Hayter Mowers 447F инструкция обслуживания

Operator ’ sManual R48 Recycling Mower G008079 Code 446F , 447F Serial No. 310000001 and Up Manual Part No. 1 1 1-3375 Rev A[...]

This product complies with all relevant European directiv es , for details please see the separate product specic Declaration of Conformity (DOC) sheet. Introduction Thank you for purchasing a Hayter mow er . The following pag es are designed to help y ou gain safe and efcient ser vice from y our mac hine This rotar y-blade, walk-behind la wn[...]

Safety Improper ly using or maintaining this mo wer can result in injur y . T o reduce the potential for injur y , comply with these safety instructions. This mow er was designed and tested for reasonably safe ser vice; ho wev er, failure to comply with the follo wing instr uctions ma y result in personal injury . T o ensure maximum safety , best p[...]

– Do not mow ex cessiv ely steep slopes. – Exercise extreme caution when on slopes . – Mow across the face of slopes , nev er up and down and ex ercise extreme caution when changing direction on slopes . – Alwa ys be sure of your footing on slopes . • Use low throttle settings when eng aging the traction-clutch, especially in high gears .[...]

Safety and Instructional Decals Important: Safety and instruction decals ar e located near areas of potential danger . Replace damaged decals. Manufacturer ’ s Mark 1. Indicates the blade is identied as a part from the original machine manufacturer . 1 10-7058 1. Height of cut 1 10-7059 Model 447F only 1. Read the Operator ’s Manual. 4. Inst[...]

Setup Unfolding the Handle 1. Unlock the handle locks , mo ve the handle sections into the operating position, and loc k the handle locks (Figure 3). Figure 3 2. Unlock the upper handle locks and rotate the upper handle upw ard and loc k it into a position that is comfortable to you (Figure 4). Figure 4 1. Highest position 3. Lowest position 2. Mid[...]

Installing the Fuse (Model 447F Only) Y our mow er comes with a 40-amp fuse that protects the electric starter . Important: Y ou cannot start the mo wer with the electric star ter or charge the batter y unless y ou install the fuse. 1. R emov e the batter y cover and the batter y and locate the fuse holder (Figure 7). Figure 7 1. Screw 3. Fuse hold[...]

Product Overview G01201 1 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Figure 9 Model 447F shown 1. Lower handle lock 8. Rear door 2. Grass bag 9. Oil ll/Dipstick (not shown) 3. Upper handle lock 10. Fuel tank cap 4. Recoil start handle 1 1. Cutting height lever (2) 5. Upper handle 12. Spark plug 6. Blade control bar 13. Air lter 7. Electric start (model[...]

detergent oil with an API ser vice classication of SF , SG , SH, SJ , SL, or higher .) 3. Install the dipstick. Adjusting the Cutting Height Adjusting the cutting height may bring you into contact with the mo ving blade, causing serious injur y . • Stop the engine and w ait for all moving par ts to stop. • Do not put y our ngers under the[...]

sides , and the mo wer will automatically keep pace with you. Figure 15 Stopping the Engine 1. R elease the blade control bar (Figure 16). Figure 16 2. When the engine stops , remo ve the ignition key when you lea ve the mo wer . Important: W hen y ou r elease the blade control bar , both the engine and blade should stop within 3 seconds. If they d[...]

G008083 Figure 18 Removing the Grass Bag T o remo ve the bag, rev erse the steps abo ve . Rear-discharging the Clippings Use the rear disc harge for cutting very tall g rass . If the bag is on the mow er , remo ve it (refer to R emo ving the Grass Bag) before rear -discharging the clippings (Figure 19). The R ecycling/bag ging lever should be in th[...]

– Raise the cutting height on your mow er . – Cut the grass more frequently . – Overlap cutting swaths instead of cutting a full swath with each pass . – Set the cutting height on the front wheels one notch lower than the rear wheels . F or example , set the front wheels at 60 mm and the rear wheels at 70 mm. Cutting Leaves • After cuttin[...]

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the rst 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level. • Ensure that the engine stops within 3 seconds after releasing the blade control bar . • Clean the mower . Every 25 hours • Charge the [...]

Lubrication Lubricating the Wheel Gears Ser vice Inter v al: Y early—Lubricate the wheel gears . 1. R emov e the wheel bolts on the rear wheels and remov e the rear wheels . 2. Apply a lubricating oil to the gear as sho wn in Figure 21. Figure 21 3. Install the rear wheels . Engine Maintenance Replacing the Air Filter Ser vice Inter v al: Y early[...]

Figure 23 4. Slowly pour oil into the oil ll tube until the oil level reaches the Full line on the dipstick (Figure 6). Do not o verll. (Max. ll: 0.59 l, type: SAE 30W detergent oil with an API ser vice classication of SF , SG , SH, SJ , SL, or higher .) 5. Install the dipstick securely . 6. Dispose of the used oil properly at a local r[...]

Drive System Maintenance Adjusting the Self-propel Drive If y our mo wer does not self-propel properly , adjust the self-propel dri ve cable . 1. Loosen the nut on the cable mount (Figure 25). Figure 25 1. Nut on cable mount 2. Pull the upper handle bac k fully rearward (Figure 26). Figure 26 3. Pull the cable jacket downw ard until you remov e the[...]

Blade Maintenance Replacing the Blade Ser vice Inter v al: Every 25 hours—R eplace the blade or hav e it sharpened (more frequently if the edge dulls quic kly). Important: Y ou will need a torque wr ench to install the blade pr oper l y . If y ou do not ha ve a torque wrench or are uncomfor ta ble perfor ming this procedure, contact an Authoriz e[...]

Cleaning Cleaning the Mower Ser vice Inter v al: Before each use or daily—Clean the mow er . Tipping the mo wer may cause the fuel to leak from the carburetor or the fuel tank. P etrol is extremely amma ble, highly explosiv e, and under cer tain condition can cause personal injur y or proper ty damage. Run the engine dr y or remov e the fuel w[...]

Notes: 19[...]

Notes: 20[...]

1st Y ear (12 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: 1st Y ear (12 months) Owner’s Name: Serial Number: Date: 2nd Y ear (24 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: Owner’s Name: Serial Number: Date: Note for dealer : [...]

[...]

LIMITED WARRANTY Hayter Limited warrants to the original user/purchaser that this unit shall be free from defect s in material and workmanship under normal use and service for a period of three years from the date of purchase. The manufacturer of major proprietry components ie. engines, gearbox / transaxle (where applicable) furnish their own warra[...]

CUS T OME R INFO RMA TI ON Date of Sale:- Y our Local Dealer:- HA Y TER L IM ITED , SPEL L BR OO K, BI SHOP ’S S T O R TF O RD , H E R T S . C M 2 3 4B U, E N G L A N D Code Serial No.[...]