Enviro 25BV инструкция обслуживания

SHERWOOD INDUSTRIES IS AN ENVIRO NMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER ACCENT 2 5 BV By SHERWOOD INDUSTRIES LTD. OWNERS MANUAL WARNING If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Installation and service must be p[...]

SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERAT ION OF YOUR "ENVIROGAS" HEATER, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: • All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in this manual first. Consult the building authority having ju[...]

TABLE OF CONTENTS SECTION PAGE 1. Code Approvals 3 2. Dimensions and Clearances to Combustibles 5 3. Venting 6 4. Assembly and Installation Instructions 7 5. Electrical Requirements 8 6. Gas Line Connection and Testing 9 7. Installation of Log Sets and Embers and Brick Panels 10 8. Operating Instructions 11 9. Routine Maintenance and Service 12 10.[...]

CODES AND APPROVALS CONTINUED RE: CONVERSION OF ZERO CLEARANCE FACTORY BUILT FIREPLACES The following instructions cover Sherwood Industries Ltd. policy for Gas-Fired Appliances (inserts) to be retofitted into existing factory built fireplaces with replacement parts removed. GENERAL REQUIREMENTS Background A gas fired insert is approved for use in [...]

2. DIMENSIONS AND CLEARANCES TO COMBUSTIBLES DISTANCE TO COMBUSTIBLES: Mantel pillar to surround panel 2" / 5.08 cm Floor to 8" wide mantel 40" / 101 cm Minimum non-combustible surface in front of unit 8" / 20.8 cm OTHER DIMENSIONS A. Minimum Depth of unit into fireplace 16" / 41 cm B. Depth of unit out of fireplace 1 / 2.5[...]

3.VENTING FIREPLACE INSERTS WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoning and possible death. The Envirogas ACCENT 25 may be installed and vented into any solid fuel fireplace that has been installed in accordance w ith the National, Provincial[...]

4. ASSEMBLY AND INSTALLATION INSTRUCTIONS ASSEMBLING AND INSTALLING YOUR ENVIROGAS ACCENT 25 1. Remove the unit from it’s box 2. Open the door, by first removing the cover with the nameplate attached (open valve door and pull nameplate cover side tab to release catch), undo the two bolts at the bottom of the door. Lift the door up and out to remo[...]

5. ELECTRICAL REQUIREMENTS The ACCENT 25 will operate without electrical pow er. This model has a Millivolt gas control w hich uses the pilot flame to generate enough electricity to oper ate the main burners. The appliance when equi pped w ith blow er must be electrically connected and grounded in accordance with local codes or in the absence of lo[...]

6. GAS LINE CONNECTIONS and TESTING WARNING: Only persons licensed to w ork with gas piping may make the necessary gas connections to this appliance. GA S LINE CONNECTION • This stove is equipped with a 3/8 x 3 inch black iron nipple located on the right side of the unit terminating in a 3/8" male NPT fitting. Consult your local authorities [...]

7. INSTALLATION OF LOGS, EMBERS and BRICK PANELS INSTA LLING THE GLOWING EMBERS and LOGSET A bag of ceramic fiber embers is provided for use on the burner PAN. CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pi[...]

8.OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIO NS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE , PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot, which must be lit by hand by following thes e instructions exactly. B) BEFORE LIGHTING smell a[...]

9. ROUTINE MAINTENANCE and SERVICE Periodically check to ensure that your sy stem is clean. Periodically check the pilot and burner. Check to see that all the burner ports are clean and clear. Check the pilot head for blockage. Check to ensure the pilot flame is blue with y ellow tips. NOTE: Wipe the gold louvers with a soft cloth before firing uni[...]

10.FUEL CONVERSION “Warning” This conversion kit shall be installed by a qualified service technician in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not follow ed exactly, a fire, explosion or CO poisoning may result[...]

11. TROUBLE SHOOTING Problem Possible Cause Solution Spark will not arc to the pilot after repeated pressing of spark ignitor Defective piezo ignitor Check connections to ignitor -If ignitor connections are good but there is no spark-replace ignitor Broken spark electrode -Check for broken ceramic insulation replace, electrode if broken Miss-aligne[...]

15 12. PARTS AND ACCESSORIES Service Parts av ailable from your local Envirogas Dealer. PART # DESCRIPTION EG25-001 Convection Blower EG25-002 Heyco Strain Relief EG25-003 Fan Controller with Knob EG25-004 Hi-Temperature Electrical Cord EG25-008 Burner Switch EG25-014 120°F Ceramic Auto Reset n/o Temp Sensor (big foot) EG25-015 300°F Temp Sensor [...]

PAINTED DOOR EG25-092 BLACK IRON NIPPLE EG25-062 LOUVER SET (TOP & BOTTOM) EG25-115 FULLY ASSEMBLED PILOT EC-015 NG EC-016 LP THERMOPILE EC-012 THERMOCOUPLE EC-009 SPARK ELECTRODE EC-011 ACCENT 25 DOOR COVER GOLD- 50-009 NICKEL 50-010 PAN BURNER POST APR 2000 120 ° F (49 ° C) FAN TEMPERATURE SENSOR EC-001 BRICK CLIPS AND BACK LEDGE VALVE MOUN[...]

17 FPI WIRING HARNESS PART (A) EC-034 (NOT SHOWN) FAN CONTROLLER EC-039 ACCENT 25 REGULAR SURROUND WITH TRIM PAINTED TRIM 50-107 BRASS TRIM 50-011 NICKEL TRIM 50 - 012 BRASS TRIM CORNER BRACKETS EC053 ACCENT 25 EXPLODED VIEW SURROUND PANELS PAGE 1of 2 JUNE 2002 ON / OFF / THERMOSTAT SWITCH BURNER SWITCH EC-026 (NOT SHOWN) ACCENT 25 OVERSIZE SURROUN[...]

13. WARRANTY Sherwood Industries Ltd. offers a *Lifet ime Warranty on this gas product. The lifet ime warranty covers the appliance for a period of seven years from the date of installation. This w arranty applies only to the original owner in the original location Covered under the lifetime wa rranty are Cabinet Sides, Tops, Pedestals, Surround Pa[...]

14. INSTALLATION DATA SHEET The following information must be recorded by the inst aller for w arranty purposes and future reference. Envirogas Model: ACCENT 25 BV Name of Dealer: ___________________________________________ Address: ___________________________________________ ___________________________________________ _____________________________[...]