061 1 Fan Guard 9131452-01 9131452-01 9131452-01 9131452-01 9131460-01 2 Top Panel 3013222-01 3013222-01 3013222-01 3013222-01 3013303-01 3 ¼-20 x 1/2 Screw 9031019-04 9031019-04 9031019-04 9031019-04 9031019-04 4 Fan Blade 9131451-01 9131451-01 9131451-01 [...]

Remote Condenser Service Parts Page 11[...]