Grizzly H5626/7 инструкция обслуживания

COPYRIGHT © SEPTEMBER, 2003 BY GRIZZLY INDUSTRIAL, INC. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC. PRINTED IN TAIWAN Model H5626 Model H5627 FINE WIRE UPHOLSTERY STAPLER MODEL H5626/7 INSTRUCTION MANUAL[...]

For Your Own Safety Read Instruction Manual Before Operating This Equipment Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury. Indicates a potentially hazardous situation which, if not a[...]

H5626/H5627 Upholstery Stapler -2 - 10. USE PROPER AIR HOSE for the tool. Make sure your air hose is in good condition and is long enough to reach your work without stretching. 11. WEAR PROPER APPAREL. DO NOT wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry which may get caught in moving parts. Non-slip footwear is recommen[...]

H5626/H5627 Upholstery Stapler -3 - Operating this stapler can propel objects into the air, causing immedi- ate eye damage. To protect yourself, always wear American National Standards Institute (ANSI) approved safety glasses or goggles when oper- ating this equipment. In addition, this stapler discharges at 85-90 decibels. To protect your hearing,[...]

H5626/H5627 Upholstery Stapler -4 - INTRODUCTION Commentary Most importantly, we stand behind our tools. If you have any service questions or parts requests, please call or write us at the location listed below. Grizzly Industrial, Inc. 1203 Lycoming Mall Circle Muncy, PA 17756 Phone: (570) 546-9663 Fax: (800) 438-5901 E-Mail: techsupport@grizzly.c[...]

H5626/H5627 Upholstery Stapler -5 - Compressed Air System Exceeding the maximum permissible operating pressure may cause the sta- pler to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this stapler! The Mode[...]

H5626/H5627 Upholstery Stapler -6 - OPERATION Loading Stapler To load your stapler: 1. Disconnect the air supply from the stapler! 2. Push the magazine latch in the direc- tion shown in Figure 2 . Figure 2. Releasing magazine latch. Figure 3. Loading staples into stapler. 5. Push the magazine cover forward until the magazine latch locks in place. 3[...]

ple in case of deflection. (Deflection is caused when the staple changes its path, resulting in the staple puncturing the surface of the workpiece as shown in Figure 4 .) Besides damaging your workpiece, deflection can cause injury if your free hand is securing the workpiece in the location that the staple deflects. 4. Press the trigger. If the sta[...]

H5626/H5627 Upholstery Stapler -8 - Clearing Jammed Staples A jammed staple must be cleared before using the stapler again. To clear a jammed staple: 1. Disconnect the stapler from the air supply! 2 . Open the magazine cover and pull the magazine all the way back. 3. Remove stick of staples. 4. Remove jammed staple with needle nose pliers. Speed Ad[...]

H5626/H5627 Upholstery Stapler -9 - Cleaning Stapler Use a good solvent to clean the nose assembly of the stapler. Always be sure that the stapler is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the sta- pler; this may result in leaks and damage to the stapler and the air couplings. Nev[...]

H5626/H5627 Upholstery Stapler -10 - Replacing Pistons/O-Rings If you use your stapler day in and day out, Grizzly offers repair pistons as cheap insurance against wasted down time and lost profits in the event that a piston or pis- ton shaft becomes worn out. Figure 6. Removing stapler exhaust cap. 7. Watch the discharge area and push the top of t[...]

H5626/H5627 Upholstery Stapler -11 - MAINTENANCE NOTES[...]

H5626/H5627 Upholstery Stapler -12 - H5626 PART BREAKDOWN 14 13 59 12 8 7 6 5 19 11 1 34 21 4 1 20 23 42 41 36 39 22 38 43 45 52 56 45 60 32 31 33 61 55 66 30 29 28 26 27 25 24 9 3 18 64 65 23 62 7 71 33[...]

H5626/H5627 Upholstery Stapler -13 - 01 PSB95M CAP SCR M5-.8 X 30 03 PH5626003 CAP COVER 04 PH5626004 SPRING 05 PH5626005 SEAL 06 PH5626006 CAP 07 PH5626007 O-RING 08 PH5626008 HEAD VALVE ASM. 09 PH5626009 O-RING 11 PH5626011 O-RING 12 PH5626012 COLLAR 13 PH5626013 O-RING 14 PH5626014 DRIVER ASSEMBLY 18 PH5626018 CYLINDER 19 PH5626019 BUMPER 20 PH5[...]

H5626/H5627 Upholstery Stapler -14 - H5627 PART BREAKDOWN B A A 7 9 30 1 2 3 4 5 6 29 31 33 19 18 15 17 16 14 13 12 11 10 20 21 22 B 59 60 62 61 21 67 15 64 63 60 15 65 66 C C 23 25 35 34 36 37 40 42 41 43 44 38 48 46 39 47 70 55 56 45 73 68 69 73 32 26 28 27 71 8 72[...]

H5626/H5627 Upholstery Stapler -15 - 01 PH5627001 CAP 02 PH5627002 O-RING 03 PH5627003 CYL. PRESS RING 04 PH5627004 O-RING 05 PH5627005 CYLINDER 06 PH5627006 O-RING 07 PH5627007 O-RING 08 PH5627008 DRIVER ASSEMBLY 09 PH5627009 BUMPER 10 PH5627010 COLLAR 11 PH5627011 O-RING 12 PH5627012 VALVE 13 PH5627013 VALVE PLUNGER 14 PH5627014 O-RING 15 PH56270[...]

TROUBLESHOOTING Air leaking at trigger valve area. Air leaking between hous- ing and hose. Air leaking between hous- ing and cap assembly. Tool skips staples while discharging. Tool runs slowly or has a loss of power. Fasteners frequently jam the stapler. Stapler does not fire. 1. O-rings must be replaced & operation of safety yoke must be chec[...]

H5626/H5627 Upholstery Stapler -17 - Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of main- tenance. This is Grizzly’s sol[...]

Name __________________________________________________________ Street __________________________________________________________ City ____________________ State ________ Zip _________ Phone Number ____________ E-Mail ___________________ FAX ____________ Model # ___________________________ Order # _______________________ The following information i[...]

FOLD ALONG DOTTED LINE GRIZZLY INDUSTRIAL, INC. P.O. BOX 2069 BELLINGHAM, WA 98227-2069 TAPE ALONG EDGES--PLEASE DO NOT STAPLE Name________________________________ Street________________________________ City______________State______Zip_______ Send a Grizzly Catalog to a friend: Place Stamp Here[...]