Husqvarna 225B X-Series инструкция обслуживания

225B 225B X-SERIES Operator´s manual Read the operator ’ s manual carefully and make sure that you understand the contents before using the blower . 114 00 25-95[...]

2 – English CONTENTS Introduction ......................................... 3 Key to symbols .................................... 4 Safety instructions .............................. 5 Description .......................................... 7 Fuel handling ..................................... 12 Start and stop ....................................[...]

English – 3 INTRODUCTION ! WARNING! Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories. Non-authorised modifications and/or accessories can result in serious personal injury or the death of the operator or others. Your warranty does not cover damage or liabil[...]

4 – English KEY T O SYMBOLS Symbol Description Location Operator ’ s manual Blower Checks and/or mainten-ance shall be carried out after having switched off the engine. The stop switch must be set to the STOP position. Cleaning at regular intervals is required. Approved protect goggles or visor must be worn. Approved protect goggles or visor an[...]

English – 5 Personal safety equipment Fuel safety ! Special safety instructions apply to the type of fuel used for the blower . These instructions are specified under ” Fuel handling ” on pages 1 1 and 12. The following instructions apply to persons operating the blower: 1. The operator shall have read and understood the contents of this manu[...]

6 – English 1. Do not allow bystanders or animals to be in the work area, i.e. 10 metres from the operator. 2. The blower may throw objects at high velocity that can ricochet and hit the operator. This may cause serious eye damage. 3. Never point the blower nozzle toward people or animals. 4. Stop the engine before fitting or dismantling accessor[...]

English – 7 DESCRIPTION The blower 1. Shoulder strap 2. Throttle trigger 3. Stop switch 4. Throttle lock 5. Shoulder strap ring 6. Anti-vibration system (inside the housing) 7. Fan housing 8. Fuel cap 9. Air filter 10. Choke 1 1. Inspection cover (225B X-SERIES ) 12. Cutters (225B X-SERIES ) 13. Fan impeller 14. Nozzle 15. Blower tube 16. Muffler[...]

8 – English DESCRIPTION Accessories (225B X-SERIES ) 21. V acuum device with collection components consisting of items 22 - 25 below . 22. V acuum bag tube. 23. Collection bag. 24. V acuum tube in two sections. 25. Auxiliary handle. 25 23 22 24 21[...]

English – 9 DESCRIPTION 34 2 ! The muffler is designed to give the lowest possible noise level and to direct the engine ‘ s exhaust fumes away from the operator . Muffler fitted with catalytic converter is also designed to reduce harmful exhaust components. The engine exhaust fumes are hot and can contain sparks, which may cause fire if they co[...]

10 – English DESCRIPTION 24 15 14 7 13 12 1 1 Throttle trigger (2) The speed and the output of the engine are regul- ated by the throttle trigger . The throttle lock (4) must be pressed down before the trigger will actuate the throttle. Fan casing (7) The blower fan casing (7) together with the impeller (13) provide high performance air discharge[...]

English – 11 DESCRIPTION 17 18 8 9 19 10 Starter device (18) and starter handle (17) The starter device is located at the top on the engine shrouding and engages in the crank shaft only when the starter handle is pulled. Fuel cap (8) Air filter (9) The fuel cap (14) is located at the top of the engine shrouding and has a gasket, which prevents fu[...]

12 – English Fuel mixture WARNING! Allow adequate ventilation while handling fuel. NOTE! The machine is fitted with a two-stroke engine and must always be run on a mixture of gasoline and two-stroke oil. It is important to measure the quantity of oil accurately , to ensure the correct mixture ratio. Small discrepancies in the amount of oil have a[...]

English – 13 Olja • Olje Olie • Ö ljy ä Lit. 5 10 15 20 2%(1:50) 0,10 0,20 0,30 0,40 Bensin Bensin Benzin Bensiini ä Lit. O FUEL HANDLING Mixture • Always mix gasoline and oil in a clean container intended for fuel. • Always start by filling half the quantity of gasoline required. Then add the entire oil quantity. Mix (shake) the fuel [...]

14 – English ST ART AND ST OP WARNING! Never start the blower if the inspection cover is not closed, is damaged or cannot be closed. (Exception: When the vacuum tube is fitted). ! IMPORTANT! Do not pull out the starter cord completely and do not release the starter handle from the fully pulled out position. Doing so will damage the starter Start [...]

English – 15 ST ART AND ST OP Press the machine body against the ground using your left hand (NOTE! Do not use your foot). Grip the starter handle with your right hand and slowly pull the starter cord out until you feel some resistance, (the starter hooks grip) now quickly and powerfully pull the cord. Immediately press the choke control in when [...]

16 – English USING THE BLOWER WARNING! When fitting the blower tube and nozzle, the engine must be switched off and the stop switch must be in the stop position. ! The blower tube and nozzle have a bayonet mount. Fit them in the following manner: 1. Press the blower tube (15) against the blower air outlet and turn it 90 degrees until a snap is he[...]

English – 17 USING THE BLOWER ! WARNING! Never start the blower if the inspection cover is not closed, is damaged or cannot be closed. (Exception: When the vacuum tube is fitted). ! 21 14 WARNING! Do not operate the blower while standing on a ladder or a stand. High-velocity nozzle (21) The high-velocity nozzle is an accessory of the blower and i[...]

18 – English USING THE BLOWER 1. Open the collection bag. Insert the collection bag tube from inside the bag to fit in the vacuum inlet opening of the bag as illustrated in the adjacent figure. Close the zipper on the bag. 2. Press the collection bag tube on the blower, turn it 1/4 of a turn until a snap is heard. The section of the tube that is [...]

English – 19 USING THE BLOWER ! WARNING! Do not operate the blower while standing on a ladder or a stand. When operating the blower , the blower and collection bag must be secured in the shoulder strap. The strap should be worn over the shoulder as shown in the adjacent figure. WARNING! Always check that the collection bag is intact and the zippe[...]

20 – English MAINTENANCE The fuel quantity required in relation to the air flow , provided by the opening in the throttle, is adjusted by the L and H jets. If they are screwed clockwise, the air/fuel mixture becomes leaner (less fuel) and if they are screwed counterclockwise, the mixture becomes richer (more fuel). A leaner mixture gives rise to [...]

English – 21 MAINTENANCE Muffler NOTE! Some mufflers are fitted with a catalytic converter . See “ T echnical data ” to see whether you clearing saw is fitted with a catalytic converter . The muffler is designed to dampen the noise level and to direct the exhaust fumes away from the user . The exhaust fumes are hot and can contain sparks, whi[...]

22 – English The air filter (A) must be cleaned regularly to remove dust and dirt. This will prevent: • Carburetor malfunctions • Starting problems • Reduced performance • Unnecessary wear on engine parts • Abnormal fuel consumption • Elevated content of harmful exhaust fumes Clean the filter after 25 hours of operation or more often [...]

English – 23 MAINTENANCE 1 2+3 4 5 8 1+3 4 5 6 7 8 2 Maintenance schedule A number of general maintenance instructions are given below . If more detailed instructions are required, get in touch with your local servicing dealer . Daily maintenance 1. Clean the exterior surfaces of the blower . 2. Check that the throttle lock and the throttle trig-[...]

24 – English MAINTENANCE Monthly maintenance 1. Flush the fuel tank with clean gasoline, which afterward should be disposed of in an environ- mentally correct manner . 2. Clean the outside of the carburetor and the space around it. Replace damaged parts. 3. Clean the fan blades on the flywheel and the space around it. 4. Check the fuel filter and[...]

English – 25 TECHNICAL DA T A 225B 26,9 35 28 3.000 8.200 7.400 0.9 kW/9000 rpm No W albro CD Champion RCJ 7Y 0.5 W albro/WT 0.4 5.1 89 105 2.6 4,3 Radial fan 83 (300) 600 Engine Cylinder volume, cm 3 : Cylinder bore, mm: Stroke, mm: Idling speed, rpm: Max. speed – blowing, rpm: Max. speed – vacuuming, rpm: Max. engine output to ISO 8893: Cat[...]

26 – English ´+H"[¶5B¨ FEDERAL AND CALIFORNIA EMISSION CONTR OL W ARRANTY ST A TEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EP A (U.S. Environmental Protection Agency), CARB (California Air Resources Board) and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2001 and later small off-ro[...]

English – 27[...]

2001W32 ´+H"[¶5B¨[...]