Honeywell 69-0786-2 инструкция обслуживания

1 69-0786—2 OWNER’S GUIDE 69-0786-2 T8132C Programmable Thermostat Weekday/W eekend Programmable Heat and/or Cool Thermostat and Mounting Plate[...]

2 69-0786—2 Welcome to the world of comfort and energy savings with your new Honeywell Program- mable Thermostat. Y our new T8132C Thermostat automatically controls the temperature in your home, keeping you comfortable while saving energy when programmed according to the instructions in this manual. Direct questions concerning the operation of th[...]

3 69-0786—2 T able of Contents Page Programming Thermostat ............................................................................................................... 4 Program Schedule .......................................................................................................................... 6 T8132C Programming Guide ........[...]

4 69-0786—2 Programming Thermostat When you program the thermostat, set one schedule for weekdays and another for weekends, because your temperature require- ments probably vary . (During weekends, only the W AKE and SLEEP time periods are available.) Use the personal Program Schedule for planning your program schedule of time and temperature set[...]

5 69-0786—2 Select RETURN if you want the house at a comfortable temperature for activities before bedtime. When deciding what time to set for your RETURN period, include extra lead time, depending on the outside temperature and your furnace response time, to give the furnace a head start to heat the house before you arrive home. (Again, higher f[...]

6 69-0786—2 Program Schedule HEA TING PROGRAM SCHEDULE Weekdays Start Time Heating T emperature W AKE LEA VE RETURN SLEEP Weekends W AKE SLEEP W AKE and RETURN start times should include extra lead time, based on outside temperature and furnace response time, to give your furnace a head start to heat the house. The temperatures cannot be set any [...]

7 69-0786—2 COOLING PROGRAM SCHEDULE Weekdays Start Time Heating T emperature W AKE LEA VE RETURN SLEEP Weekends W AKE SLEEP W AKE and RETURN start times should include extra lead time, based on outside temperature and furnace response time, to give your furnace a head start to heat the house. The temperatures cannot be set any higher than 88 ° [...]

8 69-0786—2 T8132C Programming Guide NOTE: Batteries are required for operation and programming. When replacing the batteries, set the system switch to OFF . Remove the battery door (on the thermostat left side) using a coin at the bottom. Follow the instructions in Changing Batteries section. Set Current Time/Day T o set time, press and release [...]

9 69-0786—2 Ahead Back Warmer Cooler Press to program the W AKE time and press to program the WAKE temperature for MON-FRI. Repeat the sequence for LEA VE, RETURN, and SLEEP . Press until SA T SUN, W AKE and SET appear on the display . Press to program W AKE time and press to program W AKE temperature for Sat-Sun. Repeat the sequence for SLEEP . [...]

10 69-0786—2 A quick guide for operating or making changes follows. NOTE: Set system switch to HEA T or COOL to perform the following: T emporarily Change temperature for current period only—press ; temperature is cancelled at next scheduled change; to cancel sooner , press . Hold a temperature indefinitely—press , ; to cancel, press . Check [...]

11 69-0786—2 Weekday Schedule Usage Check Programs— press , repeatedly to see each time and temperature; then press . Cancel a program—press , until program to cancel shows; then press . Check Usage — press to determine length of time heating or air conditioning has been on since midnight; press again for yesterday’s usage, and again for [...]

12 69-0786—2 Setting Fan and System Switches First set the fan switch. AUTO: Normal setting for most homes. A single-speed fan turns on automatically with the air conditioner or furnace. A two-speed fan usually runs on high with the air conditioner and runs on low with the furnace. ON: The fan runs continuously . Use for improved air circulation [...]

13 69-0786—2 Changing Batteries IMPORT ANT Batteries are required for prog ram- ming and operation of the thermostat and heating/cooling system. As the batteries run low , bAt Lo indicator flashes for one to two months before the batteries run out com- pletely . Replace the batteries as soon as possible after the indicator starts flashing. If you[...]

14 69-0786—2 T o remove batteries, press down on the left ends of the batteries. If you insert new batter- ies within 20 to 30 seconds of removing the old ones, the thermostat does not require repro- gramming. However , if the display is blank, the batteries are dead or incorrectly installed and the thermostat requires reprogramming. • Install [...]

15 69-0786—2 T roubleshooting Guide IF… THEN… Display will not come on. ■ Set the system switch to OFF; remove batteries and insert them backward for at least five seconds to reset the thermostat; replace the batteries correctly . The display should come on. ■ Make sure the batteries are fresh and installed correctly . T emperature displa[...]

16 69-0786—2 Heating will not come on (Cont). ■ If display is blank or displays bAt Lo, install fresh batteries. ■ If temperature setting is higher than current temperature, and thermostat displays HEA T , contact Honeywell Customer Assistance at 1-800-468-1502. Cooling will not come on. ■ Check that the switch on the thermostat is set to C[...]

17 69-0786—2 Cooling will not come on (Cont). position. If the air conditioner comes on, the compressor could have reached its high limit temperature protection and shut down. If the air conditioner does not come on after ten minutes and displays COOL, contact Honeywell Customer Assistance at 1-800-468-1502. The house is too warm or too cool. ■[...]

18 69-0786—2 30% 28% 26% 24% 22% 20% 18% 16% 14% 12% 8% 6% 2% 10% 4% Minneapolis St. Paul Montreal Ottawa Toronto Buffalo Cleveland Milwaukee Edmonton Regina Winnipeg Calgary Moncton North Bay Quebec St. John's Halifax Vancouver Denver Des Moines Omaha Salt Lake City Boston Chicago Detroit Pittsburgh Indianapolis Cincinnati Kansas City St. L[...]

19 69-0786—2 Limited One-Y ear W arranty Honeywell warrants this product, excluding battery , to be free from defects in the workmanship or materials, under normal use and service, for a period of one (1) year from the date of purchase by the consumer . If, at any time during the warranty period, the product is defective or malfunctions, Honeywel[...]

20 69-0786—2 69-0786—2 Rev . 5-96 J.S. Printed in Mexico Copyright © 1996 Honeywell Inc. All Rights Reserved Home and Building Control Honeywell Inc. 1985 Douglas Drive North Golden Valley, MN 55422 Helping You Control Your World Home and Building Control Honeywell Limited-Honeywell Limitée 155 Gordon Baker Road North York, Ontario M2H 2C9 T [...]