Emotiva ERC-2 инструкция обслуживания

[...]

[...]

3" " TABLE OF CONTENTS Thank You for your ERC -2 Purchase 5 Limited Warran ty 6 Service Assistance For t he ERC-2 6 Emotiva Disclosure 7 FCC Compliance 7 Safety Precautions 8 A Note for the Cable Television (CATV) Installer 9 Unpacking the ERC -2 9 Inventory 9 TECHNICA L SPECIFICA TIONS 10 Key Features of Your New ERC -2 Audiophil e CD Pl[...]

4" " TROUBLESHOOTING 20 The disc does not rotate 20 The disc is playing but there is no sound 20 The disc stops, noise is heard or the sound drops out 20 A CD- R / CD-RW disc cannot be played 20 The remote control does not operate 20 A specific CD cannot be played 20 Digital signal ha s no output 20 IMPORTAN T USER INFORMATION 21[...]

5" " THANK YOU FOR Y OUR ERC -2 PURCHASE Dear Music Enthusiast, Thank you for purchasing the Emotiva ERC-2 CD Player. We sincerely believe that it offers you outstanding performance and value. Emotiva products are engineered and produced with the highest quality materials and incorporate the latest technology. We think you will find the E[...]

6" " LIMITED WARRANTY The Emotiva ERC-2 CD Player has been created to perform flawlessly for many years. As a result of this quality and craftsmanship, Emotiva offers the following warranty to owners of the ERC-2. Emotiva Audio warrants the ERC-2 to be free from defects in materials and workmanship for a period of five years from the orig[...]

7" " E motiva Di sclosur e Copyright 2011 Emotiva All Rights Reserved. Emotiva reserves the right to make improvements to its products at any time. Therefore, the specifications of the product and the specific details of this manual are subject to change at any time. Emotiva and the Emotiva "E" are registered trademarks of Emoti[...]

8" " S AFETY PRECAU TIONS Read this User's Guide thoroughly before attempting to install and configure the ERC-2 CD Player. All the safety and operation instructions should be read before any operation of the component(s) begin. After successful installation and configuration of the ERC-2 CD Player, be sure to retain this manual in a[...]

9" " A Note for the Cable Television (CATV) Installer This reminder is to call the CATV system installer's attention to Article 82040 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable ent[...]

10 " " TECHNICAL SPECIFICATIONS • Nominal output voltage: 2V rms • Channel separation: ≥ 95dB - ref. 1kHz • Frequency response: 20Hz~20kHz (+/- 0.1dB ) • S/N : ≥ 100dB (A weighted ） • THD: ≤ 0.01 ％ 0dB 1KHz ） • Playback formats: Redbook CD , HDCD , MP3 • Digital Output Filter: 24 -Bit, 384 times oversampling (Ana[...]

11 " " ADDITIONAL FEATURES Four (4) independent power supplies drive each section of the unit independently . This prevents interactions and noise. The separate power supplies drive: 1. CD mechanism 2. D igital electronics 3. A nalog electronics 4. VFD Display The CD drive mechanism and the digital electronics are encased in a steel subst[...]

12 " " DISC HANDLI NG Use only discs with regular shapes. If an irregular disc (a disc with a special shape) is used the ERC-2 may be damaged. Discs usable with the ERC-2 CD Audio (CD-DA), CD- R, CD - RW , HDCD Holding discs Avoid touching the surface of a disc where recording is performed. Loading discs Hold the CD by the edges loosely a[...]

13 " " FRONT PANEL LAYOUT 1. PLAY/PAUSE This is used to play and pause the disc. 2. PREVIOUS This is used to jump to the start of the current track or to jump to the start of the previous track. 3. NEXT This is used to advance to the start of the next track. 4. STOP This is used to stop the disc. 5. DISPLAY This contains all information a[...]

14 " " REAR PANEL LAYOU T 1. BALANCED OUTPUTS (1 set ) These are used to connect the ERC-2 to an input device (pre/pro, receiver) with balanced (XLR) type cables. 2. ANALOG OUTPUTS (2 sets) These are used to connect the ERC-2 to an input device , ( DAC, pre/pro, receiver) with RCA type cables. 3. TRIGGER INPUT When connected to a pre/pro [...]

15 " " REMOTE CONTROL 1. EJECT Ejects the disc from the unit. 2. DIM This is used to dim the display light. It also turns off the halo light and the lights for all the front panel buttons except the On/Standby button. 3. STANDBY Switches the unit between On and Standby mode. 4. PLAY/PAUSE This is used to P lay and Pause the disc. 5. PREV [...]

16 " " 11 . A -B This allows you to loop a certain section of a track, a full track, multiple tracks etc. Press once to start the loop, press again where you want the loop to end. The player will now play the section between the two l oop points. Press the A-B button again and the ERC-2 returns to normal play. 12. DISPLAY Pressing the dis[...]

17 " " CHANGING THE REMOTE CONTROL BATTERI ES Emotiva recommends using high quality AAA batteries in the ERC-2 remote control. To change the remote control batteries you will need a flat tipped Phillips #2 screwdriver! DO NOT attempt to use a different size bit or damage will occur! Remove the six (6) Philips head screws on the back of th[...]

18 " " OPERATING I NSTRUCTIONS LOADING & EJECTING DISCS 1. Press the Standby/On button, make sure unit is on. 2. The display will read EMOTIVA for a few seconds at power up. LOADING will then appear on the screen. The player will then say READY . Insert disc into the slot-loader gently. Do not push hard. Allow the slot-loader to take [...]

19 " " LOCATING A PARTICULAR POINT IN A TRACK 1. Make sure that the disc is playing the desired track. 2. Press the Left REV Button on the remote control, the CD will then rewind within the track. Press again and the disc will rewind faster. Press a third time and the disc rewinds faster. Press a fourth time and the disc will resume norma[...]

20 " " TROUBLESHOOTING • The disc does not rotate 1. Is the power cable plugged in? 2. Is the power switch on? 3. Is the disc placed upside down? 4. Is the disc dirty? 5. Is the disc scratched? 6. Is the disc warped? • The disc is playing but there is no sound 1. Are the receiver or pre/pro and amplifier and speakers connected correct[...]

21 " " IMPOR TAN T USER INFORMATION C AUTION – The use of controls or adjustments or performance of procedures other than those specified herein ma y result in hazardous radiation exposure. CAUTION – No user serviceable parts inside unit. The unit is not to be open or modified by the customer. Exposure to harmful laser radiation may r[...]

22 " " Revised 0 5 /6/20 11 All contents © 2011 Emoti va Audio Corporat ion.[...]

23 " "[...]