Hawking CardBus 10/100 Fast Ethernet PC Card инструкция обслуживания

CardBus 10/100 Fast Ethernet PC Card User Manual Doc. No.: 052902- 01[...]

REGULATORY STATEMENTS FCC Certification The United States Federal Com m unication Com m ission (FCC) and the Canadian Departm ent of Comm unications have established certain rules governing the use of modem s and other electronic equipm ent. FCC Part 15 Registration This device com plies with Part 15 of FCC rules. Operation is subject to the follow[...]

TABLE OF CONTENTS INTRODUCTION ............................................. 1 System Requirements ................................... 1 Operating Systems & Software Support ...... 1 INTRODUCTION TO CARDBUS .................. 2 HARDWARE INSTALLATION ..................... 4 Inserting the CardBus Dual-Speed PC Card ...............................[...]

INTRODUCTION Sy stem Requirements  An IBM compat ible notebook com puter with 486 or faster processor wit h CardBus supported socket.  Drivers and u tilities provided with this product.  PCMCIA PC Card com pliant Card Services and Socket Services.  100Base-TX Fast Ethernet or 10BaseT Ethernet connectivity to your local area network. Ope[...]

INTRODUCTION TO CARDBUS Cardbus is the next generat ion 32-bit version issued by PCM CIA PC Card standard. In additi on to support a wi der bus (32 bits instead of 16 bits ), CardBus also supports bus m astering and operation speeds up to 33 M Hz. The 132M Bytes bus transfer rate (com pares with legacy 16-bit I/0 PC Ca rd, 20MByte) provi des the mo[...]

 Due to variant design of not ebook computers, some m odels implement a setting in th e Com puter’s BIOS to swi tch between Ca rdbus and 16-bit PC Card modes. You could consul t the User’s Guide of your notebook and properly set on the CardBus or Auto_Detect mode. - 3 -[...]

HARDWARE INSTALLATION Inserting the CardBus Dual-Speed PC Card 1. Hold the CardBu s PC Card with wide connector toward the slot and the brand label facing upward. 2. Insert the CardBus PC Card and push it firmly into the bottom. (Please see the following figure for reference) Removing the CardBus Dual-Speed PC Card It’s quite different for variou[...]

Connecting to the Netw ork Connect RJ-45 port of t he CardBus 10/100 Ethernet PC Card Adap ter to the Category 5 Network cable before loadi ng any network driver.  For operation in t h e 100Mbps (100Base-TX) Ethernet network, a C ategory 5 unshielded twiste d pair (UTP) cable should be used t o connect between the RJ -45 port and 100Mbps hub/swi[...]

SOFTWARE INSTALLATION Windows 95 Installation (OSR2) 1. Boot up com puter to Windows 95. Make sure the CardBus 10/100 Fast Ethernet PC Card is well conn ected to the CardBus Socket. 2. Cli ck Next in the Update Device Driver Wizard Windows . 3. Cli ck Others Locations to select an installation d river manually. 4. Insert the in stallation disk o r [...]

5. Insert the original Windows 95 CD/disks to reset the system as requested. 6. For the first installatio n, please select Network in the Control Panel window to add Protocols, Cl ient and Service if needed. 7. Restart the system to activate the card. Windows 98 Installation 1. Boot up com puter to Windows 98. Make sure the CardBus 10/100 Fast Ethe[...]

4. Insert the in stallation disk o r CD into the chosen drive (a floppy dri ve or a CD-ROM drive) and select the location where you load the device driver. Click Next to start the search. The driv er will be installed automatically. 5. Cli ck Next to contin ue when the suitable driver for the device selected. - 8 -[...]

6. Insert the original Windows 98 CD/disks to reset the system as requested. Click OK to continue. 7. Follow on- screen instruction to complete installation. Click Finish . - 9 -[...]

8. Cli ck Yes to restart the syst em to activate the card. Windows 2000 Installation 1. When the C ardBus 10/100 Fast Et hernet PC Card is well conn ected to the CardBus Socket, the system will automatically detect the card and ask for the necessary device driver. Click Next to continue. 2. Select Search for a suitable driver for my device (recomme[...]

3. Insert the in stallation disk o r CD into the chosen drive (a floppy dri ve or a CD-ROM drive) and select the location where you load the device driver. Click Next to start the search. 4. Cli ck Next to continue when t he appropriate driver for the device is selected. - 11 -[...]

5. Cli ck Yes in the Digital Signature Not Found window to conti nue. 6. Click Finish to complete installation. - 12 -[...]

Window ME Installation 1. Once the CardBus 10/100 Fast Ethernet PC Card is well conn ected to the CardBus Socket, Windows ME will autom atically detect the card and ask for the device driver. 2. Select Automatic search for a better driver (Recommended) and click Next to continue . 3. Insert the installation d isk or CD into the chosen drive (a flop[...]

4. Cli ck Next to contin ue when the appropriate driver for the devi ce is selected. 5. Windows Me will copy the appropriate driver to your system. Insert the or iginal Windows ME CD/disks into the chosen drive to reset the system if Windows Me system requests you to do. 6. Click Finish to complete the installation. Windows XP Installation 1. Windo[...]

2. Insert the installation d isk or CD into the chosen drive (a floppy drive or a CD-ROM drive) and select the location where you load the device driver and Select Search for the removable media (floppy, CD-ROM…) and click Next to start the search. - 15 -[...]

3. Windows will start searching for the appro priate installation driver. W hen the screen instruction appears as below, click Continue Anyway to proceed. 4. Wait for seconds while Windows copies the appropriate dri v er to your sy stem. 5. Click Finish to complete the installation. - 16 -[...]

Novell NetWare Installation 1. At the DOS prompt t ype Start under the path NETWARE . 2. The installation prog ram will automatically proceed. 3. Follow Novel l's instruct ions on using ODI programs. 4. Enter login at the Netware login prom pt, e.g. f:login >. 5. Type your user nam e and password. 6. The connection is m ade. - 17 -[...]

SPECIFICATIONS Netw ork Interface Specifications:  10Mbps Ethernet: IEEE 802.3 standard for 10BaseT baseband CSMA/CD local area network.  100Mbps Ethernet: IEEE 802.3u standard for 100Base-TX baseband CSMA/ CD local area network.  20/200 Mbps ful l duplex support  Autonegotia tion between all four-operati on modes. Host Interface:  C[...]