Electrolux Over The Range Microwave Oven инструкция обслуживания

Inst allation Instructions Over the Range Microwave Oven BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector ’s use. • IMPORTANT – Observe all governing codes and ordinances. • Note to Inst aller – Be sure to leave these instructions with the Consumer . • Note [...]

Inst allation Instructions 2 CONTENTS General information Important Safety Instructions .....................3 Electrical Requirements ..............................3 Hood Exhaust ...........................................4, 5 Damage – Shipment/Installation .................6 Parts Included ...............................................6 Tools [...]

Inst allation Instructions 3 IMPORT ANT SAFETY INSTRUCTIONS This product requires a three -prong grounded outlet. The installer must perform a ground continuity check on the power outlet box before beginning the installation to insure that the outlet box is properly grounded. If not properly grounded, or if the outlet box does not meet electrical r[...]

Inst allation Instructions 4 HOOD EXHAUST NOTE: Read these next two pages only if you plan to vent your exhaust to the outside. If you plan to recirculate the air back into the room, proceed to page 11. OUTSIDE T OP EXHAUST (EXAMPLE ONL Y) The following chart describes an example of one possible ductwork installation. * IMPORT ANT : If a rectangula[...]

Inst allation Instructions 5 NOTE: If you need to install ducts, note that the total duct length of 3¼" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet. Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully. NOTE: It is important that venting be installed using the most dire[...]

Inst allation Instructions 6 DAMAGE – SHIPMENT/ INST ALLA TION • If the unit is damaged in shipment, return the unit to the store in which it was bought for rep air or replacement. • If the unit is damaged by the customer , repair or replacement is the responsibility of the customer . • If the unit is damaged by the inst aller (if other tha[...]

Inst allation Instructions 7 T OOLS YOU WILL NEED # 1 and #2 Phillips screwdriver Level Safety goggles Stud finder or Hammer (optional) Saw (saber, hole or keyhole) Gloves Scissors (to cut template, if necessary) Pencil Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only) Duct an[...]

Inst allation Instructions 8 A. REMOVING THE MICROW A VE OVEN FROM THE CART ON/ REMOVING THE MOUNTING PLA TE 1. Remove the installation instructions, Exhaust adaptor , filters, glass tray and the small hardware bag. Do not remove the S tyrofoam protecting the front of the oven. 2. Fold back all 4 carton flaps fully against carton sides. Then carefu[...]

Inst allation Instructions 9 C. DETERMINING W ALL PLA TE LOCA TION UNDER YOUR CABINET Your cabinets may have decorative trim that interferes with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. THE MICROWAVE MUST BE LEVEL. Use a level to make sure the cabinet bottom is level. If the cab[...]

Inst allation Instructions 10 D. ALIGNING THE W ALL PLA TE 1. Draw a V ertical line on the wa ll at the center of the 30" wide space . 2. Draw a Horizontal line on the wall at the bottom of “Rear Wall Template”. 3. Drill 5/8" holes for toggle bolt s on 3 locations (Hole A, Hole B, Hole C) but if the location of hole is same as that of[...]

Inst allation Instructions 11 2. INST ALLA TION TYPES (Choose A, B or C) This microwave oven is designed for adaptation to the following three types o f ventilation: A. Recirculating (Non-V ented Ductless) B. Outside T op Exhaust (V ertical Duct) C. Outside Back Exhaust (Horizont al Duct) NOTE: This microwave is shipped after being assembled for ?[...]

Inst allation Instructions 12 A. RECIRCULA TING (Non-Vented Ductless) A1. A TT ACH THE MOUNTING PLA TE T O THE W ALL Attach the plate to the wa ll using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into the mounting plate through the holes desig[...]

Inst allation Instructions 13 A3. MOUNT THE MICROW A VE OVEN FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We rec[...]

Inst allation Instructions 14 B. OUTSIDE T OP EXHAUST (Vertical Duct) B1. A TT ACH THE MOUNTING PLA TE T O THE W ALL Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolt s into the mounting plate through t he holes desi[...]

Inst allation Instructions 15 B2. USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF T OP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large eno ugh for the exhaust adaptor. • Read the instructions on the TOP CABINET TEMPLA TE. • T ape it underneath the t op cabinet.[...]

Inst allation Instructions 16 AFTER: Fan Blade Openings Facing Upward 5. Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6. Secure blower unit to microwave with the screw . B4. INST ALLA TION PROCEDURE FOR EXHAUST ADAPTOR AND PROPER DAMPER OPERA TION CHECK 2. [...]

Inst allation Instructions 17 B5. MOUNT THE MICROW A VE OVEN (cont.) 4. Attach the microwave oven to the top cabinet. 7. T ighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) 8. Install grease filters. See the Owner’s Manual packed with the[...]

Inst allation Instructions 18 C. OUTSIDE BACK EXHAUST (Horizontal Duct) C1. PREP ARING THE REAR W ALL FOR OUTSIDE BACK EXHAUST You need to cut an opening in the rear wall for outside exhaust. • Read the instructions on the REAR W ALL TEMPLA TE. • T ape it to the rear wall. • Cut the opening, following the instructions of the REAR W ALL TEMPLA[...]

Inst allation Instructions 19 Knockouts Parts”A” C2. A TT ACH THE MOUNTING PLA TE T O THE W ALL (cont.) T o use toggle bolt s: 3. Place the mounting plate against the wall a nd insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening togg le bolts and wood screw, make sure to coincide bottom line of the Mou[...]

Inst allation Instructions 20 6. Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: The blower unit exh aust openings should match exhaust openings on rear of microwave oven. 7. Secure the blower unit to the microwave with the screw . 8. Attach the exhaust [...]

Inst allation Instructions 21 C5. MOUNT THE MICROW A VE OVEN (cont.) Install grease filters. See the Owner’s Manual packed with the microwave. 4. Attach the microwave oven to the top cabinet. 7. T ighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top c[...]

Inst allation Instructions 22 BEFORE YOU USE YOUR MICROW A VE 1. Make sure the microwave oven has been installed according to instructions. 2. Remove all packing mater ial from the microwave oven. 3. Install turnt able and ring in cavity . 4. Replace house fuse or turn breaker back on. 5. Plug power cord into a dedicat ed 20 amp electrical outlet. [...]