Hyundai V226WA инструкция обслуживания

2 1.5 " wide LCD Monitor User Manual English Deutsch Français Italiano Español ㅔԧЁ᭛ 3FFɤɢɣ Svenska Suomi Dansk Polski Nederlands 穢剳檺[...]

TABLE OF CONTENTS FOR YOUR SAFETY ----------------------------------------------------------- 1 SAFETY PRECAUTIONS ------------------------------------------------ 2 SPECIAL NOTES ON LCD MONITORS ----------------------------- 3 BEFORE YOU OPERATE THE MONITOR ------------------------------- 3 FEATURES ------------------------------------------------[...]

1 Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequen cy Interference Statement WA RNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply w ith the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules[...]

2 PRECAUTIONS • Do not use the monitor near water, e.g. near a bathtub, w ashbowl, kitchen sink, laundry tub, sw imming pool or in a wet basement. • Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and c ause serious damage to the appliance. Use only a cart or stand recommended by the m[...]

3 SPECIAL NOTES ON LCD MONITORS The following symptoms are normal w ith LCD monitor and do not indicate a problem. NOTES • Due to the nature of the fluoresc ent light, the screen may flicker during initial use. Turn off the Power Sw it ch and then turn it on again to make sure the flicker disappears. • You may find slightly uneven brightness on[...]

4 INSTALLATION INSTRUCTIONS Install Remove Figure 1 Installing and Removing the Base POWER CORD Pow er Source: 1. Make sure that the pow er cord is the correct type required in y our area. 2. Th is LCD monitor has an External universal power supply that allow s operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is requi[...]

5 CONTROLS AND CONNECTORS SIGNAL CABLE Connecting the Signal Cable: Plug the Signal Cable one end to LCD monitor’s “DSUB-Input” socket , the other end to the computer’s VGA port and tighten the two screw s on the cable connector. Connecting the DVI Cable (option) : Connect one end of the 24-pin DVI cable to the back of the monitor and conne[...]

6 ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your ow n preference. • Hold the stand so you do not t opple the monitor w hen you change the monitor’s angle. • You are able to adjust the monitor’s angle from -5 ° to20 ° . Figure 3 NOTES [...]

7 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the monitor (See Figure 4). By changing these settings, the picture can be adjusted to your personal preferences. • The power cord should be connected. • Connect the video cable from the mon[...]

8 FRONT PANEL CONTROL • Pow er Button : Press this button to switch ON/OFF of monitor’s power. • Pow er Indicator: Blue — Power On mode. Orange —Off mode. • MENU / ENTER : Active OSD menu or function adjust confirm or Exit OSD menu when in Contrast /Brightness OSD status. • ECO Hotkey(-) Activates  the  ECO  control  when [...]

9 • To keep the monitor looking new , peri odically clean it w ith a soft cloth. Stubborn stains may be removed w ith a cloth lightly dampened w ith a mild detergent solution. Never use strong solvents such as thinner, benzene, or abrasive cleaners, since these will damage the cabinet. As a safety precaution, alway s unplug the monitor before cle[...]

10 ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description Brightness Backlight Adjustment Contrast Contrast from Digital-register. Standard S tandard Mode Text Text Mode Internet Internet Mode Game Game Mode Movie Movie Mode Eco Sports Sports Mode Off Disable dynamic contras[...]

11 Cool Recall Cool Color Temperature from EEPROM. sRGB Recall SRGB Color Temperature from EEPROM. User-B Blue Gain from Digital-register User-G Green Gain Digital-register. User User-R Red Gain from Digital-register H.Position Adjust the verticalposition of OSD V.Position Adjust the horizontal position of OSD Timeout Adjust the OSD T imeout OSD Se[...]

12 PLUG AND PLAY Plug & Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host sy stem of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The DDC2B is a bidirectional data channe[...]

13 TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Pow er Switch is in the ON position *Power Cord should be connected No Plug & Play *Check if the PC system is Plug & Play compatible *Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent P[...]

14 CLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen show s vertical stripes and the picture has not correct width. FOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in light picture. For FOCUS and [...]

15 APPENDIX SPECIFICATIONS Driving system TF T Color LCD LCD Panel Size 547.86 mm(21.5") Pixel pitch 0.248( H ) ×0.248mm ( V ) R,G,B Analog Interface Video Digital Interface Input Separate Sync. H/V TTL H-Frequency 31kHz – 67.5kHz V-Frequency 56-75Hz Display Colors 16.7M Colors Dot Clock 138.5MHz Max. Resolution 1920x1080@60Hz Plug & Pl[...]

16 Switch • Power Button • Menu • Volume Hotkey(+) • ECO/- • Source/Auto External Controls: Functions • Contrast • Brightness • Focus • Clock • H. Position • V. Position • OSD setup • Language • Input Select • Information • (Warm)Color • (Cool)Color • sRGB • USER Color temperature • Reset • Exit Power Consu[...]

17 FACTORY PRESET TIMING TABLE ST ANDARD RESOLUTION HORIZONT AL FREQUENCY VERTICAL FREQUENCY 640×480 @60Hz 31.469 59.940 640×480 @72Hz 37.861 72.809 VGA 640×480 @75Hz 37.500 75.000 Dos-mode 720×400 @70Hz 31.469 70.087 800×600 @56Hz 35.156 56.250 800×600 @60Hz 37.879 60.317 800×600 @72Hz 48.077 72.188 SVGA 800×600 @75Hz 46.875 75.000 1024×7[...]

18 CONNECTOR PIN ASSIGNMENT 15 6 10 11 15 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. Ground 3. Blue 11. Ground 4. Ground 12. DDC-Serial Data 5. Detect Cable 13. H-Sync 6. R-Ground 14. V-Sy nc 7. G-Ground 15. DDC-Serial Clock 8. B-Ground 24 - Pin Color Display Signal Cable(option) PIN NO. D[...]