Haier XQB70-10 инструкция обслуживания

Names of the parts.............the 2 nd cover Safety precautions .......................1 Introduction of the special functions.........3 Installation and adjustment ..................3 Install the water inlet hose............5 Preparation before washing .............7 Put in the laundries .........................8 Put in the detergent ...........[...]

Meaning and description of the symbols Honourable users, Thank you for choosing our products. Our products integrate high-tech, precision,frontier science.T o facilitate using it, please read this manual carefully and operate this machine according to it. Before Using Before Using Names of the par ts the end connecting to the water inlet hose joint[...]

Before Using Before Using Saf ety pr ecautions Please insert the power cord into special rece- ptacle with rated voltage.If the power cord is three-phase wire,please use three-phase rec- eptacle.The earthing terminal of the receptacle must be earthed reliably .If it is two-phase wire, please guarantee that the earthing wire is ear- thed reliably .I[...]

Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items (such as the kettle with hot water ) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc.) The handicapped or children without care shall not use the machine. Keep the machine away from direct sunlight and heat[...]

The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods: Adjust the adjustable foot: Install the bottom pla te After you open the package, please lean the washing machine gently down on soft items ( like the tow[...]

1. The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way . 2. Do not trample or press the drain hose. If the drain hose is too long, cut it at mid point. T o make smooth drainage, cut the front end of the hose slantingly . 4. If extra drain hose is need[...]

Water tap,suitable Water tap,not suitable It is required that the front end shall be longer than 10mm. The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage. 2. Loosen the screw till the water tap can be accessed. Put the jointer of the water inlet hose on the tap. See to Figure 2. (If the tap diameter i[...]

1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately . 2.Put the nut of the water inlet hose on the valve jointer. 3.Fasten the nut. Swaying it gently to confirm if it's suitable. 1.Close the water tap. 2.Press the[...]

Confirm if there's special requirment for the laundries. Clear the pocket. T ake out the coins , sand, hairpins etc. Fasten the buttons and zippers. When the pulsator is running , the buttons of the laundries may cause noise. For the sake of discretion,please put the laundries with buttons into other laundries. Preparation before washing 1.Con[...]

Reference weight of the laundries: working suit up,down jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity. The largest capacity of this machine is 7.[...]

How to use the whitener Fill water to decided level. Dilute the whitener with container . Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color . The whitener shall not touch the laundries directly . Refer to the user's manual for the usage and quantity of the whitener. For[...]

The user selects a suitable water level depending on the load. If "Quick" wash is selected, water level will indicate "2". After water level reaches "2", it will wash while water filling, and wash normally upon the water level reaching "4". After washing for 1 min, pressing "Water level" button will[...]

Remarks: After pressing "Power On/Off" to connect power supply , if the washing machine lasts idle more than 10 min, it would automatically shut off the supply . XQB70-10 T o indicate -- during sensing. T o indicate remaining min. During program running. T o indicate remaining reserved time (hrs) during reservation period. T o indicate fa[...]

WA TER LEVEL SELECTION RESERV ATION PROCEDURE SELECTION POWER ST ART ON / OFF PROGRAM SELECTION NORMAL BIG CLOTHING GENTLE QUICK WASH After the power is switched on, the washing machine will automatically set a normal program comprising of processes of "Wash, Rinse and Spin" . If other program is desired, press the button of "Process[...]

Even there's no water in the tub, the spinning will start after a certain period. Do not use soak process for woolen laundries . Wash the laundries that are prone to lose colors separately from other laundries. The pulsator will not rotate unless the water is filled to selected water level. Selection method of the procedure programs Attention [...]

After switching on, the washing machine reserved wash program will be automatically set inactive. If you desire a wash cycle to end at a reserved time, you can press the " Reservation " button to set a reserved wash program. Refer to " The button of Reservation " on page 11. When " Reservation " becomes active, the nix[...]

After switching on, the washing machine reserved wash program will be automatically set inactive. If you desire a wash cycle to end at a reserved time, you can press the " Reservation " button to set a reserved wash program. Refer to " The button of Reservation " on page 11. When " Reservation " becomes active, the nix[...]

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company . Do not repair it by yourself. Phenomena [...]

User's manual Name Components of the water inlet hose Bottom plate T apping screws ST4x16 One One One Eight One Quantity Inside the document bag Storage position Automatic washing machine Inside the accessory bag Inside the accessory bag Between the upper cushion of the washing machine package and the upper seal of the package carton Packing l[...]

Rated voltage frequency Rated washing / spinning capacity W ater level/Water quantity (about) Max water consumption pressure Rated washing power Rated spinning power Weight Dimension 7.0kg (weight of standard dry cloth) About 1 26L (High water l evel; Standard program) 0.03MPa-0.78MPa 350W 255W About 26kg L 537mm W 520mm H 890mm 220V~ 50Hz Model XQ[...]